Unique Home Designs SPD0640072P002 Operating instructions

Unique Home Designs
Brand
Unique Home Designs
Model
SPD0640072P002
Type
Operating instructions
Entry Door Jamb
Entry Door
Stucco 1 (Top View)
Stucco
Pop-Out
1" minimum
mounting
surface
1" minimum
mounting
surface
StudStud
Min. 2" Min. 2"
Determine Mounting Method and Rough Opening Measuring Points
1
The security door will require a minimum mounting surface of 1" on the trim above and on both sides of the sliding patio
door. Mounting screws must be secured to a stud in the wall. Review Figures 1-5 to determine which mounting method
you can and wish to use and the rough opening measurement.
Door is mounted with projection brackets that project 3" from mounting surface.
Entry Door Jamb
Brick molding trim
Entry Door
Brick Molding (Top View)
StudStud
1" minimum
mounting
surface
1" minimum
mounting
surface
Figure 1 Brick Molding - Surface Mount
Rough Opening
Width
Rough Opening
Width
Figure 2
Stucco 1
– Mounted between stucco pop-outs
-
Surface Mount
Entry Door Jamb
Entry Door
Stucco 2 (Top View)
Stucco
Pop-Out
1" minimum
mounting
surface
1" minimum
mounting
surface
StudStud
Figure 3
Stucco 2 – Mounted to front surface of stucco pop-outs -
Surface Mount
Rough Opening
Width
Entry Door Jamb
1" minimum
mounting
surface
1" minimum
mounting
surface
Entry Door
Flat Trim (Top View)
Flat Trim
StudStud
Figure 4 Flat Trim - Surface Mount
Rough Opening
Width
Entry Door Jamb
Entry Door
Sloped Trim (Top View)
*Sloped trim must be replaced with at trim
to properly mount your new security door
Once trim is replaced, refer to
Figure 4 for measurement locations
Sloped Trim*
Stud
Stud
Figure 5 Sloped Trim
Figure 4 or 4a for measurement points
Page 1
MK1290 12/09/2014
LEFT ACTIVE
Door on the left will be used
Determine Door Swing
2
Left or Right?
Determine active door as
viewed from outside
(see illustrations)
Note: all doors are reversible
RIGHT ACTIVE
Door on the right will be used
MEASURING GUIDE
STEEL SECURITY DOOR
VIEW INSTALLATION VIDEOS
MEASURING GUIDE
STEEL SECURITY DOOR
Page 2
Measure & Record Rough Opening
5
Height
Measure the height, right, left and center from the bottom
edge of the mounting surface to the existing threshold of
your entry door.
Use the SMALLEST of the 3 measurements if they vary.
Width
Measure the top, middle and the bottom of the door
opening across the existing entry door frame from
mounting surface inside edge to mounting surface
inside edge.
Use the SMALLEST of the 3 measurements if they vary.
W1
Record door width
W2 W3
Top View
Order Width
Hinge
Handle
Side
Trim
Trim
Entry Patio Door
Height
Width
Record smallest
measurement
Once you have measured for height and width, use the following charts to determine which models and sizes will t in your
opening. If your opening height and width measurements are within the Rough Opening Fit Range listed for the size and
model in question, that Call Size will t your opening when properly installed. If you have an unusual size opening and
none of the models and standard sizes listed will t, see a Home Depot associate to review your custom size security door
options in the MyCD system.
Determine Which Doors & Sizes Will Fit
6
Model Call Size
Rough Opening
Fit Range
Frame
Size
Tab Size
(tip to tip)
Call
Size
Rough Opening Fit
Range
Frame
Size
Tab Size
(tip to tip)
Width Height
Arcada
72" 68-1/4" - 75-1/4" 73-1/4" 77-1/4" 80" 78-5/8" - 82" 80" 84"
ArcadaMAX
72" 68-1/4" - 75-1/4" 73-1/4" 77-1/4" 80" 78-5/8" - 82" 80" 84"
Su Casa
60" 56-1/4" - 63-1/4" 61-1/4" 65-1/4" 80" 78-5/8" - 82" 80" 84"
72" 68-1/4" - 75-1/4" 73-1/4" 77-1/4" 80" 78-5/8" - 82" 80" 84"
96" 92-1/4" - 99-1/4" 97-1/4" 101-1/4" 80" 78-5/8" - 82" 80" 84"
CUSTOM SIZES AVAILABLE CUSTOM SIZES AVAILABLE
* Rough opening t range can be larger than
frame size because mounting brackets
project an additional 2" on each side of the
frame. Be sure there are not obstructions
within 3" (including the frame) on either side
of the rough opening.
Record smallest
measurement
H1
Record door height
H2 H3
W1
W2
W3
H1
H2
H3
MEASURING GUIDE
Frame: 73-1/4"
Mounting Hole: 76-1/4"
Tip of "L" bracket tab: 77-1/4"
Frame: 80"
Mounting Hole: 83"
Tip of "L" bracket tab: 84"
*
2"
*
  • Page 1 1
  • Page 2 2

Unique Home Designs SPD0640072P002 Operating instructions

Unique Home Designs
Brand
Unique Home Designs
Model
SPD0640072P002
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents