Hama 00056683 Owner's manual

Type
Owner's manual

Hama 00056683

The Hama 00056683 is a DiSEqC switch that allows you to connect multiple satellite receivers to a single satellite dish. This can be useful if you have multiple TVs in your home that you want to be able to watch satellite TV on.

The switch supports DiSEqC 1.2, which is a protocol that allows satellite receivers to communicate with each other and the switch. This allows you to control which satellite receiver is connected to the dish at any given time.

The switch has four inputs and one output. The inputs are for connecting your satellite receivers, and the output is for connecting to your satellite dish. The switch also has a built-in 22 kHz blocker, which can be used to prevent your satellite receiver from switching to the high band on your satellite dish.

Hama 00056683

The Hama 00056683 is a DiSEqC switch that allows you to connect multiple satellite receivers to a single satellite dish. This can be useful if you have multiple TVs in your home that you want to be able to watch satellite TV on.

The switch supports DiSEqC 1.2, which is a protocol that allows satellite receivers to communicate with each other and the switch. This allows you to control which satellite receiver is connected to the dish at any given time.

The switch has four inputs and one output. The inputs are for connecting your satellite receivers, and the output is for connecting to your satellite dish. The switch also has a built-in 22 kHz blocker, which can be used to prevent your satellite receiver from switching to the high band on your satellite dish.

  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Hama 00056683 Owner's manual

Type
Owner's manual

Hama 00056683

The Hama 00056683 is a DiSEqC switch that allows you to connect multiple satellite receivers to a single satellite dish. This can be useful if you have multiple TVs in your home that you want to be able to watch satellite TV on.

The switch supports DiSEqC 1.2, which is a protocol that allows satellite receivers to communicate with each other and the switch. This allows you to control which satellite receiver is connected to the dish at any given time.

The switch has four inputs and one output. The inputs are for connecting your satellite receivers, and the output is for connecting to your satellite dish. The switch also has a built-in 22 kHz blocker, which can be used to prevent your satellite receiver from switching to the high band on your satellite dish.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI