Assembly Instructions
#3 (1qty) #1 (1qty)
Parts List
1 - Top #1 2 - Handle Keepers #2
#4 (2qty) #6 (2qty)
1 - Bottom #3 2 - Long Legs #4
1 - Handle #5 2 - Short Legs #6
1 – Knob #7 16 - 1" Pan Head Screws #14
#2 (2qty)
2 - Swivel Casters #9 4 - 5/16" Carriage Bolts #10
12 - 5/16" Washers #11 4 - 5/16" Hex Nuts #12
4 - 3/4" Drywall Screws #13 2 - Fixed Casters #8
#13 (4qty)
For any missing or damaged parts, please contact:
#7 (4qty)
#8	 (4qty)
Tools Required for Assembly
Clinton Twp. MI 48036 Phillips Screwdriver
Ratchet with 1/2" socket
Assembly Instructions
Patented
PAGE 1
WorkShop Solutions, LLC.
Melissa@workshop-solutions.com
WorkShop Solutions, LLC.
44501 N. Groesbeck Hwy
1) On flat work surface, place bottom (#3) on its side. Install long legs (#4) using two carriage
bolts (#10), two flat washer (#11), and two hex nuts (#12). See Figure 1
2) Install short legs (#6) using two carriage bolts (#10), two flat washer (#11), and two hex nuts (#12).
See Figure 2
3) Place top (#12) upside down on flat work surface. Install handle (#5) using two handle keepers (#2)
and four drywall screws (#13). See Figure 3
4) Install top (#1) onto the bottom assembly using four knobs (#7), eight flat washers (#11), and four hex
nuts (#12). See figure 4
5) Place the entire assembly upside down and install two fixed casters (#8) at the end opposite of the
handle end using eight pan head screws (#14). Install two swivel casters (#9) at the handle end using
eight pan head screws (#14). See Figure 5
For complimentary products please visit www.bucketaccessories.com
PAGE 2
PAGE 3
/
