Ceiling Fan Light Kit
Installation
Instructions
Please read carefully and save there instructions, as you may need them at a later date. Ceiling fan
light kits are only meant to be used with ceiling fans.
Do not install as a light fixture
______________________
SAFETY
WARNING: RISK OF ELECTRIC SHOCK.
Disconnect the electrical supply circuit to the fan
before installing light kit
_______________________
GENERAL
All electrical connections must be in accordance with local codes, ordinances or national electrical
codes. If you are unfamiliar with methods of installing electrical wiring,
Secure the services of a qualified electrician. Before starting installation, disconnect the power by
turning off the circuit breaker or removing the fuse at fuse box. Turning power off using the fan
switch (speed control on/off) is not sufficient to prevent electrical shock.
NOTE: The important safeguards and instructions appearing in the manual are not meant to cover
all possible conditions and situations that may occur. It must be understand that common sense,
caution and care are factors which cannot be built into any product. These factors must be supplied
by the person(s) installing this unit.
CAUTION:
To reduce the risk of electrical shock, disconnect the electrical supply circuit to the fan
before installing light kit.
ASSEMBLY and INSTALLATION
Tool Required: Screwdriver
For Type A: Center Nipple Attachment (see Fig. 1/Fig 2/Fig. 3)
1. Remove the switch housing cover from the fan by unscrewing the three screws.
2. Remove the threaded plug from the center of this cover by unscrewing it. You may discard
this piece or keep it for future use.
3. Attach the cover to fitter and feed the kit wires (black and white) through the hole of the cover.
Screw on the cover and secure it to the fitter. Be sure it is tight enough to prevent light kit
from vibrating loose.
4. Locate two single wires in switch housing. White (gray on some models) and blue (red on
some models) labeled “for light”.
5. Connect wires from ceiling fan to wires from light kits using wire nuts provided.
-White (gray) to white
-Blue (red) to black
For secure connection, put electrical tape around wire nuts.
6. Carefully push all wires back into switch housing of fan. Then replace the cover with original
screws.
7. Install 60 watt max. (bulbs not provided) and glass globe or shade(s). Gently tighten three
thumb screws provided. Do not over tighten.
Some units may allow up to 100 watt max. bulb (not provided) on your single light kit.
8. Restore the power and your light kit is ready for operation
9. If light kit does not work, turn off the electricity and lower either the canopy or the decorative
housing of your ceiling fan to make sure the blue wire is connected to black supply wire.
Please refer to the electrical connections section of the ceiling fan instruction manual.
-
1
-
2
Design House 154211 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Westinghouse 7784500 Owner's manual
-
-
-
Monte Carlo MC79-L Installation guide
-
Harbor Breeze 41521 Installation guide
-
Harbor Breeze BTH44OSB5L Installation guide
-
Harbor Breeze RS54EB6LR Installation guide
-
Harbor Breeze 42071 Installation guide
-
Harbor Breeze SCH52ORB5L Installation guide
-
Harbor Breeze 40419 Installation guide
