DK Digital CDR-50 Owner's manual

Brand: DK Digital

Model: CDR-50

Category: CD players

Type: Owner's manual

DK Digital CDR-50 is a portable CD radio that allows you to enjoy your favorite music and radio programs on the go. With its compact size and lightweight design, you can conveniently carry it with you wherever you go. The device offers a variety of features and functionalities that enhance your listening experience.

The CDR-50 plays both audio CDs and CD-R(W) media burnt with a PC. It supports various playback functions, including the ability to select tracks, pause and resume playback, and stop playback. Additionally, you can repeat a single track or the entire CD with the repeat function.

For radio listening, the CDR-50 features both AM and FM reception. To enhance FM reception, the device comes with a telescope antenna that you can adjust for optimal signal strength. The built-in AM antenna ensures clear reception of AM radio stations. You can easily tune in to your desired stations using the intuitive tuning control.

Thank you very much . . .

. . . for choosing one of our portable CD radios. For your own safety and in order to learn all

about the functions available, please read this manual and keep it for future reference. And

if you once sell the unit please include the manual.

www.dk-digital.com

Important Safety Instructions, please read carefully!

•

This unit is meant to play back CDs and

to receive radio program. Using it in any

other way you risk electric shock. This

device may not be used differently from

the instructions in this manual.

•

Never attempt to open the housing of

your CD radio. All servicing or repair must

be referred to qualified service

personnel authorised by us.

•

To avoid the risk of electric shock never

use the product in humid areas or near

water - e.g. near a bathtub, washbowl,

kitchen sink, in a wet basement or near a

swimming pool, or the like.

•

This unit is intended for use with the

mains voltage of AC230V~ / 50 Hz or

battery power (6 x 1,5V, UM-2). Never try

to use it with different voltage supply.

•

Proper air circulation around the

housing must be provided to avoid

overheating.

•

If objects have fallen inside or liquid

has been spilt onto the product disconnect

the plug from the mains immediately and

consult qualified service personnel.

•

Never let children play with the unit or

stick anything into it. Otherwise they face

the risk of electric shock.

•

Do not place the unit near strong

magnetic fields, water or heat.It

should not be exposed to direct sunlight

for a longer period. Avoid positions with

heavy dust or poor ventilation. The unit

should not be exposed to mechanical

vibrations or shock.

•

This product uses invisible “Class-1-

Laser”. Never expose your eyes to this

dangerous laser beam.

•

If you switch off the device, it is not

disconnected from the mains.To

switch the unit off completely, unplug the

power cord from the wall outlet.

If you don’t use the product for a longer

period disconnect it from the mains.

•

For additional safety we recommend to

disconnect the unit from the mains during

a thunderstorm and when the unit is not

in use for a longer period.

•

If you transport the unit from cold to warm

conditions, condensation inside may

cause moisture leading to malfunctions.

If so please open the disc tray and wait

about 30 minutes, until the moisture has

evaporated.

•

After disconnection from the mains you

can use a soft damp cloth to clean the

housing. Don’t use strong cleansing

products.

The control elements

1. Speaker

2. PROGRAM - to program a sequence of CD tracks

3. REPEAT - to repeat one or all CD tracks

9 - Skip / search back

5. CD compartment lid

6. CD display

: - Skip / search forward

8. STOP - to stop CD playback

9. PLAY/PAUSE - to start / pause CD playback

10. Carrying handle

11. FM telescope antenna

12. Mains socket AC230V~ / 50 Hz

13. Battery compartment

14. TUNING - to tune in the stations

15. Function switch - to choose the requested operating mode

16. VOLUME - to set the volume

Power supply

You can operate this device with the mains voltage of AC230V~ / 50 Hz, or with battery

power.

Mains operation

Connect the mains cord to a properly wired wall outlet with a voltage of AC230V~ / 50 Hz.

Now the device is operational.

Battery operation

Open the battery compartment on the bottom side of the unit. Insert 6 x 1.5V UM-2 R14 „C”

size batteries (not supplied) into the compartment according to the insertion instructions in the

battery compartment. Observe the correct polarity of the batteries, as otherwise the device may

suffer damage. Due to their longer service life, we recommend you to use alkaline batteries.

Close the compartment again. Now the device is operational.

Batteries must not be thrown in the household waste. Please take used batteries

to the respective collecting points or take them there where you have bought the

new ones. Do not throw batteries into the fire.

General operation

Move the function switch to choose the desired function.

"AM” for AM radio reception, or

"FM” for FM radio reception, or

"CD” for CD playback.

To switch the unit off, move the function switch to the "OFF” position.

With the VOLUME controller at the right side of the unit you can set the volume as

requested. Turn the controller towards the rear to increase the volume. Turn it towards the

front to lower the volume.

CD operation

This device plays generally audio CDs as well as CD-R(W) media burnt with a PC. Due to the

various types of blank CDs, PC types, operating systems, burning software and methods,

we cannot guarantee that every burnt CD will be played immaculately. The device does not

play CD-ROMs or DVD media.

How to handle CDs

Only touch CDs at the edges to avoid finger prints and dirt.

Clean dirty CDs carefully with a soft non-fluff cloth by wiping from

the middle to the outside. Avoid circulating movements! Do not

use any solvents as this may damage the CD.

Do not use any inscriptions and labels on your CDs. This could

damage the CD or lead to unbalance which might impair playback and

the device.

CD playback

Move the function switch to the CD position.

Open the CD compartment by carefully lifting the CD compartment lid. Insert a CD with

the label side up onto the spindle of the CD plate.

Close the CD compartment by carefully pushing down the cover of the CD compartment.

The device is then reading the CD. Now the display shows the total number of tracks on

the CD.

To start playback, press the PLAY/PAUSE button. The CD display shows the respectively

played track number and the playback symbol

4. Press this button again to pause

playback. Pressing the PLAY/PAUSE button again continues the playback process.

Press the STOP button to stop playback. Now the display shows the total number of

tracks on the CD.

Please always press the STOP button first before opening the CD compartment.

Select tracks

During playback you can briefly press the

9 or : button to select the previous or subsequent

track. Keep the button pressed to activate the search function (high-speed playback). When

the desired location is reached, release the button to resume normal playback.

Repeat function

If you press the REPEAT button once during playback, “REPEAT 1” will be indicated in the

display, and the track currently being played will be repeated. If you press this button twice,

the whole CD will be repeated and “REPEAT ALL” is displayed. The track(s) will be repeated

over and over, until you leave the repeat mode by pressing the REPEAT button again or if

your cancel playback by pressing the STOP button.

Playback in programmed order

You can programme the playback of tracks in a special sequence of up to 20 tracks selected

by yourself.

To select the tracks for your individual sequence, stop playback first. Then press the

PROGRAM button. Now “PROG” is flashing in the display and invites you to select track

no. 01.

Now use the 9 or : buttons to select the first track.

Press the PROGRAM button, to store that track. Now select the next track and repeat

above steps, until all desired tracks have been stored.

Press the PLAY/PAUSE button, to start the playback of the programmed sequence.

To delete the programme press the STOP button twice, or open the CD compartment, or

switch to radio operation. Then the PROG indication in the display goes out.

Radio operation

Move the function switch to the position of the desired radio frequency range.

For FM reception you need to pull out the telescope antenna on the rear side of the unit.

Turn the antenna to find the best antenna orientation.

For AM reception the device has a built-in antenna. If AM reception is noisy or distorted,

please turn the unit to find the best orientation.

Use the TUNING control to select the broadcasting stations. The frequency scale printed

on the TUNING knob will help you to locate stations.

Support

In case of any problems or malfunctions occur while running your device, you have several

options to get help from our support-centre:

• Telephone (from Germany): 09 00/1393684 (Euro 1.89/min)

• Fax (from Germany): 0 18 05 / 00 82 38

• per E-mail: [email protected]

Or visit us on our website (www.dk-digital.com), choose your language and click on

“Support”. Then fill-up the contact form provided there.

Disposal advice

When the operating life of this device has ended it must not be disposed as

domestic waste, but in accordance with national environmental guidelines.

Technical Specifications

Power supply : mains operation: AC230V~/50 Hz

battery operation: DC12V=, 6 x 1,5V - UM-2

Reception range: FM: 87,5 - 108 MHz

AM: 522 - 1602 KHz

We reserve the right to correct errors and make technical alterations.

nor excerpts may be reproduced without our prior written permission.

DK digital GmbH

40878 Ratingen

Germany

www.dk-digital.com

DK Digital CDR-50 Owner's manual

Brand: DK Digital

Model: CDR-50

Category: CD players

Type: Owner's manual

Download PDF

report

DK Digital CDR-50 Owner's manual

DK Digital CDR-50 Owner's manual

Related papers

Other documents