ng up and Operang the A-6:
1. perfsteps 1 thrugh 6 usA e at a . Unscrew one
Aromarizer bole cap, the lack cap assst up the, set the black cap
assembly aside, and place about 2 inches of water inside the Aromarizer .
2. Add about 10 drops of aroma oils to the Aromarizer bole (more or less to taste) and screw the
black le cap assembly back on.
3. Place the Aromarizer bole on to the Aroture by pushing the bole down on the LED
light seat ( #3) on the top of the Aromarizer unit. Keep in mind that the 1” piece of vinyl tubing
aached to the “in” port of the Aromarizblack cap (#13) should be facing towards
the rear of the A-6 unit and the empty “out” port should be facing towards the
front of the A-6 unit.
4. Push the white che
ck valve into the 1” piece of vinyl tubing ( #14)
5. Connect the 24” piece of vinyl tubing to the empty (out) port on the black Aromarizer bole
cap ( #6)
6. Place aroma labels on the front and back of the Aromarizer bo
7. Repeat steps 1 through 6 for the other 5 Aromarizer boles.
8. Plug in the electric power adaptor into the rear of the A-6 unit ( #10)
9. If you purchased a complete oxygen bar package from Airheads which includes the AOCS-10
oxygen concentrator, connect your A-6 to your AOCS-10. Take the 6 foot length of clear vinyl
tubing (included in your AOCS-10 oxygen concentrator) and plug the l end of the tubing onto
the connecon port on the A-6 unit ( #17) and plug the large end of the tubing onto the
“O2 output” port on the front of your AOCS-
10.
Before you turn on your AOCS-10, be sure that you have unobstructed ow. If your A-6
e all “o”, your AOCS-10 will build up pressure, stop working, and you will void our
warranty! NEVER RUN AN OXYGEN CONCENTRATOR CONNECTED TO THE A-6 UNLESS
YOU HAVE AT LEAST ONE AROMARIZER BOTTLE CONTROL VALVE ON AND BUBBLING!
10. Your A-6 has arrived with all 6 of the aiw control valves ( #11) in the “on” poIdeally,
users should receive at least 2.5 liters each. With that said, your AOCS-10 is set to produce
10 liters per minute which will allow you to service up to 4 people at a om your A-6. This
means you should always have at least 2s turnel mes to give proper 2.5 LPM
oxygen bar service for up to 4 people simultaneously.
11. Once your AOCS-owing O2 into the
A-6, and yoes are bubbling, you are now ready to
service your customers. Aer placing a nasal cannula (nose hose) on the user, you will take the end
of the nose hose and connect it to the 24” piece of vinyl tubing ( #6) coming from the Aromarizer
“avor” of their choice.
12. Each of the Aromarizer boles LED li can be controlled by depressing each bo
corresponding blue bun (#15) The order of colors produced are as follows:
White - Yellow - Green - Cyan - Dark Blue - Purple - Orange - Fade - Off
White - Yellow - Green - Cyan - Dark Blue - Purple - Orange - Fade - Off
13. The LED lighng of the front panel of the A-6 can also be controlled by depressing the center white
buon ( #8). The order of colors produced are as follows: