When the dust full indicator turns to red, it is time to
replace dust bag, to do that please follw the instructions
as below.
When the dust full indicator turns to red, it is time to
replace dust bag, to do that please follw the instructions
as below.
Open the cover.Open the cover.
Remove the dustbag holder .Remove the dustbag holder .
Remove the full dustbag.Remove the full dustbag.
Insert the new dustbag into the dustbag holder.Insert the new dustbag into the dustbag holder.
Insert the dustbag holder into the lowerhousing.Insert the dustbag holder into the lowerhousing.
Close the lid ('ticktack')Close the lid ('ticktack')
If you use the cotton dustbag instead of the paperIf you use the cotton dustbag instead of the paper
dustbag, the bag can be used and emptied repeatedly. dustbag, the bag can be used and emptied repeatedly.
For removing and inserting the cotton dustbag, simply For removing and inserting the cotton dustbag, simply
follow the instructions for replacing paper dustbag. follow the instructions for replacing paper dustbag.
1200-1400W (Norminal at Maximum Power Setting)
1600W (Maximum at Maximum Power Setting)
1200-1400W (Norminal at Maximum Power Setting)
1600W (Maximum at Maximum Power Setting)
LVC1600BMELVC1600BME
1
2
3
4
5
6
7
8
9
10
11
12
1. HANDLE1. HANDLE
2. ON/OFF SWITCH PANEL2. ON/OFF SWITCH PANEL
3. Retractable Power
Cord/ Plug
3. Retractable Power
Cord/ Plug
4. Power Adjustment Slide 4. Power Adjustment Slide
Switch (MIN-MAX) Switch (MIN-MAX)
5. CORD REWINDING
PANEL
5. CORD REWINDING
PANEL
6. FRONT COVER6. FRONT COVER
7. LOWER BODY7. LOWER BODY
8. COMBINATION
NOZZLE
8. COMBINATION
NOZZLE
9. TUBES9. TUBES
10. HOSE10. HOSE
11. FLOOR BRUSH11. FLOOR BRUSH
12. REAR WHEEL12. REAR WHEEL
How to use the applianceHow to use the appliance
To connect the suction hose: To connect the suction hose:
-Insert the suction hose into the opening,and rotate the hose -Insert the suction hose into the opening,and rotate the hose
in clockwise direction in order to lock it in position. in clockwise direction in order to lock it in position.
To disconnect the suction hose. To disconnect the suction hose.
To connect the tube to the handgripTo connect the tube to the handgrip
To switch the appliance onTo switch the appliance on
To carry the appliance: lift it by the handleTo carry the appliance: lift it by the handle
To adjust the suction powerTo adjust the suction power
To adjust the combi nozzle to the type of floor toTo adjust the combi nozzle to the type of floor to
be cleaned: (for carpets) or (for hard floor) be cleaned: (for carpets) or (for hard floor)
- Rotate the hose in anti- clockwise direction to unlock the
connection, and slowly pull out the suction hose from the
opening.
- Rotate the hose in anti- clockwise direction to unlock the
connection, and slowly pull out the suction hose from the
opening.
level by adjusting the Slide Switch level by adjusting the Slide Switch
Note: Note:
2-pin Power Adaptor for EU Market2-pin Power Adaptor for EU Market
3-pin Power Adaptor for UK Market3-pin Power Adaptor for UK Market
once to turn on and press it again to turn off. once to turn on and press it again to turn off.
Dust Bag
Holder's edge
Dust Bag
Holder's edge
MIN (Minimum Power Setting)
MAX (Maximum Power Setting)
MIN (Minimum Power Setting)
MAX (Maximum Power Setting)
After using, you can put hook of the tube on the vacuum
cleaner unit
After using, you can put hook of the tube on the vacuum
cleaner unit
-
1
-
2
