A Division of Stevens Lee Company
1600 Xenium Lane North, Minneapolis, MN 55441-3787
Phone (763) 553-1881
Technical Manual
and
Replacement Parts List
Refrigerated Display Cabinets
Specifications Subject to Change Without Notice.
MODEL SKCTDPT 1
1
TECHNICAL MANUAL
COUNTERTOP DISPLAY REFRIGERATOR
MODELS SKCTD1, SKCTDST1 AND SKCTDPT1
Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the
most reliable equipment in the industry today. Please read this manual and the accompanying warranty
information before operating your new Silver King unit. Be sure to complete and mail the warranty card
within 10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible freight damage following
the instructions printed on the exterior of the container. Report any damages to the carrier responsible for
transportation and promptly present a claim for any evidence of mishandling. Save all packaging materials
if a claim is filed.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing
and shipping. This covering can be readily stripped before installation. After removing this covering, wash
the interior and exterior surfaces using a warm, mild soapy water solution and a sponge or cloth, rinse with
clean water and wipe dry.
Legs
The display refrigerator comes with four legs. To install them, tip the unit and thread them into the four
threaded holes in the bottom of the cabinet.
Shelves
Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. The Shelf Supports with
the tang go on the rear Pilasters. This shelf system allows for easy adjustment to suit your needs.
Location
When locating your new refrigerator, convenience and accessibility are important considerations, but the
following installation guidelines must be followed;
*Always avoid placing the refrigerator adjacent to an oven, heating element or hot air source that
would affect the operation of the unit.
*For proper ventilation the unit requires the following minimum clearances:
- 1 inch on the sides and back.
- open above the cabinet and in front of the doors.
- 4 inch legs are to be attached to the unit.
*The unit must be level or tilted backwards slightly.
*When placing the unit on a counter or shelf the structure must be able to support a
minimum of 260 pounds.
2
Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting
the unit to power. The specifications on the data plate supersede any future discussion.
The standard display case is equipped with an eight (8) foot power cord that requires a 115 Volt, 60 Cycle,
1 Phase properly grounded electrical receptacle. The power cord comes with a 3 prong plug for ground-
ing purposes. Any attempt to cut off the grounding spike or to connect to an ungrounded adapter plug will
void the warranty, terminate the manufacturers responsibility and could result in serious injury.
The circuit must be protected with a 15 or 20 ampere fuse or breaker. The unit must be isolated on a circuit
and not plugged into an extension cord.
OPERATION
Initial start up
After satisfying the installation requirements, the refrigerator is ready to start. The refrigerator will start
when the power cord is connected to the required power source. If the compressor does not start when the
unit is initially plugged in, check to make sure that the Temperature Control is not in the off position. Allow
the unit to run for two hours before loading it with product. When loading the unit with product, take care not
to block the air flow in the storage area as this would affect the units performance.
Temperature Control
The Temperature Control is located on the top of the cabinet liner and is factory set to maintain an average
cabinet temperature of approximately 35 to 40 Deg F. To obtain colder temperatures turn the Temperature
Control knob clockwise and vice versa. Allow the unit a minimum of one hour to fully respond to a control
setting adjustment.
Defrost
Your Silver King refrigerator is an automatic defrost unit and no additional plumbing is required. Automatic
defrosting is accomplished when frost buildup on the evaporator coil is cleared during compressor off
cycles. Defrost water is collected in a pan located in the compressor compartment where it is evaporated
into the room air. It is important that the unit be installed level to allow proper drainage of the condensate
water.
MAINTENANCE
Preventative maintenance is minimal although these few steps are very important to continued operation
and maximizing the life of the appliance.
Cabinet Surfaces
The cabinet interior and the exterior is stainless steel. These surfaces should be cleaned periodically with
a solution of warm water and mild soap, rinsed and wiped dry with a soft cloth. A stainless steel cleaner can
also be used. Should a surface become stained or discolored, do not attempt to clean with an abrasive
cleanser or scouring pad. Use a soft cleanser and rub with the grain of the metal to avoid scratching the
surface. Do not use chlorinated cleaners. Always rinse well and dry after cleaning.
Condenser
Periodically, accumulated dust must be removed from the condenser. First, disconnect the unit from the
power supply. To clear the dust, blow compressed air into the condenser fins at the top of the cabinet. This
will need to be done regularly to maintain the compressor warranty!
90052
MODEL___________________ SERIAL NO.______________________ DATE INSTALLED____________________
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
PARTS LIST - MODEL SKCTD1
ITEM NO. DESCRIPTION PART NO.
1 DOOR, COMPLETE - RIGHT 115/60 61722-1
DOOR, COMPLETE - RIGHT 230/50 61722-3
2 DOOR, COMPLETE - LEFT 115/60 61722
DOOR, COMPLETE - LEFT 230/50 61722-2
3 DOOR GASKET 10310-11
4 HINGE, RIGHT BOTTOM 23176
5 HINGE, LEFT BOTTOM 23175
6 DOOR BUSHING 20703
7 WASHER 20702
8 MIRROR SKCTD1 ONLY 22219
9 GLASS PANEL ASSY SKCTDST1 ONLY 42467
10 TEMPERATURE CONTROL 20889
11 KNOB, TEMPERATURE CONTROL 20651
12 PLATE, TEMPERATURE CONTROL 20653
13 EVAPORATOR 61262-1
14 HEAT EXCHANGER 62426
15 THERMOSTAT, DEFROST HEATER 23140
16 FAN MOTOR 115V 21256
FAN MOTOR 220V 21256-1
17 FAN BLADE 99196
18 FAN GUARD 41473
19 CONDENSER COIL 42498
20 FAN MOTOR 115V 22048
FAN MOTOR 230V 43193
21 FAN BLADE 8 INCH 62561
22 STARTER, LAMP 115/220V 99184
23 LAMP 20662
24 COMPRESSOR 115V/60HZ 10343-10
COMPRESSOR 220-240V/50HZ 99805
25 RELAY/OVERLOAD ASSY 115V 23493
RELAY 220V 99802
OVERLOAD 220V 99803
START CAPACITOR 220V 99804
26 GROMMET, COMPRESSOR MOUNT 20481
27 WASHER, COMPRESSOR MOUNT 22401
28 CLIP, HAIRPIN 98106
29 SHELF 42495
30 PILASTER 42986
31 SHELF SUPPORT (W/TANG) 99531
32 SHELF SUPPORT 99530
33 DEFROST HEATER 115V 63055
DEFROST HEATER 220V 63056
34 SIGN, "FRESH AND WHOLESOME" 61610
BACK PANEL - STAINLESS STEEL 41800
35 TEMPERATURE INDICATOR 22409
36 DEFROST TIMER 120/60 99291
DEFROST TIMER 220/50 99296
37 BALLAST, LIGHT 115/60 99183
BALLAST, LIGHT 220/50 99617
38 SHELL COVER ASSY 62433
39 DRIER 22677
40 GRILL, COMPRESSOR OPENING 42514
41 GRILL, CONDENSER OPENING 62402
42 POWER CORD 115V 42928
POWER CORD 220V 23514
43 LEG 22664
WHEN ORDERING REPLACEMENT PARTS, PLEASE PROVIDE MODEL AND SERIAL NUMBERS
10
11
WIRING DIAGRAM
115V 60Hz, 1 Ph AC
OR
220V 50 Hz, 1 Ph AC
FORM NO. 25976 09/00 Printed in the U.S.A.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
Silver King SKCTDPT1 User manual
- Type
- User manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- français: Silver King SKCTDPT1 Manuel utilisateur
- español: Silver King SKCTDPT1 Manual de usuario
- Deutsch: Silver King SKCTDPT1 Benutzerhandbuch
Related papers
-
Silver King SKM49R User manual
-
-
-
-
-
-
-
Silver King SKSR User manual
-
-
