Garmin 01-065-0087-0 Datasheet

Garmin
Brand
Garmin
Model
01-065-0087-0
Type
Datasheet

Garmin 01-065-0087-0 is a mount for GPS Map 276 C devices. It allows you to attach your GPS to the crossbar of your motorcycle or to an adapter. The mount is designed to protect your GPS from vibration and theft, but it is not a 100% guarantee. It is important to always make sure that your GPS is securely fastened in the mount.

Here are some of the features and possible use cases of the Garmin 01-065-0087-0:

  • Vibration damping: The mount is designed to absorb vibrations from your motorcycle, which can help to protect your GPS from damage.
  • Theft protection: The mount has a locking mechanism that helps to deter theft. However, it is not a 100% guarantee, so it is important to never leave your GPS unattended in the mount.

Garmin 01-065-0087-0 is a mount for GPS Map 276 C devices. It allows you to attach your GPS to the crossbar of your motorcycle or to an adapter. The mount is designed to protect your GPS from vibration and theft, but it is not a 100% guarantee. It is important to always make sure that your GPS is securely fastened in the mount.

Here are some of the features and possible use cases of the Garmin 01-065-0087-0:

  • Vibration damping: The mount is designed to absorb vibrations from your motorcycle, which can help to protect your GPS from damage.
  • Theft protection: The mount has a locking mechanism that helps to deter theft. However, it is not a 100% guarantee, so it is important to never leave your GPS unattended in the mount.
April 2005
Diese Anleitung ist nach unserem derzeitigen Kenntnis-
stand verfasst. Rechtliche Ansprüche auf Richtigkeit
bestehen nicht. Technische Änderungen vorbehalten.
Sehen Sie auch in unserem Katalog
oder im Internet unter www.touratech.com
DIN EN ISO 9001:2000
Zertifikat 15 100 42285
Achtung: wichtige Hinweise zur Montage
Achten Sie immer darauf, dass das
Gerät fest im Halter sitzt.
Wir übernehmen keine Haftung für beschädigte oder verloren
gegangene Geräte!
Der Halter ist kein 100%iger Diebstahlschutz.
Lassen Sie Ihr Gerät nie unbeaufsichtigt. Entfernen Sie das Gerät aus
dem Halter wenn Sie Ihr Fahrzeug verlassen.
Montieren Sie den Halter mit der an der Unterseite des Halters
angebrachten Rohrschelle an der Mittelstrebe Ihres Lenkers
oder an dem entsprechendem Adapter.
Wenn der Verschluss ganz geöffnet ist, das Gerät von vorne aufrecht in
den Halter einschieben, so das die Antenne im Antennenhalter liegt und die
auf der Geräterückseite hervorstehende kante in der Nut im Halter liegt.
Öffnungshebel loslassen und den Hebel hinten herunter drücken, bis er
spürbar einrastet (2).
Halter abschließen.
Jetzt Stromkabel anschließen .
Install the mount with the two clamps on the underside of the mount onto
the crossbar of your motorcycle. Handlebars without crossbar can use
mount adapters such as RAM 065-0040.
To insert the GPS into the mount, press down on the front while lifting up on
the rear of the release tab (1)
Insert the GPS into the mount while aligning the antenna into the vibration
damping antenna support and the lip on the back side of the GPS in the
recess on the mount (2).
Then rotate the release lever back while pressing the retaining catch
downward at the front top of the GPS. The lock can be engaged at this time
and the power cable connected.
April 2005
01-065-0087-0, 01-065-0088-0
Attention: important tips / explanations
Always make sure that the GPS sits firmly in the mount. We accept no
responsibility for damaged or lost devices!
The MvG model (065-0088) is designed for the best possible
protection from vibration but TOURATECH does not warranty that any
mounting bracket will prevent damage or theft.
Anleitung Lenkerhalterung GPS Map 276 C
Installation Instructions GPS Mount 276 C
This guidance is written after our present level of
knowledge. Legal requirements on correctness do not
exist. Technical subject to change.
1
2
3
,01-065-0138-0
  • Page 1 1

Garmin 01-065-0087-0 Datasheet

Garmin
Brand
Garmin
Model
01-065-0087-0
Type
Datasheet

Garmin 01-065-0087-0 is a mount for GPS Map 276 C devices. It allows you to attach your GPS to the crossbar of your motorcycle or to an adapter. The mount is designed to protect your GPS from vibration and theft, but it is not a 100% guarantee. It is important to always make sure that your GPS is securely fastened in the mount.

Here are some of the features and possible use cases of the Garmin 01-065-0087-0:

  • Vibration damping: The mount is designed to absorb vibrations from your motorcycle, which can help to protect your GPS from damage.
  • Theft protection: The mount has a locking mechanism that helps to deter theft. However, it is not a 100% guarantee, so it is important to never leave your GPS unattended in the mount.
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents