2. Fusion
  3. D-16-Z8-E-ORB

Fusion D-16-Z8-E-ORB Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Fusion D-16-Z8-E-ORB Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
EXTERIOR
INTERIOR
Install latch into door, first adjusting for appropriate backset.
Insert assembled Exterior half into door and through latch
Attach interior chassis with two screws provided – for Privacy function, place button on bottom.
Snap on Interior Rose – for Privacy, first align hole to allow Privacy button to pass through rose.
Install knob or lever with set screw provided. For Privacy – push on knob/lever and rotate slightly
to get better access to set screw away from Privacy Button
LEVER
Passage and Privacy Installation
KNOB
EXTERIOR
INTERIOR
INTERIOR INTERIOR
INTERIOR
EXTERIOR
INTERIOR
EXTERIOR
TFN-00G0012
Rev 10/12-01
    --
CARE AND MAINTENANCE
THE FOLLOWING CARE INSTRUCTIONS SHOULD
BE FOLLOWED TO ENSURE A LONG LASTING FINISH:
1. Remove locks, or do not install locks, prior to
painting you door.
2. Periodically clean with mild soap and a
soft cloth only.
Do not use abrasives or harsh chemicals,
and avoid sharp or scratching objects.
Template
1-3/4 in.
(45mm)
1-3/8 in.
(35mm)
1-9/16 in.
(40mm)
Ø 2-1/8 in.(54mm)
Fold here. Place on
door edge.
Backset
2-3/4 in.(70mm)
Backset
2-3/8 in.(60mm)
Drill 1 in.(25mm)
hole at center of
door edge.
LHR RHR
Hinges Hinges
EXTERIOR
Template
/