Resolution
To install the RHEL
version 6.1 drivers:
1.
Start the operating system installation through Lifecycle Controller.
2.
After the operating system media boots, press [
Tab
].
3.
For installation in BIOS mode: Type the command line argument [
space
] followed by the string
dd updates
. For
installation in UEFI mode: Press
a
and type the string
dd updates
.
4.
Press [
Enter
] to start the installation.
5.
During installation, a
Driver Disk
popup appears with the message -
Do you have a driver disk?
.
6.
Select
Yes
and provide the location of the driver disk.
NOTE:
In some cases, the driver disk is automatically detected. If the disk is detected, skip this step, select
No
,
and follow the on-screen instructions to complete the installation.
7.
Select the driver disk drive (OEMDRV).
8.
Select the file
driver_disk.iso
to load the drivers.
9.
A
Update Disk Source
popup appears with the message to select the location of the update source.
10.
Select the OEMDRV partition and press
OK
. The
Updates Disk
popup appears.
11.
Press
OK
and follow the on-screen instructions to complete the installation.
Versions Affected
Lifecycle Controller 2 version 1.00.00
Issue 3
Description
If FlexAddress is enabled on Chassis Management Controllers, iDRAC and Lifecycle Controller does not display the same MAC
addresses.
Resolution
To view the chassis-assigned MAC address, use the iDRAC Web interface or the CMC Web interface.
Versions Affected
All
Issue 4
Description
Windows operating system deployment may intermittently fail with the following error message:
A required CD/DVD drive device driver is missing. If you have a driver floppy disk, CD,
DVD, or USB flash drive, please insert it now.
Resolution
Reboot to Lifecycle Controller and retry until the operating system is successfully deployed.
Versions Affected
Lifecycle Controller 2 version 1.00.00