JennAir JKTPX151HL Installation guide

JennAir
Brand
JennAir
Model
JKTPX151HL
Type
Installation guide

This manual is also suitable for

INSTALLATION INSTRUCTIONS
In many instances, customers want to integrate the undercounter
compactor appearance with overall kitchen design. Use the
materials in this accessory kit to install the panel by following the
installation instructions.
Before you begin:
A qualied service technician must perform installation.
Panel Accessory contains:
1 Front Panel and Handle Assembly
6 Screws — #8 x 3/8" Low Rd. Head
Tools required:
Phillips Screwdriver
Installation Procedure
1. Remove Drawer from Compactor by pulling out and lifting
up to remove. Set the drawer on protective surface such as
cardboard, to protect the customer’s oor.
2. If your Compactor currently has a front panel and handle,
remove the assembly by removing the 6 screws holding the
front panel to drawer. Then lift the front panel and handle
assembly upward and OFF.
Figure 1
07/18
for JennAir
®
Compactor RISE™ Panel Accessory
3. Slide new front panel assembly on drawer from the top. Use
the six (6) mounting screws supplied to mount the front panel
assembly. See Figure 1.
Front panel and
Handle assembly
4. Install drawer assembly in compactor.
Instruction Sheet W11238358A
®
/™ ©2018 JennAir. All rights reserved. Used under license in Canada.
  • Page 1 1

JennAir JKTPX151HL Installation guide

JennAir
Brand
JennAir
Model
JKTPX151HL
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents