OWNER'S MANUAL
WARRANTY INFORMATION INSIDE. PLEASE READ
IMPORTANT!
PORTABLE COMPACT DISC SYSTEM
Teac PCD803 (AUST).p65 2006/8/15, ¤U¤È 12:011
WARRANTY REGISTRATION
Please read this warranty card.
Keep your purchase receipt to enable you to proceed quickly in the event of a Warranty Service.
Warranty Terms & Conditions
1. TEAC warrants to the original retail purchaser only, that this product is free from defects in material and
workmanship under normal domestic use and authorises free service during the warranty period at any TEAC
Authorised Centre only. TEAC warranty only applies to products purchased, used and serviced in Australia.
2. Subject to the terms herein, this warranty effectively covers the equipment as specified in the Warranty Periods
Table from the date of purchase.
3. All parts, except the external cabinet, are warranted as specified in Warranty Periods Table, and will be repaired or
replaced at the sole judgement of TEAC.
4. Normal customer maintenance as described in the owner’s manual is not covered by this warranty (such as cleaning
VCR heads etc.)
5. This warranty does not apply to equipment showing abuse, damage or that it may have been tampered with, altered
or repaired outside any TEAC Authorised Service Centre. If so, the warranty will be void.
*Your nearest Authorised TEAC Service Centre is listed in your Owners Manual
6. In the event that this unit or any defective parts must be returned to TEAC Service Centres, a copy of this warranty
certificate and of your purchase receipt must be enclosed to be a valid warranty. Such equipment or parts must be
sent freight prepaid to the nearest authorised TEAC Service Centre. After the repair, the unit will be available for
collection by the owner or it will be returned to the owner. The warranty does not cover freight or insurance. In all
cases of in-transit damages or loss, a claim must be filed against the carrier by the purchaser.
8. TEAC National Service Centre in home service and installation is available at competitive rates.
9. No one is authorised to assume any liability on behalf of TEAC or impose any obligation on it, in connection with
the sale of any equipment other than as stated in this warranty and outlined above.
10. In no event will TEAC be responsible or liable for indirect or consequential damages from interrupted operations or
other causes.
11. Warranty is not transferable to any subsequent purchaser if the product is sold during the warranty period,
TEAC PRODUCT
WARRANTY PERIOD
Televisions / Plasma 106 cm and
above
1 Year (In-Home Service Included)
LCD televisions 56cm and above 1 Year (In-Home Service Included)
Televisions – 51cm and above 1 Year (In-Home Service Included)
Televisions under 51 cm 1 Year (No In-Home Service)
Digital Set Top Boxes 1 Year (No In-Home Service)
VCR 1 Year (No In-Home Service)
DVD 1 Year (No In-Home Service)
DVD Recorder 1 Year (No In-Home Service)
Audio Systems 1 Year (No In-Home Service)
* Extended promotional warranty may apply to certain products (for more info please contact: [email protected])
In home service administration fee is applied after 1
st
year of warranty.
R
7. In home service will only be provided as part of this warranty if all the following conditions are met;
a) The product is a Colour Television of 51cm screen size or over.
b) The product is within the warranty period.
c) The product is located within the normal service area of the local TEAC Service Provider.
In any other situation or circumstance, where an in home service call is made, a service fee will be charged by the
Service Provider including travel fee if outside normal service area.
WARRANTY PROCEDURES
Please keep this information for your own records.
Please refer to the owner’s manual to ensure that you have followed the correct installation and operating procedures.
1. Read owner’s manual carefully
2. If you require Warranty Service, please contact the TEAC Service Centre
3. Please have your purchase receipt as your proof of purchase and the following details completed for a valid
Warranty.
Owner’s Name
Owner’s Address
Postcode
Model Name/No. Serial No.
Dealer’s Name
Dealer’s Address
Postcode
4. Please ensure that your product is packed appropriately upon return to the service centre.
If you have any other queries regarding service or warranty please contact the TEAC National Service Centre below:
www.teac.com.au
1800 656 700
R
R
WARNING
To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
IMPORTANT
Since the CD circuitry may cause interference to other radio tuners nearby, switch this unit
off when not in use or move it away from the affected radio tuner.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING
The lightning flash and
arrowhead within the
triangle is a warning sign
alerting you of
"dangerous voltage"
inside the product.
The exclamation point within
the triangle is a warning sign
alerting you of important
instructions accompanying
the product.
WARNING : TO REDUCE THE RISK
OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
WARNING : To reduce the risk of fire or electric shock, do not expose this appliance to rain or
moisture.
DANGER
This product contains a low power laser device.
LASER SAFETY
This unit employs an optical laser beam system in the CD mechanism, designed with built-in
safeguards. Do not attempt to disassemble, refer to qualified service personnel.
Exposure to this invisible laser light beam may be harmful to the human eye.
THIS IS A CLASS-1 LASER PRODUCT. USE OF CONTROLS, OR ADJUSTMENTS OR
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN, MAY RESULT IN HAZARDOUS LASER
LIGHT BEAM EXPOSURE.
The marking plate are indicated on the back side of the unit.
CLASS 1 LASER
PRODUCT
CAUTION
INVISIBLE LASER
RADIATION WHEN OPEN
AND INTERLOCKS
DEFEATED.
AVOID EXPOSURE TO
BEAM.
Teac PCD803 (AUST).p65 2006/8/15, ¤U¤È 12:014
LOCATION OF CONTROLS
1. VOLUME KNOB
2. FUNCTION SWITCH
3. TUNING KNOB
4. PLAY / PAUSE BUTTON
5. STOP BUTTON
6. PROGRAM BUTTON
7. REPEAT BUTTON
8. NEXT SKIP / SEARCH FORWARD
BUTTON
9. BACK SKIP / SEARCH BACKWARD
BUTTON
10. DIAL SCALE
11. DIAL POINTER
12. CD DOOR OPEN POSITION
13. CD DOOR
14. CD TRACK DISPLAY
15. REPEAT INDICATOR
16. PLAY / PROG. INDICATOR
17. FM STEREO INDICATOR
18. POWER INDICATOR
19. TELESCOPIC ANTENNA
20. HANDLE
21. SPEAKER
22. BAND SWITCH
23. HEADPHONE JACK
24. AC SOCKET
25. BATTERY COMPARTMENT DOOR
5
6
16
21
7
1
18
14
22
17
20
19
12
9
8
4
15
3
23
2
24
25
21
13
11
10
Teac PCD803 (AUST).p65 2006/8/15, ¤U¤È 12:015
POWER SOURCE
BATTERY POWER OPERATION
1. Open the BATTERY COMPARTMENT DOOR by pushing the catches downwards.
2. Install 6 x UM2 batteries carefully as indicated in battery compartment.
3. Close the BATTERY COMPARTMENT DOOR.
AC POWER OPERATION
Connect receptacle end of the mains lead to the AC SOCKET and the plug to an AC outlet.
OPERATION OF UNIT
RADIO OPERATION
RECEPTION OF RADIO PROGRAMME
1. Set the FUNCTION SWITCH to the RADIO position. The POWER ON indicator will light. Set the
desired radio band with the BAND SWITCH.
2. Tune in a desired station by turning the TUNING KNOB.
3. For FM reception, pull out the antenna and adjust the direction, length and angle to have the best
reception.
4. For AM reception, rotate the unit to have the best reception.
5. Adjust the VOLUME KNOB for your desired listening level.
6. To turn off the radio, set the FUNCTION SWITCH to the OFF position.
PLAYING COMPACT DISCS
- Slide the FUNCTION SWITCH to the CD position. The POWER ON indicator will light.
- Use a fingertip to open the CD DOOR. Place a CD into the compact disc compartment and close the
CD DOOR. The printed label side faces upward.
- The CD TRACK DISPLAY will show the total number of tracks after a few seconds.
- " n o " will be displayed when there is no CD inside the CD compartment.
CD-R AND CD-RW PLAYABLE
This unit can play normal audio CD, CD-R and CD-RW discs.
PLAY / PAUSE BUTTON
Press once to start playing the CD, the CD TRACK DISPLAY will show the first track and the PLAY /
PROG. INDICATOR will light. Press once again to pause playback. The TRACK NO. will be flashing. Press
once again to resume playing.
STOP BUTTON
Press once to stop playing the CD.
NEXT SKIP / SEARCH FORWARD BUTTON
Press once to skip to the next track. Press and hold to search for a desired position at high speed. Release
the button to resume normal play.
BACK SKIP / SEARCH BACKWARD BUTTON
Press once to skip back to the beginning of the current track. Press repeatedly to go to previous tracks.
Press and hold to search for a desired position at high speed. Release the button to resume normal play.
REPEAT BUTTON
- Press once for single track repeat playing and the REPEAT INDICATOR will be flashing.
- Press twice for all tracks repeat playing and the REPEAT INDICATOR will light.
- To cancel the repeat play mode, press the REPEAT BUTTON once or twice until the REPEAT
INDICATOR turns off.
To remove the CD from the unit, press the STOP BUTTON and open the CD DOOR, take out the CD.
To turn off, set the FUNCTION SWITCH to the OFF position.
Teac PCD803 (AUST).p65 2006/8/15, ¤U¤È 12:016
CD PROGRAM PLAYBACK
Programmed playback enables tracks on a disc to be played in the desired order. Up to 20 tracks can be
programmed.
1. Press the PROGRAM BUTTON once, the PROGRAM INDICATOR and " 0 1 " will be flashing in the
CD TRACK DISPLAY.
2. Press the "BACK SKIP / SEARCH BACKWARD" and / or "NEXT SKIP / SEARCH FORWARD"
BUTTONS to select the desired track number.
3. Press the PROGRAM BUTTON again to memorize the track.
4. Repeat steps 2 and 3 until all desired tracks are programmed.
5. Press the PLAY / PAUSE BUTTON to start playing. the PROGRAM INDICATOR will light.
6. Press the STOP BUTTON to stop programmed playback.
7. Press the PLAY / PAUSE BUTTON to resume programmed playback.
8. Open the CD DOOR or turn off the CD player to clear the programmed memory.
9. When in stop mode, pressing the STOP button also clears the memory.
NOTE : Programming can only be made when the CD player is in stop mode.
CARE AND MAINTENANCE
Caring for Compact Discs
* Treat the disc carefully. Handle the disc only by its edges.
Never allow your fingers to come in contact with the shiny,
unprinted side of the disc.
* Do not attach adhesive tape, stickers, etc. to the disc label.
* Clean the disc periodically with a soft, lint-free, dry cloth.
Never use detergents or abrasive cleaners to clean the
disc. If necessary, use a CD cleaning kit.
* If a disc skips of gets stuck on a section of the disc, it is
probably dirty or damaged (scratched).
* When cleaning the disc, wipe in straight lines from the
center of the disc to the outer edge of the disc.
Never wipe in circular motions.
* This unit is designed to play only Compact Discs bearing the identification logo as shown here.
Other discs may not conform to the CD standard and may not play properly.
* Compact Discs should be stored in their cases after each use to avoid damage.
* Do not expose Compact Discs to direct sunlight, high humidity, high temperatures,
or dust, etc. Prolonged exposure or extreme temperatures can warp the disc.
* Do not stick or write anything on either side of the disc. Sharp writing instruments, or the ink may
damage the surface.
NOMINAL SPECIFICATIONS
Power Sources : AC240V, 50Hz
DC9V (6xUM2 Batteries - not included)
Power Output : 0.8 Watt RMS per channel
Frequency Range : FM 88-108 MHz
AM 531-1602 kHz
Frequency Response : CD - 125 Hz - 15000 Hz
Dimensions : 230(L) x 220(W) x 145(H) MM
Weight : 1.49 kg
Weight and dimensions are approximate because we continually strive to improve our products,
specifications may change without prior notice.
Teac PCD803 (AUST).p65 2006/8/15, ¤U¤È 12:017
R
TEAC CORPORATION
3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan Phone: (0422) 52-5081
TEAC AUSTRALIA PTY., LTD.
HEAD OFFICE
Phone : (03)8336 6500
SERVICE DIVISION
MELBOURNE, VIC
30 Tullamarine Park Road, Tullamarine, VIC 3043 Phone : (03)8336 6544
SYDNEY, NSW
Phone :
BRISBANE, QLD
335 Montague Road, West End, QLD 4101.
Phone : (07)3010 0100
PERTH, WA
273 Great Eastern Highway, Belmont, WA 6104.
Phone : (08)9479 6522
E-mail
Website
http://www.teac.com.au
NATIONAL CUSTOMER SERVICE CENTRE (NCSC)
Free call: 1800 656 700
Between Monday to Friday - EST 9 AM to 5PM
(02)9774 1075Unit 41, 65 Marigold St., Revesby, NSW 2212.
Teac PCD803 (AUST).p65 2006/8/15, ¤U¤È 12:128
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- italiano: TEAC PC-D803 Manuale del proprietario