![](//vs1.manuzoid.com/store/data-gzf/33b90addc230275bee743a6264dc673b/3/000112139.htmlex.zip/bg31.jpg)
Operating the appliance en
49
The name of the drink and the currently
active values are shown on the display.
9. To change the settings for the
selected drink.
~ "Adjusting beverage settings"
on page 51 ~ "Menu settings"
on page 56
10. To begin dispensing the drink, press
the rotary selector.
The coffee is brewed and then
dispensed into the cup.
Notes
â– Any grounds residue in the grounds
shaft should be directed down the
shaft using a soft brush.
â– To prematurely stop dispensing the
drink, press the rotary selector
again.
â– For another drink with ground coffee,
repeat the procedure.
â– When ground coffee is used, the
aromaDoubleShot function is not
available.
Preparing drinks with milk
This appliance features an integrated
milk system.The milk system can be
used to prepare coffee drinks with milk,
as well as milk froth and warm milk.
You can choose between Espresso
Macchiato, Cappuccino,
Latte Macchiato, Caffe Latte, Café
cortado and Flat White.
Tip: You can also use plant-based
alternatives to milk, e.g. soya milk.
Notes
â– While milk is being prepared, you
may hear a whistling sound. These
noises are emitted for technical
reasons and are normal.
â– Dried milk residues are difficult to
remove so always perform cleaning.
~ "Cleaning the milk system"
on page 60
â– The quality of the milk froth depends
on the type of milk or the
plant-based alternative used.
:Warning
Risk of burns!
The milk system becomes very hot.
After use, always let it cool down before
you touch it.
Using the milk container
The milk container H has been
designed especially for use together
with this appliance. It is intended solely
for use in the household and for storing
milk in the refrigerator.
Important: The milk container can only
be connected if the milk system is
installed in the outlet system with an
adapter and hose. (~ Fig. #)
1. To remove the lid, press the marking
and remove the lid. (~ Fig. ')
2. Pour in the milk.
3. Press the lid onto the milk container
until it engages.
4. Connect the milk container on the
left of the appliance. The milk
container must engage.
Tip: If the milk container runs empty
during dispensing, it can be filled and
connected again. Dispensing continues
automatically.
Coffee drinks with milk
The appliance is switched on. The water
tank and bean container have been
filled.
The milk container filled with milk is
connected.
1. Place a cup or a glass under the
outlet system.
2. Use the rotary selector to select the
desired drink.
The name of the drink and the currently
active values are shown on the display.
3. To change the settings for the
selected drink.
~ "Adjusting beverage settings"
on page 51 ~ "Menu settings"
on page 56