IMPORTANT NOTE
• Handle the liquid crystal display (LCD) with care:
- The LCD is a very delicate display device: Do not press its surface with force, hit it or prick
it with a sharp object.
- If you push the LCD surface, unevenness in display may occur. If unevenness does not
disappear, turn the camcorder off, wait for a few moments, then turn it on again.
- Do not place the camcorder with the open LCD screen down.
- Close the LCD monitor when not using the camcorder
• Liquid crystal display :
- The LCD screen will be slightly dimmer than usual when the camcorder is at low
temperature, as in cold areas, or immediately after power is turned on. Normal brightness
will be restored when the temperature inside the camcorder rises. This has no effect on the
images in the storage media, so there is no cause for concern.
• Hold the DVD camcorder correctly:
- Do not hold the DVD camcorder by the LCD monitor when lifting it: the viewfinder or LCD
monitor could detach and the DVD camcorder may fall.
• Do not subject the DVD camcorder to impact:
- This DVD camcorder is a precision machine. Take great care that you do not strike it
against a hard object or let it fall.
- Do not use the DVD camcorder on a tripod in a place where it is subject to severe
vibrations or impact.
• No sand or dust!
Fine sand or dust entering the DVD camcorder or AC power adaptor could cause malfunctions or
defects.
• No water or oil!
Water or oil entering the DVD camcorder or AC power adaptor could cause electric shock,
malfunctions or defects.
• Heat on surface of product:
The surface of the DVD camcorder will be slightly warm when in use, but this does not indicate a
fault.
• Be careful of ambient temperature:
- Using the DVD camcorder in a place where the temperature is over 60°C (140°F) or under
0°C (32°F) will result in abnormal recording/playback.
- Do not leave the DVD camcorder on a beach or in a closed vehicle where the temperature
is very high for a long time: This could cause a malfunction.
• Do not point directly at the sun:
- If direct sunlight strikes the lens, the DVD camcorder could malfunction or a fire could
occur.
- Do not leave the DVD camcorder with the LCD screen exposed to direct sunlight: This
could cause a malfunction.
• Do not use the DVD camcorder near TV or radio:
- This could cause noise to appear on the TV screen or in radio broadcasts.
precautions when using
使用须知
重要注意事项
细心处理液晶显示屏 (LCD):
-
LCD 是非常精密的显示设备:切勿用力压其表面,或使用尖锐的物体击打或刺戳。
- 如果您按压 LCD 表面,可能会在显示时出现不平现象。如果不平现象不消失,请关闭摄
像机,等待片刻后再次打开。
- 切勿使打开的 LCD 屏幕向下放置摄像机。
- 在不使用摄像机时关闭 LCD 显示屏
液晶显示:
- LCD 屏幕是采用高精密技术制造的产品。 在总像素(LCD 显示屏的大约 112,000 像素)
中,0.01% 或更少的像素可能会损失(黑点),或可能以彩色(红、蓝和绿色)的点亮起。
这表明了当前技术的局限性,但不表示是影响录制的故障。
- 当摄像机在温度较低的环境(如在寒冷地区)时,LCD 屏幕会比正常时稍暗,或在打开电
源后显示正常。当摄像机内部的温度上升时,会恢复到原来的亮度。注意,上述现象对储
存媒体中的图像没有什么影响,因此无需顾虑。
正确把持 DVD 摄像机:
- 不要握住 DVD 摄像机的 LCD 显示屏来提起它:LCD 显示屏可能会拆离,从而导致 DVD 摄
像机跌落。
切勿撞击 DVD 摄像机:
- 本DVD摄像机是精密机器。 要特别小心,不要让其撞击硬物或摔落。
- 切勿在严重振动或撞击的地方将 DVD 摄像机放在三角架上使用。
要避免沙尘!
细沙或灰尘进入 DVD 摄像机或交流电源适配器会引起故障。
要避免水或油!
水或油进入 DVD 摄像机或交流电源适配器会引起触电或故障。
产品表面变热:
在使用时,DVD 摄像机表面会轻微变热,但这并不表示有故障。
注意异常的环境温度:
- 在温度高于60℃ (140°F) 或低于0℃ (32°F) 的地方使用DVD摄像机,可能会导致录制/播
放不正常。
-
切勿将 DVD 摄像机放在沙滩上或温度长时间会很热的封闭车辆中:这样可能会导致发生
故障。
切勿直接对着太阳:
- 如果阳光直射镜头,DVD摄像机可能会出现故障或发生火灾。
- 在放置 DVD 摄像机时,切勿让阳光直射 LCD 屏幕:这样可能会导致发生故障。
切勿在电视或收音机旁边使用本 DVD 摄像机:
- 这样可能会导致在电视屏幕或收音机中出现噪音。
(AD68-01309T)VP-DX10_ENG+CHN_IB.indb 6 2007-11-29 ¿ÀÈÄ 2:22:42