1 To assure the finest performance, please read
this manual car@ally Keep it in a safe place for
futurereference.
2 InstaEI this unt n a well vent bted, cool, dry dean
place away from direct sunlight, beat sources,
vibrat on, dust, moisture, or cold. In a cabinet,
allow about 2.5cm (1 inch) dfree space ale
around this unt for adequate ventilation.
3 Locate this unit away from other electrical
appliances, motors, or transformers to avoid
bumming sounds.
4 Do not expose this untt to sudden temperature
changes from cold to hot, nor locate tbs untt in
an environment with high humidity (.e., a room
wth a humid fier) to prevent condensation inside
this unit, which may cause an electr cal shock, fi_,
damage to this unit, and/or personal _jury
5 Avoid installing this unit in a location where
foreign obJeCts may fall onto this unit or where
this unt may be exposed to liqud @-ipping or
splashing, On the top of this unit, do not place:
Other components, as they may cause
damage and/or disc@orat on on the surface
of this unit,
Burning objects (i.e,, candles), as they may
cause fire, damage to this unit, and/or
personal inpry
Conta ners wttb Iquid n them, as they may
fall, spilling the liquid and causing an electrical
shock to the user and/or damage to this unit.
6 Do not cover this untt with a newspaper,
tablecloth, curtain, etc, n order not to obstruct
heat rad ation, lfthe temperature nside this untt
rises, it may cause fire, damage to this uni%and/or
personal iniur Y
7 Do not plug in this unit to a wall outlet untl all
connect ons are complete.
8 Do not operate this unit upside-down, It may
overheat, possibly causing damage.
9 Do not use excessive force on switches, knobs
and/or cords,
10 When disconnect}ng the power cord from the
wall outlet, grasp the plug; do not pull the cord.
11 Do not clean th}s un}t wttb chemical solveuts;this
might damage the fin sh, Use a clean, dry cloth,
1 2 Use only the voltage specified on this unit. Using
this un}t wtth a higher voltage than specified is
dangerous and may cause fire, damage to this
unit, and/or personal injuryYAMAHA will not be
held responsible for any damage resulting from
use of this un}t wttb a voltage other than as
specified.
13 To preve_t damage by lightning, disconnect the
power cord from the wall outlet durng an
electrical storm.
14 Do not attempt to modify or fix this unit.
Contact qualifiedYAMAHA service personnel
when any serv ce is needed.The cabinet should
never be opened for- any reason.
15 When not planning to use this unit for long
periods of t}me (i.e., vacation), d sconnect the AC
power plug from the wall outlet.
16 Be sure to read the "TROUBLESHOOTING"
section on common operat}ng errors before
concluding that this unit is faulty
| 7 Before moving this unit, press STANDBY/ON to
set the un}t }n standby mode, then disconnect
the AC power plug from the wall outlet.
WARNING
TO REDUCETHE RISKOF FIREOR ELECTRIC
SHOCK, DO NOT EXPOSETHISUNITTO
RAIN OR MOISTURE
NOTE:
Pictures shown maybe different between countries,
Never make or change connections w}th the power
switched on,
When playing DTS encoded CDs, excessive noise
will be heard from the analog stereo outputs,To
avoid possible damage to the audio system, the
consumer should take proper- precaut ons when the
analog stereo outputs of the player are connected to
an amplification system.To enjoy DTS D gttal
Surround TM playback, an external 5,1 channel DTS
Digital Surround TM decoder system must be
connected to the digital output of the player:
LASER SAFETY
This unit employs a laser: Due to possible eye injury
only a qualified serv ce person should remove the
cover or attempt to service this device,
CAUTION
VISIBLEAND INVISIBLELASERRADIATION
WHEN OPEN,AVOID EXPOSURETO BEAN
(WARNING LOCATION:INSIDE ON LASER
COVERSHIELD ORTHE BACKPLATEOF SET)
LASER
_pe
Wave lenS1]
Output Power
Beam d}vergence
Semiconductor laser GaAlAs
650 nm (DVD)
780 nm (VCD/CD)
7 mW (DVD)
10 mW (VCD/CD)
60 degree