Minka Group 2341-77 User manual

Minka Group
Brand
Minka Group
Model
2341-77
Type
User manual
INSTALLATION INSTRUCTIONS
Item#2341-77
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton and check that
all parts are included as shown in the illustration.
2. Shut off power at the circuit breaker and remove old fixture
including the mounting hardware.
3. Connect rods (H) together to get desired hanging height.
Secure rods (H) to quick link and loop (G). Attach quick link
and loop (G）to the canopy (E). Now, attach rod and canopy
to fixture body (I).
4. The crossbar (B) contains several pairs of threaded holes,
find the pair of holes that match the holes spacing in your
Junction box Attach the crossbar (B) to the Junction Box
using the two mounting screws (C size:8/32*27mm). Tighten
the screws (C) securely with screwdriver.
CONNECTING THE WIRES (Fig. 2)
5. At this point, connect the electrical wires as shown in (Fig.2),
making sure that all wire connectors are secured. If your
outlet has a ground wire (green or bare copper), connect the
fixtures Ground Wire to it. Otherwise, connect the fixture
Ground Wire directly to the circular strap using the Green
Screw provided.
6. Position the canopy (E) so that the mounting screws
protruding from mounting bracket line up with the holes in the
canopy. Secure canopy in place with provided cap nuts (F).
FINISH THE INSTALLATION (Fig. 1)
7. Install light bulb (J) (not included) in accordance with the
fixture’s specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!!) (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
8. Your installation is complete now. Return power to the junction
box and test the fixture. Note: Illustration (Fig.1) on this
manual is for installation purposes only. It may or may not
be identical to the fixture purchased.
2341-77
N
o
ch
To
in
c
th
e
st
r
us
sh
FIXTURE
WIRES
Black or
Smooth
H
O
U
S
E
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
H
O
U
S
E
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
H
O
U
S
E
WIRES
Green
(Ground)
- Set#A-010
-Crossbar
- Ground Screw
- Mounting Screw*2
- Chain# HCH2072-77
-Crystal: *14 strands
GC2341-2
GC2341-3
GC2341-1
14* 14
20* 20
GC2341-5
10

22* 63
GC2341-4

22* 22
  • Page 1 1

Minka Group 2341-77 User manual

Minka Group
Brand
Minka Group
Model
2341-77
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents