WARNING
Playing loud music in an automobile can reduce your ability
to hear traffic and permanently damage your hearing. We
do not accept any liability for hearing loss, bodily injury or
property damage resulting from the use or misuse of our
products.
IMPORTANT
Although these instructions explain how to install amplifiers
in a general sense, they do not show specific installation
methods that may be required for your particular installation.
CHOOSING A MOUNTING LOCATION
Mount the amplifier in the vehicle’s trunk or cargo area,
but never mount the amplifier in the engine compartment,
outside the vehicle or in any location where it may get wet.
When choosing a location, make sure the site’s underlying
structure is strong enough to support the amplifier’s weight.
Also, verify that there will be adequate ventilation around
the amplifier.
MOUNTING THE AMPLIFIER
We strongly recommend first mounting a piece of wood or medium density fiberboard (MDF) in the vehicle, and then mounting the amplifier on
the board. Amplifiers must be mounted using all mounting screws. Using the amplifier as a template, mark the location of the mounting holes on
the mounting surface, drill pilot holes and securely attach the amplifier to the mounting surface. Make sure the amplifier does not pinch or smash
power cables, speaker wires, input cables or any of the wiring in the vehicle.
INSTALLATION WARNINGS AND TIPS
Always wear protective eyewear when using tools.
Turn off all audio components and other electrical devices before you start. Disconnect the (–) negative lead from your vehicle’s battery.
Check clearances on both sides of the mounting surface before drilling holes or installing screws.
At the installation sites, locate and make a note of all fuel lines, hydraulic brake lines, vacuum lines and electrical wiring. Use extreme caution
when cutting or drilling in and around these areas.
Before drilling or cutting holes, remove unwanted fabric or vinyl to keep material from snagging in a drill bit.
When routing cables, keep input-signal cables away from power cables and speaker wires. Use grommets when passing cables through metal.
When making connections, observe the amplifier’s polarity markings. Make sure that each connection is clean and properly secured. Use the
shortest ground wire possible to minimize resistance and avoid noise problems.
If the amplifier’s fuse must be replaced, use only the same type and rating as that of the original. Do not substitute another kind.
CAR AUDIO INSTALLATION TIPS
© 2016 HARMAN International Industries, Incorporated. All rights reserved. JBL is a trademark of
HARMAN International Industries, Incorporated, registered in the United States and/or other
countries. Features, specifications and appearance are subject to change without notice.
HARMAN International Industries, Incorporated
8500 Balboa Boulevard, Northridge, CA 91329 USA
www.jbl.com
AMPLIFIER INSTALLATION
-
1
JBL GRAND TOURING GTR 7535 Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Infinity Reference1600a Instructions Manual
-
-
Infinity REF1600A Specification
-
Infinity 611A Instructions Manual
-
-
Infinity Reference 4555A Owner's manual
-
Infinity 60.7cs User manual
-
-
-