Security Tronix ST-IP-TEST-BAT W/HSG Owner's manual

Type
Owner's manual
THE IMAGE OF QUALITY
TRONIX
TRONIX
SECURITY
SECURITY
®
800-460-1801 | [email protected] | www.securitytronix.com
Battery
ST-IP-TEST-BAT W/HSG
Replacing the battery and back cover
on the ST-IP-TEST Test Meter
ST-IP-TEST-BAT W/HSG | 07312020
Phillips Head Screwdriver
Replacement Parts
Tools Needed
Back Cover
Step 1
On the back of the meter, open the
battery door and remove the old battery.
Step 2
Using your screwdriver, remove the screws
from the back cover of the meter. Lift the
back cover o the meter and save the
existing screws for the new back cover.
Step 3
Take the new back cover and attach
the battery cable to the HD board
on the meter.
THE IMAGE OF QUALITY
TRONIX
TRONIX
SECURITY
SECURITY
®
800-460-1801 | [email protected] | www.securitytronix.com
ST-IP-TEST-BAT W/HSG | 07312020
Step 4
Once the battery cable is attached, align
the back cover to the meter, screw the new
back on to the meter using the existing
screws from the original back cover.
Step 5
Install the new battery into the battery
area and replace the door over the
battery.
Step 6
Turn the meter over and power the meter
ON to make sure everything is installed
properly.
The replacement of the new
battery and back cover of the
ST-IP-TEST meter is complete.
THE IMAGE OF QUALITY
TRONIX
TRONIX
SECURITY
SECURITY
®
n SAME DAY SHIPPING ON ORDERS
RECEIVED BY 5PM ET
n PRE-SALES AND POST-SALES SUPPORT
n 24/7/365 US-BASED TECHNICAL
SUPPORT VIA PHONE AT 610-429-0334
  • Page 1 1
  • Page 2 2

Security Tronix ST-IP-TEST-BAT W/HSG Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI