Page is loading ...
CHARGE
The SEAL SwimSafe
™
Band and Hub must
be charged in order to monitor swimmers.
Plug in the SEAL SwimSafe
™
Charger and
fully charge the Band and Hub before an
outing or a long day of swimming. Charge
the Band and Hub until the lights stay on
and are no longer flashing to indicate a
full charge.
CHARGING TIME (0% to full charge)
Band: 1.5 hours Hub: 3 to 4 hours
BATTERY LIFE Up to 8 hours
The bands will blink RED until they have
reached the minimum usable charge.
Plug in the SEAL SwimSafe
™
4-Band Charger.
Place the SEAL SwimSafe
™
Band into the
4-Band Charger.
Rotate the swivel clamp over the Band
to hold it in place.
NOTE If the swivel clamp does not rotate
smoothly, be sure that the four metal
contact points on the face of the Band
are aligned with the pins in the Charger.
Place the SEAL SwimSafe
™
Hub into the
Charger. Indicator lights will appear.
CHOOSING A SWIM LEVEL
The SEAL SwimSafe
™
System allows you
to set each Band to four different Swim
Levels. The user’s swim ability and lung
capacity are important in determining
which Swim Level to choose.
NOTE Older adults or swimmers with
medical problems may need a lower
Swim Level to detect shorter periods
of submersion before alarming.
USER GUIDE
POWER UP
TURN ON THE SYSTEM by pressing the button on the top of the
Hub. The Hub light will flash RED, then GREEN. The Band will
flash the SWIM LEVEL COLOR (see "Swim Levels" section below),
and the Hub will begin flashing GREEN/WHITE
to indicate they are turned on and charging.
NOTE Turn on a Band at any time by rubbing
the face of the Band against the SEAL logo on
the side of the Hub until you hear the Hub chirp,
or place the Band in the Charger connected to
a power source. The Band will begin flashing
the preset SWIM LEVEL COLOR.
TURN OFF THE SYSTEM by pressing and
holding the button on top of the Hub. The
Hub light will turn RED. This will turn off
the Hub and all Bands paired with the Hub.
WHAT’S INCLUDED
CONNECT
PAIR
When the Band and Hub
lights turn GREEN, the Band
is now synced with the Hub.
Remove the Band from the Charger,
then press the button on top of the Hub.
Rub the face of the Band
against the SEAL logo on the
side of the Hub. The Band and
Hub will flash while pairing.
SEAL SwimSafe
™
alone can not protect
swimmers and can only be used in
conjunction with vigilant lifeguards or
parents/guardians and safe swimming
practices.
SEAL SwimSafe
™
technology is for
in-ground pools and lakes only and will
not protect swimmers in above-ground
pools or hot tubs.
SEAL SwimSafe
™
alarms when a
swimmer is at least 12 inches underwater
and should not be used on swimmers
that are of an age or have disabilities
where they could drown in water shallow
enough to stand up in.
SEAL SwimSafe™
Band (x1)
Adult Band
Extender (x1)
Interchangeable
Band Face Plates
(x3)
SEAL SwimSafe™
Hub (x1)
SEAL SwimSafe™
4-Band Charger (x1) Power
Supply (x1)
SWIM LEVELS
Four different submersion time limits.
NON-SWIMMER
Alarms seconds after
entering water.
BEGINNING &
RECREATIONAL
SWIMMER
Up to 20 seconds
submerged.
COMPETITION
ATHLETE
Up to 45 seconds
submersion.
GUARD LEVEL Allows the Band to act as another Hub,
alarming the wearer of any danger. Adults and lifeguards
are encouraged to wear the included Band extender and
orange faceplate with their Guard Band.
CHANGING THE SWIM LEVEL
Select the appropriate Swim Level for each Band.
Secure the Band in the
Charger while plugged in.
Press the Swim
Level button.
Lights will flash
the Swim Level
color you select.
Remove the
Band and place
on swimmer.
Swimmers should be set to level BLUE unless they can safely
and comfortably be under water for more than 20 seconds.
If your Band is flashing yellow,
it needs to be paired to the Hub.
To pair a Band with the Hub:
PRESS
CUSTOMER SUPPORT (888) 786-8721
customerser[email protected]
Visit www.SEALSwimSafe.com/userguide for
additional information and videos of product.
SET SWIM LEVELS
EARLY WARNING SYSTEM
The SEAL SwimSafe
™
System will alarm by emitting audible
sirens and flashing RED/WHITE lights, when it determines:
• A swimmer has been submerged for longer
than their Swim Level setting allows.
When this occurs, the swimmer will hear an alarm
and the Band will flash RED/WHITE. The swimmer
must immediately come to the water surface.
• A person wearing the Band travels outside
of the Hub’s range.
When the Band returns to within the Hub's range,
the Band will stop flashing RED/WHITE and return
to flashing it's Swim Level color and the Hub will
stop alarming.
The Hub will alarm if the user is unable to surface or return
to range of the Hub.
LIMITED PRODUCT WARRANTY
SEAL Innovation, Inc. ("SEAL SwimSafe™")
warrants to the original purchaser that your SEAL
SwimSafe™ electronic device (the "Product") shall
be free from defects in materials and
workmanship under normal use for a period of
one (1) year from the date of purchase, except
that if you reside in the European Economic Area
(EEA) and you purchased your SEAL SwimSafe™
product in the EEA, the warranty period is two (2)
years from the date of purchase (the "Warranty
Period"). SEAL SwimSafe™ does not warrant that
the operation of the Product will be uninterrupted
or error-free. SEAL SwimSafe™ is not responsible
for damage arising from failure to follow
instructions relating to the Product's use.
harmful interference in a residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help. This device meets the FCC
and IC requirements for RF exposure in public
or uncontrolled environments.
Model Name: SB/SRS001/SB001/SH002
FCC IDs: 2AFCI-SB001. 2AFCI-SH002,
15KWE072798F
USA: Federal Communications Commission (FCC)
Statement
This device complies with FCC part 15 FCC Rules.
Operation is subject to the following
two conditions:
1. This device may not cause harmful interference
and
2. This device must accept any interference,
including interference that may cause undesired
operation of the device.
FCC Warning
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment. Note:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
Why is SEAL SwimSafe™ worn around the neck?
The only consistently reliable placement is around the neck. Wristband
wearables will not accurately monitor a swimmer because they will false
alarm when a user holds their arm underwater.
What happens if the battery dies?
The Band will alert the swimmer and guard or adult when its battery is low
by blinking red and making a ‘chirping’ noise.
How many bands can be monitored by a single Hub?
One Hub can monitor twelve Bands at once. For larger swim groups,
contact SEAL Innovation (888) 786-8721 for SEAL SwimSafe™ Commercial.
What happens if I forget to take it off when I leave the pool?
The Band will give a warning to return to the pool before you get too far.
The Hub will alarm if you travel outside of its coverage area.
Will there be any apps or additional functions?
Yes, SEAL Innovation is developing the SEAL SwimSafe™ app for iOS and
Android. Sign up at www.SEALSwimSafe.com and we will notify you of
any updates to the software.
Can my swimmers wear it during a competition?
The Band is designed and tested not to interfere with any aquatic
activities. Check your individual race rules for any restrictions.
SWIM LEVEL ALARM
The Hub will flash RED/WHITE with sirens to
indicate a swimmer has been submerged for
longer than their Swim Level setting allows.
All other Bands will turn solid RED.
If the System alerts due to an emergency, all
swimmers should exit the pool. Lifeguards,
parents or others should identify the swimmer
wearing the alarming Band.
INDICATORS & WARNINGS
Why does SEAL SwimSafe™ use RFAO instead of Bluetooth?
SEAL SwimSafe™ uses Radio Frequency Always On (RFAO) technology
to ensure greater range, reliability, and accuracy than Bluetooth.
What is the range of the System?
SEAL SwimSafe™ will monitor an Olympic-sized pool.
Can I buy additional Bands separately?
Yes. You can purchase more Bands at www.SEALSwimSafe.com and at
retailers across the country.
Will it work on my boat or at the beach or lake?
Yes, as long as the swimmer stays within range of the Hub. In deep or
murky water, the strobe light on the swim Band may not be visible. It is
critical to always use safe swimming practices and have direct visual
supervision of swimmers at all times.
Is there any installation involved?
No. The SEAL SwimSafe™ System is completely portable.
Swim Level Alarm (any Band)
Low Hub Battery
Low Band Battery
Unclasped Band
Shutting Down / Starting up
Out of Charger - ON
OFF
Pairing
HUB INDICATORS
HUB WARNINGS
slow
Charging - <50% Charge - ON
Charging - >50% Charge - ON
Charged - ON
Charging - <50% Charge - OFF
Charging - >50% Charge - OFF
Charged - OFF
fast
fast
slow
HUB CHARGING INDICATORS
Charging - <50% Charge - ON
Charging - >50% Charge - ON
Charged - In Charger - ON
Charging - <50% Charge - OFF
Charging - >50% Charge - OFF
Charged - In Charger - OFF
BAND CHARGING INDICATORS
ON
OFF
Unpaired - <50% Charge
Unpaired - >50% Charge
This Band’s Swim Level Alarm
Other Band Swim Level Alarm
Low Band Battery
Unclasped Band
Shutting Down / Starting up
BAND INDICATORS
BAND WARNINGS
This Band’s Swim Level Alarm
Other Band’s Swim Level Alarm
Low Band Battery
Low Hub Battery
Other Band has a Low Battery
Other Band is Unclasped
GUARD BAND WARNINGS
REGULATORY AND SAFETY NOTICES
ALARMS
FAQ’S
/
