FURNITUREBOX Marley Barstool Assembly Instruction Manual

  • Hello! I've reviewed the Marley Barstool assembly guide, and I'm prepared to assist you with any questions you might have about assembling your new bar stool. The guide covers everything from initial setup to safety recommendations, and I can help you navigate the assembly process or clarify key features.
  • What tools are recommended for assembly?
    What should be used to clean this product?
    What is the maximum weight capacity?
MARLEY
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/marley-barstool
SCAN ME
Check you have all the components and
tools listed.
Remove all ttings from the plastic bags
and separate them into their groups.
We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
Make sure you have enough space to
layout the parts before starting.
Assemble the item as close to its nal
position (in the same room) as possible.
Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
From time to time check
that there are no loose
screws on this unit
This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE
www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
PLEASE BE AWARE THAT QUANTITIES ARE PER CHAIR
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
30 MINUTE
BUILD
MAXIMUM
CAPACITY 150Kg
Follow us on Instagram
@furniturebox_uk
STEP 1
Place seat upside down over the
edge of a table or other raised
clean, at surface.
Carefully align the leg frame
onto the seat and secure with 1 x
washer [A] followed by 1 x spring
washer [B] then 1 x screw [C] in
each hole.
Get all screws in place before
fully tightening with Allen key
[D].
www.furniturebox.co.uk
STEP 2
Carefully turn bar stool
over so it rests on its
legs. Check for stability.
Your new stool is ready
to use.
FULL ASSEMBLY INSTRUCTIONS
www.furniturebox.co.uk
www.furniturebox.co.uk
The cushions (foam inserts and
covers) are not covered by the guarantee.
/