morse 201/20-E1-50 Operators Manual and Parts Diagram
- Type
- Operators Manual and Parts Diagram
MORSE Mfg. Co., Inc. • 727 West Manlius Street • P.O. Box 518 • East Syracuse, NY 13057-0518
Copyright 2021 - Morse Mfg. Co., Inc. Form PL POLY-201FI (286584-______) (Updated 17 Feb, 2021) 1
The Specialist In Drum Handling Equipment
Kit POLY-201FI
to Roll Plastic Drum
Kit POLY-201FI for Customer to Install on Wheeled Morse 201 series Portable Drum Roller
Enables rolling a plastic drum
Serial number 286584 to ______
DRIVE SIDE IDLER SIDE
Morse Portable Drum Roller
shown with Kit # POLY-201FI installed
Installation Instructions
Idler Shaft Assembly
Add two wheels to the end closest to the loading plate and tighten in place.
Drive Shaft Assembly
Before you begin, mark the frame at all three pillow block bearing bases to locate factory set positio1.
Remove drive sprocket cover 2.
Remove the six pillow block bearing bolts. 3.
Remove master link from drive roller chain and take chain o sprocket. 4.
Remove drive shaft assembly and repeat wheel install procedure from above.5.
Set the drive shaft assembly on the frame into the position where the frame was marked. 6.
Install all bearing mounting bolts and hand tighten the nuts, except the outside bolts on the two bearings where 7.
the back stop tube assembly will be mounted (see diagram).
Reinstall drive roller chain. 8.
Insert the back stop tube as shown, and secure with 3/8-16 x 1-1/2”. bolts provided in kit. These should be hand 9.
tight at this point. The holes on the 201 channel frame may need to be drilled out a little larger, in order to line up
the holes of the back stop tube.
While ensuring that the drive roller chain is tight, tighten the bearing bolts. The bearings should be at the factory 10.
positions that were marked on the frame.
Install drive sprocket cover.11.
Final Assembly
1. Insert loading chain eye bolt in blank hole on idler side as shown. Secure with two nuts and two washers.
2. Adjust all wheels and tighten all set screws.
morsedrum.com
Copyright 2021 - Morse Mfg. Co., Inc. Form PL POLY-201FI (286584-______) (Updated 17 Feb, 2021) 2
The Specialist In Drum Handling Equipment
Kit POLY-201FI
to Roll Plastic Drum
Kit POLY-201FI for Customer to Install on Wheeled Morse 201 series Portable Drum Roller
Enables rolling a plastic drum
Serial number 286584 to ______
morsedrum.com
Copyright 2021 - Morse Mfg. Co., Inc. Form PL POLY-201FI (286584-______) (Updated 17 Feb, 2021) 3
The Specialist In Drum Handling Equipment
Kit POLY-201FI
to Roll Plastic Drum
Kit POLY-201FI for Customer to Install on Wheeled Morse 201 series Portable Drum Roller
Enables rolling a plastic drum
Serial number 286584 to ______
-
1
-
2
-
3
morse 201/20-E1-50 Operators Manual and Parts Diagram
- Type
- Operators Manual and Parts Diagram
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
morse 201/20-E1-50 User manual
-
morse 456-1-50-CE Operators Manual and Parts Diagram
-
-
-
-
-
-
-
-
