2EN
Safety instructions
Safety
• If any object enters the device, disconnect the device from the power supply and have the device
checked by an authorized service center before using it again.
• The unit is live when the AC adapter (not supplied) is plugged into an electrical socket, even if the unit
itself is turned off.
• This device is intended for use by children 8 years of age and older if they are supervised or instructed
in the safe use of the device and if they understand the dangers involved. Children must not perform
cleaning and user maintenance unless they are older than 8 years under supervision. Keep the device
and the cord out of the reach of children if they are under 8 years old.
• This device may be operated by persons with reduced physical, sensory or mental capabilities, or lack
of experience, provided they have been given supervision or instruction concerning use of the device
in a safe manner and by understanding the hazards involved. Children must not play with the device.
Location
• Do not place the device in an enclosed space, such as a bookcase or built-in cabinet.
• Make sure there is enough space around the air circulation device to prevent the device from
overheating.
• Do not place the device on a soft surface (blanket, tarpaulin, etc.) or near materials (curtains,
draperies) that could impede air circulation by blocking the ventilation holes.
• Do not place the unit near heat sources such as radiators, or in a place subject to direct sunlight,
excessive dust, mechanical vibration or shock.
• Do not place the device on an inclined surface. The device is designed for operation in a horizontal
position.
• Do not place the device near devices with strong magnets, such as microwave ovens or large
speakers.
• Do not place heavy objects on the device.
• If the unit is brought directly from a cold to a warm location, moisture may condense inside the unit
and cause damage to the optical mechanism. When switching on the device for the first time or after
moving the device from a cold environment to a warm one, wait approx. 30 minutes before operating
the device again until the moisture generated in the device has evaporated.
Power supplies
Power supply
1 Connect a suitable 5 V/500 mA adapter cable (not supplied) to the 5 V DC (mini USB)
jack on the unit, then plug the AC adapter into an electrical socket.
2 Use the ON/OFF switch to turn on the unit and select the desired audio source.
Warning!
Use only a suitable AC adapter with the specified parameters, a suitable terminal and a 5 V
DC output voltage.
The device is powered on while the AC adapter is plugged in, even if the device itself is
turned off.