Terra HS004T Owner's manual

Terra
Brand
Terra
Model
HS004T
Category
TV signal amplifiers
Type
Owner's manual

This manual is also suitable for

Splitband ampliers HS004, HS004L, HS004T EN
Vers. 1.06
INSTALLATION INSTRUCTIONS
Read the product description and safety instruction rst.
Installation of system according standard IEC60728-11 ensures safety of personnel and prevents apparatus against
damaging due to lightning or other sources of overvoltage surges.
Gain of every sub-band can be adjusted with screwdriver (12). There is a possibility to adjust the gain and slope of the
amplier in every sub-band by ne turning 10 dB regulators (7, 8) and an additional 10 dB by switching switches (5, 6) in
VHF and UHF bands.
Power feed for external equipment is turned on and o by switch (9). It has short circuit and overload protection. In normal
conditions powering indicator (10) glows green. If short circuit or overload in external powered equipment is detected - glows red.
1 23 4
9
10
11
6
5
5
6
7
7
8
8
12
13 13
1. RF IN - RF signal input, DC output connector
2. RF OUT - RF signal output connector
3. TEST -20 dB
4. TEST -30 dB
5. gain (attenuation) switches for each sub-band
6. slope (attenuation) switches for each sub-band
7. ne tuning gain (attenuation) regulators for
each sub-band
8. slope (attenuation) ne tuning regulators for
each sub-band
9. switch to turn on/o the power feed for external
equipment
10. powering indicator
11. functional ground clamp
12. screwdriver
13. mounting supports
Product description
The splitband ampliers HS004, HS004L, HS004T are intended for amplifying cable TV, terrestrial TV and FM radio signals.
There is a possibility to adjust the gain and slope of the amplier separately in VHF and UHF bands.
The ampliers can provide power (+12 V) to external equipment through RF IN connector (1).
The UHF sub-band of the HS004L, HS004T ampliers have integrated 30 dB LTE signal suppression lter .
The housing of ampliers meets more stringent screening requirements according to EN50083-2, class A.
According to the standard ETSI EN 303 354 V.1.1.1, type of these ampliers is Launch, selectivity clasication 0.
The ampliers are intended for indoor use only.
Safety instructions
Installation of the amplier must be done according IEC60728-11 and national safety standards.
The amplier is powered from mains 230 V~. This voltage is dangerous to life.
Any repairs must be done by a skilled personnel.
Do not remove the cover of the power supply section, without disconnecting the unit from the mains supply.
Do not plug the amplier into the mains supply if the power cord or plug is damaged.
Do not plug the amplier into the mains supply until all cables have been connected correctly.
The mains socket must be easily accessible.
Avoid placing amplier next to central heating components, near highly combustible materials and in areas of high humidity.
If the amplier has been kept in cold conditions for a long time, keep it in a warm room no less than 2 hours before plugging
into the mains.
Do not insert any objects into ventilation openings;
The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains.
Mount the amplier on not ammable wall or in not ammable installation box in vertical position with RF input connector
underneath. The amplier must be xed with steel screws Ø 4-5 mm. The screws are not included in a package. Mount in
locations where children not likely to be present. Shields of cables must be connected to main potential equalization bus.
From top, front and bottom of installed amplier must be at least 10 cm free space.
External view
Draugystes str. 22, LT-51256 Kaunas, Lithuania, tel.: +370 37
-
31 34 44, fax: +370 37
-
31 35 55
E-mail: [email protected], http://www.terraelectronics.com
Technical characteristics
Structure diagram
HS004 HS004L HS004T
Frequency range VHF UHF VHF UHF VHF UHF
47-414 MHz 470-862 MHz 88-230 MHz 470-790 MHz 88-230 MHz 470-694 MHz
Gain 34-39 dB 39-44 dB 36-39 dB 39-44 dB 36-39 dB 39-44 dB
Flatness ± 1 dB
Gain adjustment 20 dB 14 dB 20 dB 14 dB 20 dB 14 dB
Slope adjustment 20 dB 10 dB 14 dB 10 dB 14 dB 10 dB
Maximal IMD3=60 dB (DIN45004B) 121 dBµV
output level IMD3=60 dB 118 dBµV
Input and output return loss > 10 dB
Noise gure < 6 dB < 6 dB < 6 dB (700 MHz) < 6 dB < 6 dB (600 MHz)
Test points input -20 dB, output -30 dB
DC output for external equipment 12 V 100 mA max.
Supply voltage limit values, 198-250 V~ 50/60 Hz 7 W
power consumption*
Operating temperature range -20o ÷ +50o C
Dimensions/Weight (packed) 135x180x52 mm/0.7 kg
* with external DC loading
Caution.
Risk of electric shock.
This product complies with the relevant clauses of the European Directive 2002/96/EC. The unit must be recycled or discarded
according to applicable local and national regulations.
Equipment intended for indoor usage only.
Equipment is double insulated from the mains, with functional earthing.
Functional earthing. Connect to the main potential equalization.
The device has integrated LTE lter.
This product is in accordance to following norms of EU: EMC norm EN50083-2, safety norm EN IEC62368-1 and RoHS norm EN50581.
This product is in accordance with Custom Union Technical Regulations: “Electromagnetic compatibility of technical equipment“
CU TR 020/2011, “On safety of low-voltage equipment“ CU TR 004/2011.
DC
230 V~
RF OUT
Test -30 dB
-10/0 dB
0¸ -10 dB
DC 12 V 100 mA, max.
RF IN Test -20 dB
LTE
-5/0 dB
0¸ -5 dB
for HS004L and
HS004T only
0¸ -7 dB
-7/0 dB
-7/0 dB
0¸ -7 dB
  • Page 1 1
  • Page 2 2

Terra HS004T Owner's manual

Terra
Brand
Terra
Model
HS004T
Category
TV signal amplifiers
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents