First of all, we would like to thank you for having bought an EV product; we hope that
will give you years of reliable heating.
Before installing the heater, please read the following instructions carefully. EV is not
responsible for any damage or problems resulting from incorrect installation. Once
your heater is up and running, please store this booklet in a safe place for future refe-
rence.
Recycling
When you no longer need this heater, please follow the European Directive 2002/96/
CE as regards its disposal. This heater can not be put out as normal rubbish. It must
either be taken to a special tip or to a distributor offering to dispose for you. Recy-
cling electrical appliances separately allows component parts to be re-used and limits
the damage to the environment that would otherwise occur. Recycling saves power
and resources. To encourage this, the heater bears a symbol showing it can not be put
into a normal bin. For further information, get in touch with your local council or the
shop where you purchased this product.
RTD006211V02E00
A brief forward
3
How to use your heater
1. The controls 4
1.1 Turning on 5
1.2 The control panel 5
2. Some useful tips 6
2.1 Remote control IC-04 IR 6
Installation
1. Before installing 7
2. Hanging the heater 8
3. Connecting the radiator to your electricity supply 10
3.1 REA-TD electric scheme 10
4. Technical characteristics 11
Cuarantee 15
Contents
6
How to Use Your Heater
1.1 Turning on
Once hung and connected to the electricity supply, the radiator is ready to use.
In addition to the control panel, REA-TD electric thermal radiator has a safety switch,
on the right-hand side.
For the heater to work this switch must be turned to “I”.
To disconnect the electricity supply, to the display and the heater, this switch must be
turned to “O”. Use this position when you are not going to be using the radiator for a
considerable length of time i.e. over summer.
First of all, press the on/off button (2) to check the temperature display numbers light
up (1).
Then using the + and – key-pad (3), adjust the temperature on the display panel to the
right one for your room.
1.2 The control panel
1LSD Display Large digits showing chosen temperature, programme and other functions.
2On/Off touch button To turn the radiator on and off.
3Temperature To turn your heating up or down by 1°C from anything between 5°C and
35°C.
4Remote control mode Allows you to control the radiator with your remote.
5Remote control mode
indicator
Lights up showing you this programme is in use.
6Elements A light showing you when the radiator is on. This turns off when the set
temperature is reached.
7Input indicator A light showing you that the heater is connected to the electricity supply.
8Remote Control Receiver Flashes when new information arrives – i.e. a new temperature or
programme.
9Lock and Unlock Display
Combination of keys. Lock and Unlock the Display
To Lock the display, press the + and – keys at the same time, and the display
shows
To Unlock the display, press the + and – keys at the same time.
In order to avoid overheats do not
cover the heating
WARNING
7
How to Use Your Heater
Your recently purchased radiator is largely maintenance-free. To clean it, simply
wipe with a clean, damp cloth. Avoid using any chemical cleaners as they may disco-
lour your radiator and its fi nish.
Do not use the radiator to dry clothes on or as a shelf. Either scenario may prevent
the heater from functioning correctly and lead the heater to overheat and shut itself
off.
Any repair should only be carried out by a professional and with the heater discon-
nected.
This heater is not supposed to be used by people (including children) whose phy-
sical, sensory or mental capabilities are small, or who don’t have any experience or
knowledge, except if they are supervised or instructed about the use of this apparate
by a person, who is responsable for their security.
Children have to be supervised to make sure that they don’t play with the heater.
Warning – to prevent overheating, do not cover this radiator.
2.1 The IC-04 IR programming remote control (Additional extra)
To make using your radiator as easy as possible, you can now buy the IC-04 IR, as
an additional extra. It means you can set your radiator via this remote control.
The REA-TD has an infrared receiver inbuilt. Once you have the matching remote
control, the IC-04 IR, you can:
· Set your radiator for a couple of hours, a day or a week.
· It will store four different programmes.
· It will allow you to change the output temperature from a distance.
· It also provides you with a background temperature reading.
2. Some Useful Tips
9
Installation
1. Notes
Whilst the installation of this heater is incredibly straightforward, please ensure
you read the following carefully as EV will not be liable for any damage or problems
arising from incorrect installation.
Unwrap your heater and clear the packaging away. The packaging has been specifi -
cally chosen to allow you to recycle it.
If on unpacking, you discover any damage whatsoever, please get in touch with your
supplier within 24 hours and prior to installation.
For assembly and installation, please follow the instructions as set out in this bo-
oklet.
For safety reasons, this heater should never be installed in close proximity to a bath
or shower i.e. that you could touch the controls whilst in the bath or shower.
The radiator should not be placed below a socket.
If the cable has been damaged, it can only be replaced by EV, through its Aftersales
team, or by a qualifi ed person. This ensures the user will not be in any danger.
The radiator comes fi lled with an exact amount of high density thermic oil or granu-
lated high density magnetite, depending on your model. Repairs that will require
contact with it either must be carried out by the manufacturer or an authorised
fi rm. Any leaks should be reported to one of the aforementioned.
When the radiator is being decommissioned, the legislation on the disposal of the
oil should be followed rigorously.
At the end of the manual, you will fi nd a Guarantee, please check that this has been
completed correctly, dated and stamped.
10
Installation
The radiator comes complete with an installation kit, comprising the following:
· Screws
· Brackets (See diagram 15 on page 11)
· Hooks (diagram 16 on page 11)
· Cardboard guide, (remove from the top of the box the radiator comes in)
Please follow the illustrated steps below to hang and install your radiator:
A. Take the radiator out of its packaging and choose where to hang it. Please note
the minimum distances required around the heater. [4]
B. Remove the cardboard guide from the lid of the box and place it at the right
height, as shown in diagram 4 below. We suggest you use a level to ensure the radia-
tor is hung square. Using the holes as your guide, mark where the brackets need to
go. [6]
C. Drill and plug the holes. [7]
D. Screw the brackets to hold the radiator into place, using the screws and washers
provided. [8]
E. Hang the radiator using the brackets. (15) [9] y [10]
F. Mark the position of the hooks [11] and [12]; drill and plug holes and screw in
place.
2. Wall mounting
15
72
15
15
[4]
12
Installation
· If the Thermal Emitter that you have acquired does not have incorporated a plug,
in the supply cord, you should continue it indicated subsequently concerning the
electrical installation of the same.
· This must be carried out by a qualifi ed electrician.
· In the electrical connection of the appliance, means for disconnection must be
incorporated in the fi xed wiring in accordance with the wiring rules of the country
where go to be installed.
· Before connecting, check the supply is off.
· Before connecting the appliance to the fi xed wiring should be assured that the
voltage of supply is found inside the rated values indicated in the marking plate 220-
240V.
· The appliance must be connected to the protective conductor of fi xed wiring.
· Any problem arising from not following the instructions above will invalidate your
guarantee
· When wiring up, please follow the diagrams below, paying particular attention to
the colors of wires. B1: Selt-resetting termal cut-out
3.1 REA-TD Wiring
3. Connecting your heater to the mains
ESQUEMA ELECTRICO TAR -ED
N: Neutral
L: Live electrical scheme rea-td
[16]
J3
500W (min); 1500W (max.)
Heating element 125W
B
J4
J1
50Hz
J2
220-240V~50Hz
POWER PANEL/BOARD
CONTROL PANEL/BOARD
3 x1.5 mm2
Brown
Blue
Yellow/Green
L
N
PE
1
S1
S1: Break
PE: Earth
J: Connections
R: Heating element 375W
B1: Selt-resetting termal cut-out
13
Installation
3. Technical Characteristics
Technical data
REA
375-TD
REA
500-TD
REA
625-TD
REA
750-TD
REA
875-TD
REA
1000-TD
REA
1125-TD
REA
1250-TD
REA
1375-TD
REA
1500-TD
Nominal output (W) 375 500 625 750 875 1.000 1.125 1.250 1.375 1.500
Absorbed intensity (A) 1,6 2,2 2,7 3,3 3.8 4.3 4.9 5.4 6.0 6,5
Nominal tension/Frec. (Hz) — 220 / 240 V - 50 Hz —
Output capacity (Kc/h) 323 430 538 645 753 860 968 1.075 1.182 1290
Maximum output capacity (Kc) 7.740 10.320 12.900 15.480 18.060 20.640 23.220 25.800 25.800 30.960
No. of sections 3 4 5 6 7 8 9 10 11 12
Weight (Kg) 7 9 11 12 14 16 18 20 22 24
Width X (mm) 377,5 459 540,5 622 703,5 785 866,5 984 1.029,5 1.111
Height (mm) — 575 —
Depth (mm) — 95 —
Guarantee
EV produces high quality products for international markets. The company provides a technical guarantee for the
period of 2 years. When there is a manufacturing damage within that period, EV provides free repair, replacement
or a similar product. When a product is replaced, the guarantee is backdated to the original purchase, and last
at the most six months.
Prerequisites
1. The guarantee form must have been stamped and dated by your sales person and the second copy must have
been sent to the manufacturer within 30 days of purchase. Alternatively, the shop receipt or your electrician´s
bill can be taken as proof of purchase.
2. The guarantee only covers manufacturing defects and/or any problem occurring from such defects. All
problems arising from installing and undersized heater (not enough heat, improper installation, etc) are not
covered by this guarantee.
3. This heater is for domestic use only, installation in any other environment null and avoids this guarantee.
4. The guarantee form will only be valid if it has been correctly completed with the manufacturing number,
date of installation, owner´s details, installer´s signature, etc and has been sent within two weeks of purchase.
5. EV PLC reserves the right to decide whether to repair or replace any defective part or to replace the entire
heater. Any repair or replacement will not extend the original period of guarantee.
6. All costs arising from any damage caused by incorrect usage, transport, electrical supply are not covered by
this guarantee, nor is any malicious damage.
In no way this guarantee does provide compensation for incidental or consequential damage or injuries.
In the fi nal case of resorting to legislation, both parties will be under the jurisdistion of courts in Lugo.
Should you prefer, you can fi ll out your guarantee form at www.evconfort.com or e-mail your details to
comercial@evconfort.com
Reicor Ireland & UK Ltd for Heatzone
40 Woodvale Drive
Clonsilla Dublin 15
Ireland
UK Phone Number: 0845-4348449
GUARANTEE CARD
NAME OF CUSTOMER GUARANTEE NO
ADDRESS
HEATER TYPE SERIAL NO
TELEFON NUMBER DATE
NAME AND STAMP
OF INSTALLER SUPPLIER
DATE OF INSTALLATION SUPPLIER’S STAMP
/
