pond boss PBPAPK40W Owner's manual

Type
Owner's manual
Air Pump
Up to 800 gallons
ITEM #PBPAPK40W
PACKAGE CONTENTS
WARNINGS AND CAUTIONS
WARNING
Risk of electrical shock. This air pump has not been investigated for use in swimming pool areas.
This air pump is supplied with a grounding conductor and groundingtype attachment plug. To reduce
the risk of electric shock: connect only to a properly grounded receptacle which is serviced by ground
fault circuit interrupter.
Always disconnect air pump from the power source before beginning any maintenance or work on the
air pump.
THIS AIR PUMP IS NOT SUBMERSIBLE. DO NOT SUBMERGE THE AIR PUMP IN WATER.
CAUTION
This air pump has been evaluated for pump air only.
Do not place the air pump where it might fall into the water.
Do not place the air pump in direct sunlight.
Do not place the air pump near flammable or other dangerous materials or objects.
Use only to pump air.
Place horizontally and make sure the air pump is above the height of the water surface or prevent
water siphoning out the pond.
IMPORTANT SAFETY INSTRUCTIONS
WARNING- To guard against injury, basic safety precautions should be observed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
To avoid possible electric shock, special care should be taken since water is employed in the use of
aquarium equipment. For each of the following situations, do not attempt repairs by yourself; return the
appliance to an authorized service facility for service or discard the appliance:
Part
Description
Quantity
A
Air pump
1
B
Manifold
1
C
Hose clamp
2
D
Outlet tube
1
REMINDER
CALL 1-888-755-6750
BEFORE RETURNING TO STORE.
Questions, problems, missing parts? Before returning
to your retailer, call our customer service department at
1-888-755-6750, 8 a.m.-6 p.m., EST, Monday-Friday, or
email us at customercare@thepondboss.net. Or visit our
website www.thepondboss.net.
A
B
C
D
PLEASE CALL 1-888-755-6750 BEFORE RETURNING TO THE STORE.
WWW.THEPONDBOSS.NET
1. If the appliance falls into the water, DON’T reach for it!
First unplug it and then retrieve it. If electrical
components of the appliance get wet, unplug the
appliance immediately.
2. Carefully examine the appliance after installation. It
should not be plugged in if there is water on parts not
intended to be wet.
3. Do not operate any appliance plug or receptacle
getting wet, position aquarium stand and tank to one
side of wall-mounted receptacle to prevent water from
dripping onto the receptacle or plug. A “drip loop”
should be arranged by the user for each cord
connecting an aquarium appliance to a receptacle.
The “drip loop” is that part of the cord below the level
of the receptacle, or the connector if an extension
cord is used, to prevent water travelling along the
cord and coming in contact with the receptacle. If the
plug or receptacle does get wet, DON’T unplug the
cord. Disconnect the fuse or circuit breaker that
supplies power to the appliance. Then, unplug and
examine for presence of water in the receptacle.
a. Close supervision is necessary when any appliance is used by or near children.
b. To avoid injury, do not contact moving parts.
c. Always unplug an appliance form an outlet when not in use, before putting on or taking off parts, and
before cleaning, never yank cord to pull plug from outlet. Grasp the plug and pull to disconnect.
d. Do not use an appliance for other than intended use. The use of attachments not recommended or
sold by the appliance manufacturer may cause an unsafe condition.
e. Do not install or store the appliance where it will be exposed to the weather or to temperatures
below freezing.
f. If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less
amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord
so that it will not be tripped over or pulled.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or
operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 15 minutes
No tools required for assembly.
IMPORTANT NOTES
This product will not operate unless it is fully assembled with the lamp base screwed completely into
the housing.
DO NOT SUBMERGE THIS AIR PUMP IN WATER.
Specifications
Voltage
120 V
Power
35 W
Rated Frequency
60 Hz
Air flow
800 GPH
Pressure
0.030 MPa
Max. Air Stone depth
9 feet
Aquarium tank
Appliance
Power
supply
cord
Drip loop
PLEASE CALL 1-888-755-6750 BEFORE RETURNING TO THE STORE.
WWW.THEPONDBOSS.NET
ASSEMBLY INSTRUCTIONS
Air pumps should be installed 12 inches or more above the water level to ensure that water cannot flow
from the airline/diffuser back to the pump. Air pumps may be used without protection although for
longer life it is suggested that it be placed indoors or under a protective ventilated cover. Keep pump as
dry as possible. If left outdoors place it on a hard surface that will stay dry during heavy rains.
1. Connect outlet tube to the air pump. Use a hose clamp if
necessary. Fig. 1
Fig. 1
2. Connect the other end of the outlet tube to the manifold. Use
a hose clamp if necessary. Fig. 2
NOTE: It may be necessary to anchor the manifold with a
rock to secure it under water.
Fig. 2
3. Connect tubing to the air stone. Fig. 3
NOTE: Tubing and air stone are NOT INCLUDED.
Fig. 3
4. Connect the other end of the tubing to the manifold. Then
place the air stone in the water. If necessary you can connect
more air stone to manifold. Fig. 4
NOTE: Tubing and air stone are NOT INCLUDED.
Fig. 4
PLEASE CALL 1-888-755-6750 BEFORE RETURNING TO THE STORE.
WWW.THEPONDBOSS.NET
5. Connect air pump to a proper power source. Fig.5
NOTE: DO NOT SUBMERGE THE PUMP IN WATER!!!
Fig. 5
MAINTENANCE & TROUBLESHOOTING
There are no parts that need lubrication. The integrated air filter requires periodic cleaning. To clean
the filter media, remove the air filter cover. Extract the filter media from the air pump and rinse
thoroughly with cold water. Before replacing, wait for the air filter to dry. Replace media into the empty
filter cavity, replace the air filter cover and refasten. When the airflow decreases, it is time to replace
the diaphragms. There are two diaphragms, one at either end of the pump.
1. Disconnect the air pump from AC receptacle.
2. Remove the cover lid.
3. Unscrew the diaphragm assembly from either end of the pump.
4. Remove the diaphragm assembly.
5. Remove the black, round doughnut-like diaphragm and replace with the supplied parts.
6. Replace the diaphragm assembly and refasten.
7. Replace the cover lid.
Printed in China
GFCI
PLEASE CALL 1-888-755-6750 BEFORE RETURNING TO THE STORE.
WWW.THEPONDBOSS.NET
LIMITED WARRANTY
All pumps and electrical products are warranted to the user against defective material and workmanship, under
normal working conditions. This warranty period begins on the date of purchase by the original purchaser.
Unless otherwise specified all pond boss® electrical products are warranted to the user against defective
material and workmanship, under normal working conditions for 1 year from the date of purchase.
Fountain pumps are warranted for 2 years.
Pond pumps are warranted for 3 years.
Waterfall pumps are warranted for 5 years.
All pond boss® liners are warranted to the user against defective workmanship, under normal working
conditions for 20 years from the date of purchase.
All other pond boss® products are warranted to the user against defective material and workmanship,
under normal working conditions for 90 days.
Application
Warranty covers only properly installed and maintained units. Any damage to the cord or modification to the unit
will invalidate the warranty. Pump warranty is limited to applications pumping fresh water in a pond or fountain
only. Other liquid applications or extreme temperature uses must be approved in writing by the manufacturer.
Receipt and product date code are required for warranty claims.
Warranty Claim
Warranty claims must be made by calling customer service (at 1-888-755-6750). If the item is determined
to be defective, you will be given authorization to return the defective part(s), freight pre-paid, along with proof of
purchase.
Disposition
The manufacturer will make a good faith effort for prompt disposition regarding all warranty claims. Returned
product will be inspected to determine cause of failure before warranty is applied. Warranty does not cover any
costs associated with the shipping, handling, installation or removal of products or parts subject to this warranty.
For products damaged in transit, a claim should be filed with the carrier.
Disclaimer
Any oral statements made about the product by the seller, the manufacturer, the representatives, or any other
parties do not constitute warranties, should not be relied upon by the user, and are not part of the contract for
sale. The seller’s and manufacturer’s only obligation, and buyer’s only remedy shall be for the manufacturer to
either replace and/or repair at the manufacturer’s sole discretion, the product as described above. Neither seller
nor the manufacturer shall be liable for injury, loss or damages for lost profits, lost sales, injury to person or
property, or any other incidental or consequential loss arising from any cause whatsoever, no matter whether
based upon warranty, contract, negligence or other misuse, and the buyer and user agree that no other remedy
shall be available to them. Before using, the buyer and user shall determine the suitability of the product for the
intended use, and assume all risk and liability whatsoever in connection therewith. The warranty and remedy
described in this limited warranty is an exclusive warranty and remedy in lieu of any other warranty or remedy
expressed or implied. All other warranties and remedies are hereby expressly excluded, including but not
limited to any implied warranty of merchantability of fitness for any particular purpose. This warranty gives the
buyer and user specific legal rights, and buyer and user may also have other rights which vary from state to
state. Some states do not allow exclusions or limitations of incidental or consequential damages, so the above
limitations or exclusions may not apply to you.
REMINDER
CALL 1-888-755-6750
BEFORE RETURNING TO STORE.
PLEASE CALL 1-888-755-6750 BEFORE RETURNING TO THE STORE.
WWW.THEPONDBOSS.NET
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

pond boss PBPAPK40W Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI