SCOTT CX 100 DP is an advanced FM/MW PLL radio alarm clock with a power cradle. It offers a wide range of features, including the ability to store up to 10 preset stations for both FM and MW, a sleep function with a duration of up to 90 minutes, and a snooze function for those who need a little extra time in the morning.
SCOTT CX 100 DP is an advanced FM/MW PLL radio alarm clock with a power cradle. It offers a wide range of features, including the ability to store up to 10 preset stations for both FM and MW, a sleep function with a duration of up to 90 minutes, and a snooze function for those who need a little extra time in the morning.
CX 100 DP
FM/MW PLL RADIO
ALARM CLOCK WITH
POWER CRADLE
Instruction Manual
CR25-SCOTT-AMFM-ENG.indd 1 12/11/2008 16:41:10
GB 1
PRECAUTIONS
Follow the advice below for safe and appropriate operations.
PLACEMENT
- Do not use the unit in places, which are extremely hot, cold, dusty, or humid.
- Place the unit on a at and even surface.
- Do not restrict the airow of the unit by placing it in a place with poor airow, by covering it with a cloth ,
or by placing it on a carpet.
- Do not place the apparatus close to a source of heat.
- Use the apparatus only in moderate climates (not in tropical climates).
- Do not expose the apparatus to dripping or splashing.
- Do not place objects lled with liquids such as vases on the apparatus.
SAFETY
- When connecting and disconnecting the AC power cord from the AC mains outlet, pull the plug and not the cord itself.
Pulling the cord may damage it and may be dangerous.
- The mains plug must remain easily accessible.
- When you are not going to use the unit for a long period of time, disconnect the AC power cord from the AC mains outlet.
AC VOLTAGE
- Before use, check that the rated voltage of your unit matches your local voltage.
CONDENSATION
- When there is condensation inside the unit, it may not function normally.
- Unplug the unit for 1 to 2 hours before turning the power back on, or gradually heat the room up and dry the unit
before use.
- Ensure a minimum distance of 5 cm around the apparatus for sufcient ventilation.
- Ensure that the ventilation is not impeded by covering the ventilation openings with items such as newspaper,
tablecloths, curtains, etc.
BATTERIES
- Pay attention to the environmental aspects of battery disposal.
ATTENTION : To reduce the risk of electric
shock, do not remove the cover. There are
no user serviceable parts inside the unit.
Refer all servicing to qualied personnel.
The exclamation mark within a
triangle is a warning sign alerting
the user to the presence of impor-
tant instructions accompanying
the product.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
In case of malfunction due to electrostatic discharge, the apparatus has to be reset by disconnecting it from mains supply.
The lightning ash with an arrow-
head symbol within a triangle is a
warning sign alerting the user to the
presence of “dangerous voltage”
inside the unit.
CR25-SCOTT-AMFM-ENG.indd 2 12/11/2008 16:41:11
LOCATION OF CONTROLS
GB 2
BOX CONTENTS
1. Unit 3. Instruction manual
2. AC power cradle
1 2 3 1
4
5
6 7 8 9 10 11 12 13 14 15 16 17
1 2 3 2 4 5 6
7 8
Unit
1. Speakers (2x)
2. LED AC power indicator via the power cradle
3. LCD display
4. VOLUME +/- buttons
5. MUTE button
6. Clock/Alarm set
7. ALARM MODE button
8. DISPLAY button
9. SLEEP button
10. FM antenna
11. Battery door
12. SNOOZE button
13. MEMO button (preset stations)
14. P+/P- preset buttons
15. BAND button
16. button
17. TUNE/SET +/- button
LCD display
1. Stereo indicator (ST) in FM radio
2. Radio FM/ MW radio mode indicators
3. Time and frequency display
4. SNOOZE mode
5. SLEEP mode
6. MHz/kHz: Unit ofFrequency units in FM/MW
radio mode frequency
7. Buzzer alarm mode ( )
8. Radio alarm mode ( )
CR25-SCOTT-AMFM-ENG.indd 3 12/11/2008 16:41:11
GB 3
Using the AC power cradle
Insert the cradle’s AC power cord plug into an AC mains outlet with a 230V AC ~ 50Hz
power source and dock the unit into the cradle. The AC power LED indicator lights up
indicating that the cradle is supplying the power to the unit.
Using batteries
1. Open the battery compartment door.
2. Insert 3x UM3/ “AA” size batteries (not supplied) with the polarities (+/-)
matching the markings in the battery compartment. Reversed batteries may
damage the unit.
3. Replace the battery compartment door.
Note: When the AC power cradle is used, the battery power is cut off automatically.
Precautions when using batteries
1. Use only the size and type of batteries specied.
2. Do not mix different types of batteries together (e.g. alkaline, rechargeable or standard (carbon zinc)) or
old batteries with fresh ones.
3. Exhausted batteries must be removed to prevent possible battery leakage.
4. Dispose of batteries properly according to environmental regulations.
Memory backup for time and preset stations
During a power failure or while batteries are being replaced, the unit can save the time and preset stations for a
maximum time of 60 seconds.
POWER SUPPLY
CR25-SCOTT-AMFM-ENG.indd 4 12/11/2008 16:41:13
GB 4
BASIC OPERATION
ON/ Standby mode
After connecting the power supply (refer to POWER SUPPLY), the unit is in standby mode and the clock time is
displayed. Press the button to turn on the unit and press it again to go to standby mode.
Clock and Alarm time setting
1. Press the button and the hour digits will ash.
2. Press the TUNE/SET +/- button to set the hours.
3. Press the button to conrm the setting and the minute digits will ash.
4. Press the TUNE/SET +/- button to set the minutes.
5. Press the button again to conrm the clock time setting. You will automatically
go into alarm time setting mode. The hour digits will ash.
6. Repeat steps 2 to 4 above to set the alarm time.
Alarm operation
This unit allows you to wake up by buzzer or radio.
1. To adjust the alarm time, follow the steps in “Clock and Alarm time setting”.
2. To select the buzzer ( ) or radio ( ) mode, press the ALARM MODE button. The corresponding
alarm mode indicator will light up on the LCD display.
3. When the preset alarm time is reached, the alarm will sound in the selected alarm mode.
4. To stop the alarm, press the button. The alarm will sound again at the same time the next day. To
disable the alarm function, press the ALARM MODE button repeatedly until the alarm mode indicators
disappear.
Note: While the buzzer alarm volume is xed and cannot be adjusted, the radio alarm volume can be adjusted to
your desired level using the VOL +/- buttons. To select the station, refer to “RADIO OPERATION”.
Snooze function
When the alarm sounds, press the SNOOZE button to stop the alarm temporarily. The
“ ” and “ ” indicator will ash and the alarm will sound again after 9 minutes.
To cancel the SNOOZE function and repeat the alarm the next day, press the button.
Sleep function
This function allows you to programme the unit so that the radio switches off automatically after a certain
duration (up to 90 minutes).
CR25-SCOTT-AMFM-ENG.indd 5 12/11/2008 16:41:14
GB 5
1. When the unit is switched on, press the
SLEEP button, and “90 ” is displayed.
2. Press the SLEEP button repeatedly to select the duration: 90, 80….each time the
button is pressed, the duration is reduced by 10 minutes, until the duration reaches 0.
3. When the preset sleep duration elapses, the radio turns off automatically.
4. To cancel the sleep function before the preset sleep duration elapses, press the button to turn off the
radio immediately.
VOLUME control
Press the VOL +/- buttons to adjust the volume level.
MUTE function
Press the MUTE button to shut off the sound. Press it again or use the VOLUME +/- buttons to resume the
sound.
Display mode
In standby mode, press the DISPLAY button to display the alarm time for ve seconds. The unit will then return
to the clock time display.
When the unit is switched on, press the DISPLAY button repeatedly to display the clock or alarm time for ve
seconds. The display will then indicate the current radio frequency again.
LCD display backlight
Hold down the DISPLAY button to adjust the LCD display brightness level in the following sequence: off, low or
high. To save the battery power, it is strongly recommended to set the display brightness to off when the unit is
powered by batteries.
CR25-SCOTT-AMFM-ENG.indd 6 12/11/2008 16:41:15
Listen to the radio
1. Press the button to turn on the unit.
2. Press the BAND button to select FM or MW.
3. Hold down the TUNE/SET +/- button for 2 seconds to launch automatic tuning for stations ( up or down ).
Release the button to receive a radio station. For manual ne-tuning, you can press these buttons briey
to adjust the frequency step by step.
FM Stereo
In FM mode, the symbol “ ” is displayed when an FM stereo station is received. You can now enjoy stereo
sound.
Achieve optimum reception
In FM mode, extend and position the FM antenna to achieve optimum reception.
In MW mode, orientate the unit to achieve optimum reception.
Preset radio stations
You can store up to 10 stations each for FM and MW.
Automatically store stations
Hold down the MEMO button for 2 seconds, and the unit will automatically search and store the stations it nds.
Manually store stations
1. Use the TUNE/SET +/- buttons to manually search for a desired station.
Then press the MEMO button to memorize the station you have found.
The station number will ash.
2. Press the P+/P- buttons to select the number you would like to allocate to the station.
3. Press the MEMO button again to conrm the setting.
4. Repeat steps 1 to 3 above to store any other desired stations.
Listen to a preset station
When listening to the radio, press the P+/P- button to select a preset radio station.
RADIO OPERATION
GB 6
CR25-SCOTT-AMFM-ENG.indd 7 12/11/2008 16:41:16
GB 7
Care and maintenance
To clean the casing, unplug the unit and wipe off dust and stains with a soft cloth moistened with a mild soap and
water solution only. Do not use benzene, thinner or similar chemicals to clean the casing.
MAINTENANCE
Radio
Tuning range FM: 87.5 – 108 MHz
MW: 522 – 1620 kHz
Antennas FM: telescopic
MW: built-in ferrite bar
General
Output power 2 x 80mW
Power consumption 3.5 W
Speakers (2x) 2” diameter
8 Ohm impedance
Power source:
AC power cradle Input: AC 230V ~ 50Hz
Output: DC 4.5V
Batteries DC 4.5V: 3 x 1.5V UM3/ “AA” batteries
Dimensions 80 (H) x 190 (W) x 36 (D) mm
Weight
Unit 0.24 Kg
Unit with AC power cradle 0.5 Kg
Note: Due to continuing improvements, the technical specications are subject to change without notice.
TECHNICAL SPECIFICATIONS
If at any time in the future you should need to dispose of this product, please note that waste
electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your local authority or retailer for recycling advice.
(Waste Electrical and Electronic Equipment Directive)
CR25-SCOTT-AMFM-ENG.indd 8 12/11/2008 16:41:16
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
SCOTT CX 100 DP is an advanced FM/MW PLL radio alarm clock with a power cradle. It offers a wide range of features, including the ability to store up to 10 preset stations for both FM and MW, a sleep function with a duration of up to 90 minutes, and a snooze function for those who need a little extra time in the morning.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
