Ames LG5QS User manual

Ames
Brand
Ames
Model
LG5QS
Type
User manual

This manual is also suitable for

SPECIFIC
HAZARD
FLAMMABILITY
REACTIVITY
HMIS
HEALTH
HAZARD
0
0
1
Five Gallons (18.925 Liters)
What is Liquid Granite?
Ames® Liquid Granite® is a strong, water-base, liquid acrylic plastic,
elastomeric coating fused with a multi-color blend of decorative chips.
It seals and protects by substantially increasing the strength of the
surface through adhesion. The resulting finish is a beautiful seamless
floor or wall with a semi-gloss 'granite-like' appearance that is
waterproof and slip-resistant. Both professional and DIY painters can
restore old and worn surfaces to better than new condition with Liquid
Granite.
Liquid Granite® is a high performance architectural coating ideal for
floors, porches, patios, walkways, stairways, wheelchair ramps, decks,
roof decks, basement walls, and laundries. It has many other decorative
applications on concrete, metal and wood that is only limited by your
imagination.
Liquid Granite® is a one-component, strong resurfacer which may be
applied to most any shape or contour using a trowel or squeegee. It has
excellent adhesion and bonds permanently to most types of sound
substrate including wood, concrete, metal, asphalt and fiberglass. Liquid
Granite® fills small cracks and imperfections in floors and walls. It
penetrates, seals, and reinforces concrete floors and helps restore
eroded concrete. It provides a waterproof, slip-resistant surface that is
extremely durable and easy to clean.
Liquid Granite® is environmentally safe and user friendly. It dries rapidly
for minimal down time, is low odor, non-flammable and water clean-up.
It is chemical resistant and easy to clean.
Application Suggestions
Applying Liquid Granite® is a creative process. Application rate and
method will vary depending upon the condition and type of surface.
Some surfaces may require priming with Ames® Super Primer™, Super
Elasto-Barrier®, or Blue Max® Trowel Grade. For additional application
tips and suggestions, please visit our website: www.amesresearch.com.
Do-It-Yourself in 3 Easy Steps
1. Surface Preparation
Be sure that surfaces are clean and dry before the coating application.
Caulk all cracks greater than 1/8" wide with Blue Max trowel grade.
Install adequate drains to drain flat roofs. Shot blast concrete in severe
situations as needed. Always run a test patch first in an inconspicuous
area. This is to ensure that there is proper adhesion and drying, and that
the product performs to your satisfaction. Check our website at
www.amesresearch.com for the latest updates before proceeding with
the application.
2. Seam Tape Cracks, Joints and Seams
Surfaces with joints, cracks, flashings, vents, parapet wall flashings or
where two unlike surfaces come together require seam tape.
Werecommend Ames' Peel & Stick™ Seam Tape (PS250, PS450 or
PS650) to provide some additional strength and reinforcement on these
surfaces. Prime all surfaces generously with Super
Elasto-Barrier prior to setting the Seam Tape in place. (See Seam Tape
label for instructions.) Apply a liberal topcoat of Super Elasto-Barrier
over the Seam Tape and allow to cure. Smooth concrete surfaces may
need to be primed with Super Primer for better adhesion. Some
surfaces may require priming with both Super Primer and Super
Elasto-Barrier.
3. Topcoat with Liquid Granite
Apply Liquid Granite® to the surface. We recommend 1 to 2 coats of
Liquid Granite as needed to properly seal the surface for a watertight
system. A trowel works best when applying Liquid Granite®.
Horizontal / Flat Surface Application Suggestions
One may start applying Liquid Granite® by pouring 1 to 2 quarts of the
product onto the surface to be coated. We recommend working in
small manageable increments as to let the applicator reach the whole
section being covered. This suggested area would be roughly 2 feet
wide by 6 feet long. Decrease this area if you are working in direct
sunlight on a warm day as the coating’s dry time will be faster. Spread
the Liquid Granite® evenly with a 8" to 12" trowel. After a uniform
coating has been applied you can smooth out the surface with a large
cement/concrete trowel to give it a smooth finish. You may also
sprinkle a little water on the Liquid Granite® or wet your trowel to help
aid in creating your smoother finish. Then just repeat this process until
the desired area is completed and let it cure. A second coat may be
required depending on application thickness and uniformity.
Vertical Surfaces Application Suggestions
Liquid Granite may be applied to a vertical surface using a large trowel
as you would apply stucco to a wall. Or you may use a drywall mud
taping knife. After a uniform coating has been applied you can smooth
it out with your trowel to give it a smooth finish. You can sprinkle a little
water on Liquid Granite or wet your trowel to help aid in creating your
smooth finish. Then just repeat this process until the desired area is
completed and let it cure. A second coat may be required depending
on application thickness and uniformity. Tip: apply a light initial coat to
provide “traction” for a second coat. This will help prevent “sag”.
Application Tools
Liquid Granite may require one or more of the following:
Coverage
Standard product coverage is approximately five gallon per 100 sq. feet
per coat. Rough surfaces may require additional coating. Most surfaces
will only require one coat. Second coat may be required in some
applications.
Wood Decks
Sand or wire brush any areas that have loose material or are dirty. Prime
as much of the wood surface as possible with Super Elasto-Barrier liquid
rubber primer and sealer. On new deck construction, when possible,
apply Super Elasto-Barrier® to all surfaces, sides and ends of the wood
before constructing deck. Allow to dry. Topcoat with one or more coats
of Liquid Granite® and allow proper drying between coats.
Plywood (Decks and Ramps)
Seam tape and seal all seams, joints, flashings or drip edges with Super
Elasto-Barrier® and Seam Tape. Use outdoor, waterproof, 1/2-inch or
better plywood. Prime entire surface with one or more coats of Super
Elasto-Barrier and allow to dry. On new deck construction, apply Super
Elasto-Barrier to all surfaces, sides and ends of the board before
constructing deck. Ames® Contouring Roof Fabric™ (CRF-250) is
generally used in roof deck applications. Topcoat with one or more
coats of Liquid Granite®.
Concrete Surfaces
Concrete surfaces should be wire brushed or pressure washed to
remove any loose dirt or debris. Do not apply Liquid Granite® over
damp or severely decomposing concrete. Repair the concrete and allow
to cure for up to 30 days prior to application of Liquid Granite. Concrete
should be approximately 6 inches above ground water. Apply Super
Primer™ on areas with heavy use and in commercial applications.
Topcoat with one or more coats of Liquid Granite. Areas where standing
water may occur may require annual maintenance or cleaning.
Some surfaces may require maintenance because of potentially severe
weather conditions or excessive wear and tear. Other surfaces may
require priming with Super Elasto-Barrier. For roof deck applications see
our roof deck specifications.
Cleanup, Storage & Disposal
Clean tools and small spills with water. Store
unused product in its original can, tightly
sealed and protected from freezing. Dispose
of this product in accordance with local, state,
or federal requirements.
Weather & Drying Guidelines
For exterior applications Liquid Granite® is best applied between 50
to 90 degrees F (10 to 32 degrees C) on warm dry surfaces. Be sure
humidity is less than 50% and dew point and temperature have a
good spread. Liquid Granite® will begin to dry in 30 minutes to 2
hours depending upon thickness of application and weather. It
continues to cure for up to 2 weeks. Liquid Granite may be recoated
when it is dry to the touch.
IMPORTANT: For exterior applications check your local weather
forecast and follow our Ames® Weather Rule: apply when the
streets are dry, the sun is in the sky, and no inclement weather is
forecast for 24 hours. The best work window during winter months
is usually between 10 am and 2 pm. Low temperatures, high
humidity and evening and morning dew will require increased
drying/curing time.
First Aid / Caution
Keep out of reach of children. If swallowed, do not induce vomiting.
Give milk or water and seek medical attention immediately. In case
of contact with eyes, flush thoroughly with water and call a doctor or
poison control center. This product contains a unique combination
of water base acrylic co-polymers. Call 911 for the poison control
center. Repeated or prolonged contact with skin may produce
irritation or sensitivity. Use gloves. Water cleanup.
Warning: If you scrape, sand or remove old paint, you may release
lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUSTCAN CAUSE
SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLYIN
CHILDREN. PREGNANTWOMEN SHOULD ALSO AVOID EXPOSURE.
Wear a NIOSH-approved respirator to control lead exposure. Clean
up carefully with a HEPA vacuum and a wet mop. Before you start,
find out how to protect yourself and your family by contacting the
National Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
CA Prop 65: This product may contain chemical(s) known to the state of
California to cause cancer and/or birth defects or other reproductive harm
Manufactured by: Ames Research Laboratories, Inc.
1891 16th St SE, Salem, OR 97302
Toll-Free: 1-888-345-0809
Phone: 1-503-588-3330
Fax: 1-503-364-2380
Email: [email protected]
Visit our website at www.amesresearch.com.
Ames®, Blue Max®Trowel Grade, Contouring Roof Fabric™, Liquid
Granite®,Peel & Stick™ Seam Tape, Super Elasto-Barrier®, Super Primer™, is
a trademark of Ames Research Laboratories, Inc. Illustrations copyright ©
2008-2017 by Ames Research Laboratories, Inc. All illustrations and diagrams
are property of Ames Research Laboratories, Inc. All Rights Reserved.
Protect From Freezing
Store Above 50° F
Ames’
Peel & Stick
Seam Tape
Squeegee
Scissors or
Utility Knife
8”-12” Trowel
Suggested Application
For A Roof Deck
Liquid Granite
Super Elasto-Barrier
(2nd coat)
Super Elasto-Barrier
(embedding layer)
Contouring
Roof Fabric
(CRF250)
Ames® Peel & Stick Seam Tape
(PS250, PS450, PS650)
Plywood Deck
Water Clean-Up
8 1 4 5 8 0 0 1 1 0 6 2
LG5SL
  • Page 1 1

Ames LG5QS User manual

Ames
Brand
Ames
Model
LG5QS
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents