1
Installation Instructions for
1A
LAMP
JUNCTION BOX
MOUNTING
PLATE
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is safety listed for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
SOCKET
MOUNTING
PLATE SCREW
SHADE
FIXTURE
SCREW
ALLEN WRENCH
Pentragram 1, 2, 3, & 4 Light Vanity Strip
1.1
V 2040_S
V 2040_S
Vanity Strip
1
6
7
COLLAR NUT
SPACER
Secure the mounting plate to the electrical box with the two mounting plate screws.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the fixture screws using an Allen wrench.
Place the shade and spacer over the socket, then secure them in place by screwing the shade collar nut onto the socket.
Repeat for multiple shades.
Screw the lamp(s) into the socket(s). Refer to the label on the lamp socket for Max Wattage information.
1
2
3
4
5
6
7
1
3
4