Beachside Beverly
For questions or comments about your product, please contact us at
[email protected] or call our toll free customer service number
1-800-876-7336.
We guarantee that every product we sell
will stand up to the supreme test — our customers’ satisfaction.
BO_ 46 0 9 _ A3 _ EN _0 8.11.15
WARNING
• This table is intended for decorative use only.
• Do not place heavy items on the table top. Maximum capacity is 7lbs/3.18Kg.
• This table is not designed to hold excessive weight or to be used as a seating surface.
• Improper use may result in damage to the table or bodily harm.
CARE AND MAINTENANCE
• Do not use harsh chemicals when cleaning the surface of the unit. Doing so will
damage the nish. It is best to wipe clean with a damp cloth.
• If you are located in a freeze/frost climate (32°F and below), store indoors for the
winter months.
ASSEMBLY INSTRUCTIONS
1. Begin by placing Beachside Beverly (C) on her back on a soft at surface. (Fig. 1)
2. Secure the base (A) to Beachside Beverly (C) using 2 short Allen bolts (E), 2 at
washers (G) and 2 spring washers (H). (Fig. 1)
3. Ensure the bolts are alligned and assembled correctly.
4. Fully tighten the bolts (E) with the Allen Wrench (I).
5. Align the beach ball (B) to the base (A) and attach using 1 short Allen bolt (E), 1 at
washer (G) and 1 spring washer (H). (Fig. 2)
6. Ensure the bolt is aligned and assembled correctly.
7. Fully tighten the bolt (E) with the Allen wrench (I).
8. Stand Beachside Beverly up on the base. (Fig. 3)
9. Position the tray (D) on top of Beverly’s hand so
that the peg on the bottom of the tray ts into the
peg hole. (Fig. 3)
10. Use 1 long Allen bolt (F), 1 at washer (G) and 1
spring washer (H) to attach the tray to Beverly’s
hand through the peg hole.
11. Fully tighten the bolt (F) with the Allen wrench (I).
ASSEMBLY NOTES
• Please make sure that you have all parts indicated before you begin assembly.
• Items should be assembled on a soft surface to avoid scratching during assembly.
• This product may need periodic tightening. We recommend tightening every 6 months.
• Caution: Do not overtighten.
ATTENTION
Read all instructions before assembly and use of this product. Failure to follow
these instructions and warnings could result in injury or damage to the item.
Keep these instructions for future reference.
A B C D
Base Beach Ball Beachside Beverly Tray
1 1 1 1
LARGE PIECES
C
A
F
I
G
H
I
Allen Wrench
1
TOOLS
SMALL PIECES
E F G H
Short Allen Bolt Large Allen Bolt Flat Washer Spring Washer
3 1 4 4
C A G H E I
B A
G H E I
D
Fig. 1
Fig. 2
Fig. 3
/
