Jensen POWER760X5D Installation guide
- Category
- Audio amplifiers
- Type
- Installation guide
Power Series Class D Amplifiers
Installation Manual / Quick Start Guide
MODEL NUMBER FUSE SIZE MIN. WIRE GAUGE
2x30A
Power760x5D
Power1100x1D
3x35A
#4
#4
Installation Assistance
For installation assistance, call 888-921-4088 during normal business hours, or
visit www.jensenmobile.com at any time.
Supplies and Tools
To install the amplifier, you will need tools, supplies and adapters. It is best to
make sure you have everything you need before you start.
Disconnect Battery
Disconnect the negative (-) battery cable before starting the installation. Check
the battery ground (there should be two (2) ground wires coming from the
battery – one going to the starter mounting bolt or engine block and another
going to the vehicle chassis) and make sure the battery is grounded to the
chassis with at least a #4 gauge wire. Also check the alternator connections,
making sure they are tight and free from corrosion, rust or dirt.
Location and Mounting
The amplifier’s compact design allows great flexibility in mounting. Common
mounting locations include under the front passenger seat or in the trunk area.
When selecting a location, remember that amplifiers generate heat. Select a
location on a flat surface away from heat and moisture where air can circulate
around the amplifier.
Recommended Power Wire Size
Power Terminal (+12V) and Ground Terminal (Gnd)
Connect the main power wire to the battery, within 18 inches from the positive
(+) battery post, use an adequate size fuse or circuit breaker capable of
handling the current of the selected power wire. A fuse or circuit breaker must
be installed to prevent a possible electrical fire should the main power wire
short to ground.
POWER INPUT
GND REM +12V
Fuse or Circuit Breaker
Install as close to the
battery as possible.
Battery Terminal
Adapter
Make the ground lead as short as possible, leaving enough length to complete
the installation. To ensure a good ground, scrape away any paint or
undercoating to expose bare metal. Use a "ring" terminal of the proper gauge
and an "outside star washer" (between the chassis and ring terminal) when
making your ground connection.
Drill hole in chassis
Remote Terminal (Turn-On)
Connect the power antenna or amplifier turn-on lead (Switched +12VDC)
from the receiver to the amplifier remote terminal.
POWER INPUT
GND REM +12V
Remote Turn-On (Power Antenna) From Head Unit Receiver
B
A
L
T
SU
B-W
MO
NO
AS
/P
S
DIS
P
LOC/DX
1
2
INT
5
6
BAND
SCAN
i
EQ
MUTE
MODE
3
RPT
4
SHF
CD2620
DN
UP
i
BA
X
- SS
CH
A
NGER
40
WA TT
Sx4
JPTH
CD
AU
-R/R
W
i
E
I
N
X
Q
4
AUX
CD RECE IV ER
E
L
R
F
A
D
E
B
A
S
S
R
E
B
VOL
Drill hole in chassis sheet metal.
Note: Complete amplifier operation manuals are online at
www.jensenmobile.com
Speaker Wiring
The Speaker Wiring diagrams illustrate options for connecting speakers.
Observe the proper speaker polarity.
Power110x1D
One Subwoofer
– – + +
Two Subwoofers
SPEAKER OUTPUT
4 Ohm / 2 Ohm
– – + +
SPEAKER OUTPUT
Power760x5D
Five Speakers
+ CH1 - + CH2 -
+ CH3 - + CH4 -
+ BRIDGED -
+ CH1 - + CH2 -
+ CH3 - + CH4 -
+ BRIDGED -
Power760x5D
Three Speakers
2 Ohm Minimum (Each)
4 Ohm / 2 Ohm Minimum
4 Ohm / 2 Ohm Minimum
4 Ohm Minimum
4 Ohm Minimum
Minimum load is 1 Ohm for any combination of subwoofers
2 Ohm Minimum
2 Ohm Minimum
Input Wiring
Most trunk/hatchback installations will require a 15-20 foot RCA cable, while
pickup trucks and under-seat mounting will require a 6-12 foot RCA cable.
Connect an RCA cable from your receiver to the RCA input on your amplifier.
Power1100x1D
Power760x5D
POWER
PROTECTION
BASS EQ
0
12
3
0.5
10
LEFT
RIGHT
LEVEL
6
0.3
2.5
V
LEVEL
6
0.3
2.5
V
LEVEL
6
0.3
2.5
V
FRONT
REAR SUB
FLAT HPF
FLAT HPF
X-OVER
MODE
5CH 4CH
REMOTE
LPFHPF
HPF
FRONT
REAR
SUB
3.5
1.5
5
16
Hz
160
16
Hz
160
30
Hz
160
3.5
1.5
3.5
1.5
5
1
30
22
45
22
45
35
80
30
50
150
RIGHT
LEFT
RIGHT
LEFT
POWER
PROTECTION
LEVEL
LOW
PASS
80
40
300
Hz
BASS
EQ
0
12
3
dB
SUB
SONIC
20
10
40
Hz
6
0.3
2.5
5
V
3.5
1.5
60
140
15
25
1
5
PHASE
OUTPUT
INPUT
REMOTE
Limited One Year Warranty
This warranty gives you specific legal rights. You
may also have other rights which vary from
state to state.
Dual Electronics Corp. warrants this product to the
original purchaser to be free from defects in
material and workmanship for a period of one year
from the date of the original purchase.
Dual Electronics Corp. agrees, at our option, during
the warranty period, to repair any defect in
material or workmanship or to furnish an equal
new, renewed or comparable product (whichever
is deemed necessary) in exchange without
charges, subject to verification of the defect or
malfunction and proof
of the date of purchase. Subsequent replacement
products are warranted for the balance of the
original warranty period.
Who is covered? This warranty is extended to the
original retail purchaser for products purchased
from an authorized Jensen dealer and used in the
U.S.A.
What is covered? This warranty covers all defects
in material and workmanship in this product. The
following are not covered: software, installation/
removal costs, damage resulting from accident,
misuse, abuse, neglect, product modification,
improper installation, incorrect line voltage,
unauthorized repair or failure to follow instructions
supplied with the product, or damage occurring
during return shipment of the product. Specific
license conditions and copyright notices for the
software can be found via www.jensenmobile.com.
What to do?
1. Before you call for service, check the
troubleshooting guide in your owner’s manual.
A slight adjustment of any custom controls
may save you a service call.
2. If you require service during the warranty
period, you must carefully pack the product
(preferably in the original package) and ship it
by prepaid transportation with a copy of the
original receipt from the retailer to an
authorized service center.
3. Please describe your problem in writing and
include your name, a return UPS shipping
address (P.O. Box not acceptable), and a
daytime phone number with your shipment.
4. For more information and for the location of
the nearest authorized service center please
contact us by one of the following methods:
• Call us toll-free at 1-888-921-4088
• E-mail us at cs@.dualav.com
Exclusion of Certain Damages: This warranty is
exclusive and in lieu of any and all other
warranties, expressed or implied, including
without limitation the implied warranties of
merchantability and fitness for a particular
purpose and any obligation, liability, right, claim
or remedy in contract or tort, whether or not
arising from the company’s negligence, actual or
imputed. No person or representative is
authorized to assume, for the company, any
other liability in connection with the sale of this
product. In no event shall the company be liable
for indirect, incidental or consequential
damages.
Dual Electronics Corporation Heathrow, FL 32746
Technical Assistance: 888-921-4088
www.jensenmobile.com © 2016 Printed in China
-
1
-
2
-
3
-
4
Jensen POWER760X5D Installation guide
- Category
- Audio amplifiers
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Legacy LA-1999 User manual
-
Quantum Audio Solar QS2150 User manual
-
Crunch PRZA Owner's manual
-
Bazooka ELA1500 User manual
-
Audio Design Signum SX-4120 Owner's manual
-
Voyager POWER400 User manual
-
-
Hifonics TXi15080 User manual
-
-
Maxxsonics Pseries PowerZone User manual