OWNER’S MANUAL
OMĆ2605 195 600
March 1999
Blue Runner Cart (043 965)
WARNING
ELECTRIC SHOCK can kill.
• Do not touch live electrical parts.
• Turn Off welding power source and input disconnect
device.
• Disconnect input plug or power conductors from
deenergized supply BEFORE moving welding
power source.
CYLINDERS can explode if damaged.
• Keep cylinders away from welding and other
electrical circuits.
• Never touch cylinder with welding electrode.
• Always secure cylinder to running gear, wall, or
other stationary support.
FALLING EQUIPMENT can cause injury
and damage, OVERSIZED CYLINDER
can cause tipping.
• Move unit with proper handcart.
• If using a fork lift vehicle, secure unit on a skid.
• Never lift unit with cylinder attached.
• Maximum cylinder weight is 300 lb (135 kg).
802 376 / 802 375
Tools Needed:
Description (Qty)
Part
No.
Item
No.
1 194 459 Handle (1)
2 195 639 Label, Caution (1)
3 188 441 Chain, weldless 2/0 x 31 (1)
4 194 457 Tray, Mtg Feeder (1)
5 108 940 Screw, 1/4-20 x .750 (4)
6 135 390 Axle, running gear .750 dia (1)
7 602 250 Washer, flat .812 ID x 1.469 OD (2)
8 070 799 Wheel, rubolene 10 in dia (2)
9 121 614 Ring, rtng ext .750 shaft (2)
10 194 458 Base, running gear (1)
11 124 115 Nut, 438-14 hex (2)
12 602 215 Washer, lock .443 ID x .787 OD (2)
13 194 486 Caster, swvl 5.00 in, (2)
14 601 926 Screw, 1/4-20 x .62 (4)
15 602 207 Washer, lock .255 ID x .489 OD (4)
16 602 240 Washer, flat .312 ID x .734 OD (4)
17 605 904 Screw, 10-32 x 1.50 (4)
18 152 461 Nut, 250-20 hex (4)
Be sure to provide model when ordering replace-
ment parts.
1
3
4
5
6
7
8
9
13
14
17
18
10
2
11
12
15
16
. Use the holes provided in the running
gear base (item 10) to tie down the weld-
ing power source. The welding power
source must be secured so it cannot fall
off the cart.
. When tightening screws
(items 17) that secure
mounting tray to welding
power source, do not
exceed a torque value of
50 in-lbs.
5/16, 7/16 in
The outside screws must
be removed from each
handle to allow new screws
(items 17) to be installed.
Figure 1. Installing Running Gear/Cylinder Rack
-
1
Miller JK000000 Owner's manual
- Type
- Owner's manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Miller MATIC 300 Owner's manual
-
-
-
-
-
-
-
-
Miller XR GUNS Owner's manual
-
