hardWare iNstallatioN
Before proceeding with the hardware connections, ensure that you have
the items listed above in Package Contents at hand. Also check that the
surface where you intend to place the Wireless 300N Presentation
Gateway is level, stable and capable of supporting the device.
• If you intend to horizontally position and operate the device on a at
surface, adhere the four included footpads to the bottom of the
chassis near each corner (to help prevent scratching a desk, table or
whatever).
• Connect the included Ethernet cable to the LAN port (1).
• If using an external amplier and/or speakers, connect them to the
Audio Out port (2).
• Connect your external video display to either the HDMI or VGA port (3).
NOTE: Only one or the other can be used at a time.
• Attach the two antennas (4) and set them upright (perpendicular to the
chassis). NOTE: This is generally best for optimal performance: Adjust
as needed.
• Plug the included power adapter into an A/C outlet, then connect it to
the 5 V jack (5).
• Press the Power button — (6) below — on the front panel of the
Wireless 300N Presentation Gateway and check that the Power LED
— (7) below — is on. (If there is no indication of power, refer to the
Troubleshooting section in the user manual.)
33
Rear panel
1
5
4
4
3
23