Aiphone GTW-VOA Install Manual

  • Hello! I am an AI chatbot trained to assist you with the Aiphone GTW-VOA Install Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
GTW-VOA
Video Output Adaptor
The GTW-VOA is a video output adaptor for the GT Series, providing a composite video output signal
whenever a video entrance station has called, or is in communication with, a tenant station. When a video
signal is transmitting, the green LED on the adaptor will illuminate (video signal is not displayed 24/7).
-INSTRUCTIONS-
GTW-VOA Instr.
0117
Aiphone Corporation
www.aiphone.com
(800) 692-0200
1. Install the GTW-VOA to the wall or on a din rail (W-DIN11) near the GT-VBC video bus control unit.
2. Connect according to the wiring diagram above (any B1/B2 output from the GT-VBC can be used).
3. Connect video device being used to the BNC connector.
4. Ensure power switch is set to the “ON” position.
Note: The green LED will only illuminate when a video signal is transmitting.
WIRING:
BNC output to monitor/recording device
To tenant trunk line (optional)
Note termination switch setting
Termination Switch
A: If using input only
B: If output is used to tenant stations
Only wiring regarding the GTW-VOA is shown here. Refer to the GT Series Installation Manual for complete installation instructions.
+
-
A1
A2
A1
A2
A1
A2
A1
A2
A1
A2
B2
B1
B2
B1
B2
B1
B2
B1
B2
B1
B2
B1
EXP STD
GT-VBC
Video Entrance
Station
GTW-VOA
B2
B1
B2
B1
IN
OUT
A1
A2
ON OFF
A
B
TERMINATION
POWER
+
-
PS-2420UL
Power Switch must be set to
ON for the GTW-VOA to work.
VIDEO OUT
/