2. Computers & electronics
  3. Computer cables
  4. Signal cables
  5. Allison
  6. -USBT3.0 USB Translator

Allison -USBT3.0 USB Translator User manual

  • Hello, I have reviewed the Quickstart Guide for the USB Translator 3.0. This document provides instructions on installing drivers, connecting the USB cable, and using the diagnostic cable to connect the device to your vehicle. I'm ready to answer your questions about this product.
  • How is the adapter powered?
    Where can I download the adapter drivers?
    What should I do after downloading the drivers?
4*
76
*Ensure that the USB cable is firmly
seated into the adapter’s USB port
5
Close running applications.
Users can download adapter drivers online by visiting www.noregon.com/adapter-drivers and clicking the
“Instructions and Driver Download” button from the “USB Translator 3.0” section of the adapter
driver landing page.
Once the download is complete, launch the installer and follow the prompts.
CONNECT:
Connect the D89 end of the USB cable to the port labeled Computer on the USB Translator 3.0 Adapter.
Plug the other end of the USB cable into the USB port on the PC.
Connect the diagnostic cable to the 26-pin connector on the USB Translator 3.0 Adapter.
Attach the diagnostic cable’s connector to the diagnostic port on the vehicle.
1
2
3
4
5
6
7
INSTALL DRIVERS:
Adapter is powered by the vehicle
and must be connected to operate.
NOTE:
QUICKSTART GUIDE
QSG-USBT3.0-2023-02-072823
3.0
4*
6
allisonstore.noregon.com
To order additional cables or
replacement parts, visit:
/