Kenwood CO606 User manual

CO606
Kenwood
Brand
Kenwood
Model
CO606
Category
Tin openers
Type
User manual

Kenwood CO606 is an electric, tabletop can opener with a built-in knife sharpener and a bottle opener. It can open a variety of domestic can shapes and sizes, including large and wide cans. The self-starting blade pierces the can and commences cutting automatically when the lever is pressed down lightly. Once the can is open, the motor stops automatically, and the lid is retained safely by a magnet. The knife sharpener can be used to sharpen knives without a serrated edge, preferably made of carbon steel. The bottle opener is located at the edge of the worktop.

Kenwood CO606 is an electric, tabletop can opener with a built-in knife sharpener and a bottle opener. It can open a variety of domestic can shapes and sizes, including large and wide cans. The self-starting blade pierces the can and commences cutting automatically when the lever is pressed down lightly. Once the can is open, the motor stops automatically, and the lid is retained safely by a magnet. The knife sharpener can be used to sharpen knives without a serrated edge, preferably made of carbon steel. The bottle opener is located at the edge of the worktop.

When opening tall bottles, the unit should be
used towards the edge of a work top.
1. Position the bottle with the cap under the
front rim of the bottle opener.
2. Push down the bottle to remove the cap
whilst steadying the unit with one hand.
1. With the can opener sideways on, place
the knife into one of the recesses.
2. Press the lever down and gradually draw
it towards yourself. Then place the knife
in the other recess and repeat. Take care
not to allow the knife to cut into the body
of the can opener.
3. Repeat this cycle several times in order
to sharpen the knife satisfactorily.
4. The grinding wheel may jam if too much
pressure is applied on the knife. Lift the
knife slightly to release the wheel.
NOTE: Knives without a serrated edge, preferably carbon steel are
most suitable for sharpening.
1. Disconnect the appliance by switching off
and removing the plug from the power
supply.
2. Lift the lever fully and withdraw the
assembly from the can opener.
3. Wash the lever in hot sudsy water and
dry thoroughly. Dishwashing is not
advised.
4. Replace the lever in the body
5. Wipe over the body with a damp cloth and dry thoroughly.
Cleaning
Using the Knife Sharpener
Using the Bottle Opener
LIMITED
New Lane • Havant • Hants • PO9 2NH
www.kenwood.co.uk 85576/6
CO606 series
If the cord of this appliance is damaged it must, for safety reasons, be
replaced by Kenwood or an authorised Kenwood repairer.
UK
If you need help with:
using your can opener or servicing or repairs (in or out of guarantee)
call Kenwood on 023 9239 2333. Have your model number ready, it is
on the underside of your can opener.
EIRE
Contact local repairer from advertisement in GOLDEN PAGES.
ALL OTHER MARKETS
Contact the dealer from whom you purchased your appliance.
Service
Important – UK only
●The wires in the cord are coloured as follows:
Blue = Neutral, Brown = Live.
●The appliance must be protected by a 3A approved (BS1362) fuse.
Note:
●For non-rewireable plugs the fuse cover MUST be refitted when
replacing the fuse. If the fuse cover is lost then the plug must not be
used until a replacement can be obtained. The correct fuse cover is
identified by colour and a replacement may be obtained from your
Kenwood Authorised Repairer (see Service).
●If a non-rewireable plug is cut off it must be DESTROYED
IMMEDIATELY. An electric shock hazard may arise if an unwanted
non-rewireable pug is inadvertently inserted into a 13A socket outlet.
Your Kenwood Can Opener can be used to open a variety of domestic
can shapes and sizes. In addition the CO606 Series incorporates a
bottle opener and a knife sharpening facility.
When using electrical appliances basic safety precautions should
always be followed, including the following:-
1. Read all instructions.
2. This appliance is not intended for use by young children or infirm
persons without supervision.
3. Do not immerse appliance, cord or plug in water or other liquid.
4. Do not use the appliance if it is damaged.
5. Unplug the appliance from the mains supply
- before cleaning
- immediately after use
6. Do not use the appliance for other than its intended use.
7. This appliance is for domestic use only.
8. Young children should be supervised to ensure that they do not
play with this appliance.
KEEP THESE INSTRUCTIONS
IMPORTANT SAFEGUARDS
Know your Table Top Can Opener
1. Bottle Opener 5. Cutter Blade
2. Drive Wheel 6. Guide Pin
3. Magnet 7. Knife Sharpener
4. Lever 8. Cord Stowage
Key
1. Ensure that the lever is in position with
the magnet housing fully located (Fig. 1
and 2).
2. Plug the appliance into the power
supply.
3. Lift the lever to the open position.
4. Hold the can with the top rim resting
under the metal guide pin and the can
resting on the drive wheel (Fig. 3).
5. Press the lever lightly down to start the
motor. The self-starting blade will then
pierce the can and commence cutting.
6. The can will be held fixed in position
with the magnet resting against the lid.
Large or wide cans may require extra
support from the user.
7. Once the can is open, the motor will
automatically stop, retaining the can and
lid safely in place.
8. To remove, lift the lever whilst holding
the can.
9. With the exception of aluminium cans,
the lid will be retained by the magnet.
10. For tidiness, any unwanted length of
cord can be stowed inside the
appliance.
Using your Table Top Can Opener
Connecting to Power
Before switching on make sure that the voltage of your electricity
supply is the same as that indicated on the underside of your can
opener.
IMPORTANT (UK ONLY): The wires in the mains lead are coloured
in accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
NOTE:
This can opener complies with European Economic Community Radio
Interference Directive 89/336/EEC.
Fig. 1
Fig. 2
Fig. 3
  • Page 1 1
  • Page 2 2

Kenwood CO606 User manual

CO606
Kenwood
Brand
Kenwood
Model
CO606
Category
Tin openers
Type
User manual

Kenwood CO606 is an electric, tabletop can opener with a built-in knife sharpener and a bottle opener. It can open a variety of domestic can shapes and sizes, including large and wide cans. The self-starting blade pierces the can and commences cutting automatically when the lever is pressed down lightly. Once the can is open, the motor stops automatically, and the lid is retained safely by a magnet. The knife sharpener can be used to sharpen knives without a serrated edge, preferably made of carbon steel. The bottle opener is located at the edge of the worktop.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents