iGaging EZ-Depth Digital Drill Press Gauge User manual

Brand
iGaging
Model
EZ-Depth Digital Drill Press Gauge
Type
User manual

iGaging EZ-Depth Digital Drill Press Gauge helps you achieve precise hole drilling. Attached to the drill press collar and frame, it displays the drilled depth, allowing you to accurately measure and adjust your drilling operations. Easily zero the display with the drill bit touching the workpiece and switch between fractional inches, millimeters, and decimal inches for versatile measurements.

iGaging EZ-Depth Digital Drill Press Gauge helps you achieve precise hole drilling. Attached to the drill press collar and frame, it displays the drilled depth, allowing you to accurately measure and adjust your drilling operations. Easily zero the display with the drill bit touching the workpiece and switch between fractional inches, millimeters, and decimal inches for versatile measurements.

EZ-Depth Digital Drill Press Gauge
Operating Instructions
Improve the accuracy
and precision of your hole
drilling operations with the
iGaging EZ-Depth gauge
on your drill press. It is
attached directly to the
collar on the quill and to
the side frame of the drill
press. Zero the display with
the drill bit in contact with
the workpiece, then use the
digital display to measure
the drilled depth.
Display Operation
On/Off/0 Button - Short push
to turn display on or off. Push
and hold for 3 seconds to zero
the display.
INC Button - Push to zero and
enter incremental mode, push
again to toggle between abso-
lute and incremental.
Mode Button - Toggles display
between fractional inch, milli-
meters and decimal inch.
®2021 iGaging Item #35-600-4
Installation Instructions
See Installation guide for alternative methods
Examine Package Contents:
•Display & Scale
•Collar Clamp
• Quill Bracket
• Display Bracket
• Fastener Bag
• Tap & Drill Bit Bag
Step 1 - Attach Quill Bracket
Back out the end of the collar
clamp and insert it through the
slot in the quill bracket. Assemble
the clamp and bracket around the
quill collar as shown in the picture
at right, then tighten the screw to
secure both the bracket and clamp
tightly against the collar.
Step 2 - Locate Tap Locations
Using screws and washers from the
fastener bag, temporarily attach
the display bracket to the display
and the scale to quill bracket, then
mark the display bracket location
on the side of the drill press. Re-
move the display and bracket, then
use the included tap, bit, and guide
to tap holes in the side of the drill
press for mounting the bracket.
Step 3 - Complete Assembly
Mount the display bracket to the
side of the drill press using the
included screws, then reattach the
display and scale to the brackets as
shown in the picture. To prevent the
display screws from bottoming out,
use two washers with each screw.
Range: 0-5” / 0-125mm; Accuracy: 0.001”; Reading: 0.0005” | 0.01 mm | 1/64th inch
Designed in California by iGaging, Made in China
www.iGaging.com, Enjoy Accuracy®
®2021 iGaging
  • Page 1 1
  • Page 2 2

iGaging EZ-Depth Digital Drill Press Gauge User manual

Brand
iGaging
Model
EZ-Depth Digital Drill Press Gauge
Type
User manual

iGaging EZ-Depth Digital Drill Press Gauge helps you achieve precise hole drilling. Attached to the drill press collar and frame, it displays the drilled depth, allowing you to accurately measure and adjust your drilling operations. Easily zero the display with the drill bit touching the workpiece and switch between fractional inches, millimeters, and decimal inches for versatile measurements.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents