2. Fiilex
  3. FLXMXCLR-Z
FLXMXCLR-Z

Fiilex FLXMXCLR-Z User guide

  • I've reviewed the user guide for the Fiilex Matrix Color light. The document outlines crucial safety instructions, details the fixture's parts, and explains how to operate and control the light through manual controls, DMX, RDM, and Ethernet. I'm ready to answer your questions about the device and its features, such as fan speed settings and dimming options.
  • What should I do if the shields or lenses are damaged?
    What should I do if the lamp is damaged?
    What control options are available for the fixture?
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
Handle
Top Latch
Yoke Bolt
Tilt Lock Lever
Yoke
Baby/Junior Pin Receiver
Mount Tightening Knob
Vent Holes
Buttom Latch
Power Supply Unit (PSU)
Fan Intake Vent
Intensity Control Knob
CCT/HUE Knob
GN/SAT Knob
USB Type-A Port (5V/1A Power)
Dual Locking V-Mount
DMX Iutput (XLR-Male 5-pin)
OLED Display
Navigation Pad
ON/OFF Switch
USB Type-C Port (For updating firmware)
LAN Port
DMX Output (XLR-Female 5-pin)
DC Input Port
Parts Diagram
Safety Instructions
• DO NOT look into the light source. Be cautious of the high-intensity beam.
• DO NOT disassemble Matrix Color. This will void the warranty.
• DO NOT install Matrix Color in damp or wet locations.
• DO NOT obstruct the fixture’s air vents.
• Use safety cable (not included) when rigging Matrix Color overhead.
• Only use Fiilex approved power supply and accessories. Failure to do so may damage the fixture.
• Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that their
effectiveness is impaired, for example by cracks or deep scratches.
• The lamp shall be changed if it has become damaged or thermally deformed.
• The luminaire is intended for professional use only.
210125A
User Guide
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
1689 Regatta Blvd. Richmond, CA 94804 | (510) 620-5155 | fiilex@fiilex.com www.fiilex.com
Off The fan is completely off. (Operation time is limited.)
The fan speed varies based on light intensity.
The fan operates at reduced speed.
The fan operates at full speed.
Variable
Silent
Full Speed
Sharp Best for flash and strobe effects.
Best for gradual fades.
Smooth
Settings
Fixture Operation
Mode Selection
Fixture Control
Use Navigation Pad to enter MODES, then navigate
through modes and select the desired mode.
1 Manual / Local :
Use Intensity Control Knob and/or the Navigation Pad
to control the parameters.
For CCT modes and HSI modes, use either CCT/HUE
Knob and GN/SAT Knob or the Navigation Pad .
2
DMX / RDM / Ethernet (ArtNet / sACN) :
Display shows DMX connection status, NO DMX or
DMX OK.
Use Navigation Pad to enter and edit SETTINGS. Navigate to the right to access additional settings.
View current fixture firmware versions and fixture
temperature.
Modify ArtNet and sACN settings of the fixture.
Fan speed options
Dimming options
Info
Ethernet
/