Magnavox MPD8710/37 Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the Magnavox MPD8710/37 Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1 Slide the POWER switch to the OFF position
(charging of the DVD player only possible in the
power-off mode).
2 Connect the supplied power adaptor to the player
and to AC outlet to start charging.
The red CHR indicator turns on. It takes
about 4 hours to fully charge the battery.
When the battery is fully charged, the indicator
turns off.
IR/POWER/CHR
Quick start guide
Magnavox Portable DVD Player MPD8710
Charge
1
Notes:
– It is impossible to charge the battery when the environ-
ment temperature drops below 0°C or exceed 35°C.
When the environment temperature is above 35°C, the
indicator twinkles.
2
Prepare your remote control
1 Open the battery compartment.
2 Insert 1 x lithium 3V battery, type CR2025, with the
correct polarity (+/-) as indicated).
3 Close the battery compartment.
3
Enjoy (Disc operation)
1 Open the lid of the player.
2 Slide the POWER switch to ON to turn on the
DVD player.
The green POWER indicator turns on.
3 Press OPEN to open the disc door.
4 Remove the protective card (if any) and load a disc
with the label side facing up.
5 Close the disc door. Playback will start automatical-
ly. If not, press 2;.
6 To stop playback, press 9. twice.
4
Enjoy (AV OUT)
Connecting additional equipment (TV for
example)
1 Connect the AV OUT socket on the set to the
video and audio sockets on a TV as shown.
2 Switch on the TV and set to the correct video-in
channel.
You can consult the owner's manual of your TV.
(If your TV does not have Audio and Video
inputs, you will need to purchase a RF modula-
tor. Please consult your dealer.)
Guide de
démarrage rapide
1 Réglez l'interrupteur POWER sur OFF (le lecteur
de DVD peut être chargé en mode hors tension
uniquement).
2 Pour démarrer la charge, utilisez le cordon de
l'adaptateur secteur fourni pour brancher le lecteur
sur une prise secteur.
Le voyant de charge rouge est allumé. Une
charge complète de la batterie prend environ 4
heures.
Lorsque la batterie est entièrement chargée, le
voyant de charge rouge s’éteint.
Charge de la batterie
1
Remarque:
– Lors de la charge de la batterie, la température doit
être comprise entre 0 et 35°C.
WesternLorsque la température dépasse 35°C, le voy-
ant clignote.
2
Préparation de la télécommande
1 Ouvrez le compartiment des piles.
2 Insérez 1 pile CR2025 en respectant la polarité
(+/-) indiquée.
3 Refermez le compartiment des piles.
IR/POWER/CHR
3 OPEN HERE
/