Whirlpool P 604 (BK) Owner's manual

Page is loading ...

Piani da incasso elettrici

Istruzioni per l'installazione e l'uso 3

Electric built-in cooking tables

Instructions for installation and use 7

Plans de cuisson à encastrement électrique

Instruction pour l'installation et l'emploi 11

Encimera empotrable eléctricas

Instrucciones para la instalación y uso 15

Placas de encastre eléctricas

Instruções para a instalação e o uso 19

Electrische inbouw-kookvlakken

Gebruiksaanwijzingen voor de plaatsing en gebruik 23

Elektrische Einbau-Kochmulden

Informationen für installation un gebrauch 27

Page is loading ...

7

Important

1 This appliance is intended for non-professional use

within the home.

2 These instructions are only for those countries

whose symbols appear in the booklet and on the

matriculation plate of the appliance.

3 This owner’s manual is for a class 3 built-in hob.

4 Before using your appliance, read the instructions

in this owner’s manual carefully since you will find

all the instruction you require to ensure safe

installation, use and maintenance. Always keep this

owner’s manual close to hand since you may need

to refer to it in the future.

5 When you have removed the packing, check that the

appliance is not damaged. If you have any doubts, do not

use the appliance, contact your nearest Ariston Service

Centre. Never leave the packing components (plastic

bags, foamed polystyrene, nails, etc.) within the reach of

children since they are a source of potential danger.

6 The appliance must be installed only by a qualified person

in compliance with the instructions provided. The

manufacturer declines all responsibility for improper

installation which may harm persons and animals and

damage property.

7 The electrical safety of this appliance can only be

guaranteed if the cooker is correctly and efficiently

earthed, in compliance with regulations on electrical

safety. Always ensure that the earthing is efficient; if you

have any doubts call in a qualified technician to check

the system. The manufacturer declines all responsibility

for damage resulting from a system which has not been

earthed.

8 Before plugging the appliance into the mains, check that

the specifications indicated on the date plate (on the

appliance and/or packaging) correspond to those of the

electrical and gas mains system of your home.

9 Check that the electrical capacity of the system and

sockets will support the maximum power of the hob, as

indicated on the data plate. If you have any doubts, call in

a qualified technician.

10 An omnipolar switch with a contact opening of at least 3

mm or more, is required for the installation.

11 If the socket and hob plug are not compatible, have the

socket replaced with a suitable model by a qualified

technician who should also check that the cross-section

of the socket cable is suited to the power absorbed by

the appliance. The use of adaptors, multiple sockets and/

or extensions, is not recommended. If their use can not

be avoided, remember to use only single or multiple

adapters and extensions which comply with current safety

regulations. In these cases, never exceed the maximum

current capacity indicated on the single adaptor or

extension and the maximum power indicated on the mul-

tiple adapter.

12 Do not leave the appliance plugged in if it is not in use.

Switch off the main switch and gas supply when you are

not using the cooker.

13 The openings and slots used for ventilation and dispersion

of heat on the rear and below the control panel must never

be covered.

14 The user must not replace the supply cable of this

appliance. Always call an after-sales servicing centre

authorised by the manufacturer in the case of cable

damage or replacement.

15 This appliance must be used for the purpose for which it

was expressly designed. Any other use (e.g. heating

rooms) is considered to be improper and consequently

dangerous. The manufacturer declines all responsibility

for damage resulting from improper and irresponsible use.

16 A number of fundamental rules must be followed when

using electrical appliances. The following are of particular

importance:

• do not touch the appliance when your hands or feet

are wet

• do not use the appliance barefooted

• do not use extensions, but if these are necessary

caution must be exercised.

• never pull the power supply cable or the appliance to

unplug the appliance plug from the mains.

• never leave the appliance exposed to atmospheric

agents (rain, sun etc.)

• do not allow children or persons who are not familiar

with the appliance to use it, without supervision.

17 Always unplug the hob from the mains or switch off the

main switch before cleaning or carrying out maintenance

operations.

18 If you are no longer using an appliance of this type,

remember to make it unserviceable by unplugging the

appliance from the mains and cutting the supply cable.

Also make all potentially dangerous parts of the appliance,

safe, above all for children who could play with the

appliance.

19 To avoid accidental spillage do not use cookware with

uneven or deformed bottoms on the burners or on the

electric plates. Turn the handles of pots and pans inwards

to avoid knocking them over accidentally.

20 Never leave hot plates on without cookware because

they quickly heat to maximum and could damage the

appliance or adjacent furniture.

21 Some parts of the appliance, in particular the hot plates,

remain heated for a long time after use. Make sure not to

touch them.

22 Never use flammable liquids such as alcohol or gasoline,

etc. near the appliance when it is in use.

23 When using small electric appliances near the hob, keep

the supply cord away from the hot parts.

24 Make sure the knobs are in the “•”/”¡” position when the

appliance is not in use.

To maintain the EFFICIENCY and SAFETY of this appliance, we recommend:

• call only the Service Centers authorized by the manufacturer

• always use original Spare Parts

8

Installation instructions for built-in stove tops

The following instructions are directed at the qualified

installer so that the installation and maintenance

proceedures may be followed in the most professional and

expert manner possible.

Important: Unplug the electrical connection before

performing any maintenance or regulation upkeep

work.

Installation of built-in stove tops

The electric hobs are prepared with protection degree

against excessive heating of Y type, it is therefore possible

to instal them next to furniture which is higher than the

working board. For a correct installation of the cooking

top the following precautions must be followed:

a) The hoods must be installed according to the

requirements in the hood handbook.

b) The dimensions of the cutout for the appliance must

be those indicated in the figure. Clamps are provided

to fasten the cooktop to counters measuring from 20

to 40 mm in thickness. To fasten the cooktop securely,

it is recommended that all the clamps be used.

555 mm.

55 mm.

475 mm.

Fastening Clamps - Assembly Diagram

20

30

Clamp Position for Clamp Position for

H=20mm top H=30mm top

Front

40

Clamp Position for

H=40mm top Back

N.B: Use the clamps contained in the "accessory kit."

c) In case a wooden panel should be fitted under the top

for insulation, it will have be fitted at a minimum distance

of 20 mm from the inferior part of the top.

Important: When installing the hob on a built-in oven, the

oven should be placed on two wooden strips; in the case

of a joining cabinet surface, remember to leave a space

of at least 45 x 560 mm at the back.

560 mm.

45 mm.

When installing on a built-in oven without forced ventilation,

ensure that there are air inlets and outlets for ventilating

the interior of the cabinet adequately. Assembly examples

are given in figs.

Electric connections

The electric hobs are supplied without power supply cable

since the cable must be sized according to the type of

electrical connection used (see attached connection

diagram). Follow these steps to connect the cable:

• Open the terminal board box by unscrewing the 3

screws and remove the lid.

• Connect the wires as shown in the diagram below.

400 3N

H05RR-F 5x1.5 CEI-UNEL 35363

400V 2N

H05RR-F 4x1.5 CEI-UNEL 35363

230V 1N

H07RN-F 3x2.5 CEI-UNEL 35364

1

2

5

4

3

21

5

4

3

21

N

R

S

N

R

N

3

4

5

T

SR

• Fix the cable with the cable hitch, shut the lid and and

screw down with the 3 screws.

9

543

12

Electrical wire hook-up

Attach to the wire a plug of the type indicated by the tag.

In the case of direct hook-up to electrical source it is

necessary to place between the plug and the source an

omnipolar switch with a minimum distance of 3mm

between the contacts appropriate to the load and in

keeping with the regulations in vigour (the earth wire need

not be interrupted by the switch). The main supply wire

must be placed in such a spot as to not superate 50°C

above room temperature. Before actual hook-up make sure

that:

• The fuse and main breaker of the electrical system

can withstand the load required by the appliance,

• That the electrical supply system is equiped with an

efficient earth hook-up according to the norms and

regulations prescribed by law.

• That the plug or switch are easily accessible.

Important: When the appliance is installed over a built-in

oven, for safety, the electrical connections of the hob and

oven must be installed separately. This also ensures easy

removal of the oven, if necessary.

A Electric plate

B Pilot lamp of the electric plates

C Control knobs for the cook-top electric plates

Cooking table description

C

B

A

10

Technical characteristics

Voltage and supply frequency and power:

230V ~ 1N/400V ~ 3N 50-60 Hz

Max absorption:

7000 W

This appliance conforms with the following European

Economic Community directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent

modifications;

- 89/336/EEC of 03/05/89 (Electromagnetic

Compatibility) and subsequent modifications;

- 93/68/EEC of 22/07/93 and subsequent modifications.

The various functions included in the cooking table are

selected by operating the control devices located on the

control panel.

The cook-top electric plate control knobs

The cooking tables may be equipped with standard and

fast in various combinations (the fast plates are

distinguished from the others by a red dot in the centre).

To avoid heat dispersion and damage to the plates, we

recommend using cooking vessels with flat bottoms in

diameters which are not smaller than the plate diameter.

Table shows the correspondence between the positions

indicated on the knobs and the use for which the plates

are advise.

Setting Normal or Fast Plate

0

Off

1

Cooking vegetables, fish

2

Cooking potatoes (using steam) soups,

chickpeas, beans.

3

Continuing the cooking of large quantities of

food, minestrone

4

For roasting (average)

5

For roasting (above average)

6

For browning and reaching a boil in a short

time.

The pilot lamp (B)

This light turns on when one of the electric plates is on.

Use of the hob

To obtain the best cooking results from your hob there are

a few basic rules to follow.

• Use pans with a level and even base. This ensures full

contact of the base of the pan to the ceramic heat

zones. Use heavy pans with level bases

• Use pans with a large enough diameter to completely

cover the heat zone as this ensures the most efficient

use of the heat.

• Always ensure that the bases of the pans are dry and

clean as this allows good contact and will prolong the

life of your ceramic hob and pans.

The different functions of the hob

Before each operation, disconnect the cooker from

the electricity.

To assure the long life of the cooking table, it must be

frequently cleaned. When doing so, remember that:

• the enamelled parts are washed with warm water

without using any abrasive powders or corrosive

substances which could ruin them;

• the electric plates are cleaned with a damp cloth and

they should be lubricated with a little oil while they still

warm;

Cooker routine maintenance and cleaning

• stainless steel may become marked if it comes into

contact with very hard water or harsh detergents

(containing phosphorous) for long periods of time. After

cleaning, it is advisable to rinse thoroughly and dry. It

is also recommended to dry any water drops;

Page is loading ...

Piani da incasso elettrici

04/00 - 195012917.05 Xerox Business Services - Docutech

Merloni Elettrodomestici

Viale Aristide Merloni 47

60044 Fabriano

Italy

Tel +39 0732 6611

Fax +39 0732 662501

www.merloni.com

Whirlpool P 604 (BK) Owner's manual

This manual is also suitable for

Whirlpool P 604 (BK) Owner's manual

in other languages

Related papers

Other documents