IGNITION
SWITCHED
+12 VOLTS
RED
WHITE
GRAY
GRAY
WHITE
BLUE
GRAY
*NOTE: DRILL 3/16” HOLE FOR LED.
BLUE
GROUND
#8 X 1/2"
TEK SCREW
BROWN
BLACK
PURPLE
ORANGE
BLACK
GREEN
BROWN
BLUE
3 AMP FUSE
BROWN
WHITE
GREEN
USE THE SUPPLIED 2-WAY TAPE. AFFIX TO
THE SHINY SIDE OF THE GPS MODULE TO
MOUNT TO DASH, FRONT WINDSHIELD,
REAR WINDOW, OR DECK.
RECEIVERS MUST BE
INSTALLED HORIZONTALLY.
DO NOT OBSTRUCT UNIT
FACE WITH METAL, CHROME-
PLATED PLASTIC OR
CARBON FIBER.
RECEIVERS MUST BE
INSTALLED HORIZONTALLY.
DO NOT OBSTRUCT UNIT
FACE WITH METAL, CHROME-
PLATED PLASTIC OR
CARBON FIBER.
( FOR OPTIONAL DEFUSER(S) )
(DO NOT TAP INTO FACTORY GROUND WIRE)
(INTERIOR
MOUNTING
ONLY)
(Platinum360 MODEL ONLY)
YELLOW
YELLOW
OPTIX 1-5 TRANSPONDERS
(INTERIOR
MOUNTING
ONLY)
MUTE IN
GREEN
BROWN
BLUE
YELLOW
BROWN
WHITE
GREEN
YELLOW
WHITE
BLACK
ALERT OUTPUT
I/O PORTS
ORANGE
*USE L2 AND/OR L5 FOR CENTER MOUNTED
DEFUSER TRANSPONDER(S) WHEN
CONFIGURING FOR VPR LASER GUNS
*
*
ORANGE WIRE, HEADLIGHT AUTO DIM
CONNECT TO LOW BEAM HEADLIGHT POWER
(+12V) WHEN HEADLIGHTS ARE TURNED ON,
ALERT LEDs AUTO DIM TO “NIGHT” MODE.
WHITE WIRE FOR HARDWIRED MUTE BUTTON
CONNECT THE WHITE MUTE IN WIRE FROM
THE HOST TO AN OPEN PIN ON A NORMALLY
OPEN MOMENTARY PUSH BUTTON SWITCH.
CONNECT THE OTHER OPEN PIN ON THE
SWITCH TO CHASSIS GROUND.
BLACK WIRE, ALERT OUTPUT
USED TO MUTE AN AFTERMARKET RADIO OR
TRIGGER AN ALTERNATE ALERT COMPONENT.
(HOST Pt)
(PTR)
(PTF)
RED WIRE REQUIRES +12 IGNITION
SWITCHED POWER WITH 1 AMP FUSE
IF NOT CONNECTED TO RADAR SYSTEM
+12 IGNITION CONNECTION.
BLOCK WIRING DIAGRAM
Platinum360
Platinum200
K40 DAYTIME TECHNICAL SUPPORT
800-323-6768
24 HR. TECHNICAL SUPPORT
847-209-8268
44916 3/20
IGNITION AND GROUND
1. USE A TEST METER TO LOCATE A
+12v IGNITION SWITCH SOURCE
FOR THE HOST.
2. CONNECT THE BLACK WIRE TO A
SOLID CHASSIS GROUND (K40
RECOMMENDS THE DRIVER’S SIDE
KICK PANEL) USING THE PROVIDED
RING TERMINAL AND SILVER SELF-
TAPPING SCREW.
EXPERT
/
