Century FW300011
The Century FW300011 is a non-catalytic wood heater that meets the US Environmental Protection Agency’s emission limits for wood heaters. Under specific conditions, this heater has been shown to deliver heat at rates ranging from 11,800 to 32,300 BTU per hour.
- Adjustable Heat Output: The Century FW300011 has four different heat settings, allowing you to customize the heat output to your desired level of comfort.
- Large Viewing Window: The large viewing window provides a clear view of the fire, making it easy to monitor the flames and adjust the airflow as needed.
Century FW300011
The Century FW300011 is a non-catalytic wood heater that meets the US Environmental Protection Agency’s emission limits for wood heaters. Under specific conditions, this heater has been shown to deliver heat at rates ranging from 11,800 to 32,300 BTU per hour.
- Adjustable Heat Output: The Century FW300011 has four different heat settings, allowing you to customize the heat output to your desired level of comfort.
- Large Viewing Window: The large viewing window provides a clear view of the fire, making it easy to monitor the flames and adjust the airflow as needed.
HANDLE
Twist spring handle in counter
clockwise motion while pushing on to
handle; spring handle will “thread” down
to desired location.
SPRING
This manual describes the installation and operation of the Model FW300011 non-catalytic wood heater. This
heater meets US Environmental Protection Agency’s emission limits for wood heaters. Under specific
conditions thisheater has been shown to deliver heat at rates ranging from 11,800 to 32,300 BTU per hour.
6” Flue Required
Figure A: Clearance from combustible constructions
Model No. FW300011
This unit has been listed by Warnock
Hersey Limited to meet or exceed ULC
S-627-00 Canada and UL 1482 U.S.
Part No S19995 Rev07
NOTE: Retain this sheet for future reference
A minimum clearance of 18” (457mm) to the chimney connector
may be required by the authority having jurisdiction.
Unit must be placed on a noncombustible floor protection equivalent to 3/8” millboard.
Consult your local building authorities for further information.
Contact your local building inspector
prior to installation.
A permit maybe required in your area.
CAUTION: BRICK FOR ASH DRAWER
MUST BE INSTALLED BEFORE
OPERATION OF WOOD HEATER
OPTIONAL FAN
An optional heat exchange blower is available
for this wood burning appliance. To order please
see the local dealer where you purchased
your appliance.
CAUTION: Do not open fire-door to a point
where it would be in contact with the
combustible sidewall.
3FT(1M) MIN
FROM ROOF
PENETRATION
MINIMUM OVERALL
HEIGHT FROM FLOOR
15FT(5M)
G
2ft(635mm) HIGHER THAN
NEAREST POINT OF
ROOF WITHIN 10ft(3M)
B
E
A
D
8”(203mm)
BACK WALL
SIDE WALL
BACK WALL
C
F
C
F
SIDE WALL
Figure “A”
*16
**18
*16”(406mm) U.S.A.
**18”(457mm) Canada
8”(203mm)
8”(203mm)
Inlet Air Control Settings
Desired Burn Setting Inlet Air Setting Approx. BTU Output
Low Closed Fully 12,000
Med / Low ¼ Open 13,400
Med / High ¾ Open 17,700
High Fully Open 55,100
18
17
16
CAUTION:
CERAMIC BAFFLE IS FRAGILE.
BEFORE REMOVING SECONDARY AIR
TUBES SUPPORT CERAMIC BAFFLE.
1 . M a x i m u m b u r n t i m e s a n d h e a t o u t p u t s a r e b a s e d o n l a b o r a t o r y t e s t i n g u s i n g f u l l l o a d s o f
s e a s o n e d h a r d w o o d s , a n d may var y in in div i dua l use d epen d ing o n ho w the s tov e is op era t ed, t ype a nd mo ist u re
co n ten t s of f uel , and o the r fac t ors . Max i mum b urn t ime s are achie v ed un der d iffer e nt op era t ing c ond i tio n s th a n ar e
ma x imu m hea t out p uts .
2. The s e va l ues a re ba sed o n op e rat i on in bui l din g cod e -co n for m ing h ome s und e r ty p ica l Win t er cl imat e con d iti o ns in
th e nor t hea s ter n U.S . If yo ur ho me is of no nst a nda r d co n stru c tio n (e. g . Un u sua l ly we ll- i nsu l ate d , bu i lt un der g rou n d, or
if y ou li ve in a mo r e te m per a te cl ima t e), t hes e may n ot ap ply. Si nce s o ma n y va r iab l es aff e ct pe rfo r man c e, co nsu l t yo u r
CF M Au t her i zed D eal e r to d ete r mine real i sti c exp e cta t ion s for y our h ome .
3. U nde r spe c ifi c con d iti o ns us ed du r ing E PA emis s ion t est i ng.
Brick Pattern
Disposition Des Briques
Diseño de colocación de los ladrillos
11 11
11
11
12
13
13
13
13
13
13
13
13
13
13 13
14
15
6
19
From Heater From Chimney Connector
Sidewall..........18-1/2” (470 mm) Sidewall................24-1/2” (622 mm)
Backwall...............14” (351 mm) Backwall................17-1/2” (445 mm)
Corner..................11” (279 mm) Corner...................17-1/2” (445 mm)
Ceiling..................57-3/4” (1467 mm)
A D
B E
C F
G
MADE IN/FAB AU/HECHO EN CANADA BY CFM Corporation, 2695 Meadowvale Blrd, Mississauga, ON L5N 8A3 800-668-5323 www.cfmcorp.com
9
1
2
3
4
5
8
7
10
90000161
S31300
ASH DRAWER ASSEMBLY
L’ASSEMBLEE DE TROIR DE CENDRE
ASAMBLEA DE CAJON DE CENIZA
CERAMIC BAFFLE
DÉFLECTEUR DE CÉRAMQUE
17
18
19
SECONDARY AIR TUBE
TUBE D’AIR SECONDARE
TUBO SECONDARIO DEL AIRE
4
90000160
4
1
DESCRIPTION
PARTS LIST
1
DOOR ASSEMBLY
2&3
GLASS AND GASKET
3
1/8” GLASS GASKET x 6’
4
SPRING HANDLE
5
AIR CONTROL SPRING HANDLE
6
5/8” DOOR GASKET x 6’
7
GLASS CLIP
SCREW
9
HINGE PIN
10
PUSH NUT
11
FIREBRICK LT 4-1/2”x4-7/16”x1-1/4”
12
FIREBRICK LT 9”x4-7/16”x1-1/4”
13
14
15
ITEM NO.
QTY
DESCRIPTION
NO.
LISTE DES PIÉCES
PORTE MONTÉE
VITRE DE JOINT D’ÉTANCHEITÉ
JOINT DE LA VITRE 1/8po x 6pi
POIGNÉE À RESSORT
POIGNÉE POUR L’ADMISSION D’AIR
JOINT DE LA PORTE 5/8po x 6pi
FERRURE POUR LA VITRE
VIS
GOUPILLE DE CHARNIÈRE
ÉCROU À RESSORT
BRIQUE 4-1/2pox4-7/16pox1-1/4po
BRIQUE 9pox4-7/16pox1-1/4po
LEYENDA NO.
DESCRIPCIÓN
NO.de PC
LISTA DE PIEZAS
1
UNIDAD DE PUERTO
S31343
1
VIDRIO Y EMPAQUETADURA
S31141
1
EMPAQUETADURA DE 1/8” PARA EL VIDRO x 6’
S15001-6
1
MANGO CON RESORTE
S11007
1
MANGO CON RESORTE PARA EL REGULADOR DEL AIR
S11008
1
EMPAQUETADURA DE 5/8” PARA LA PUERTO x 6’
S15011-6
7
PRESILLA PARA EL VIDRIO
S37034
7
TORNILLO
S11086
2
DEPIENDA ALFILER
S11005
2
UNIDAD DEL DEFLECTOR
S11090
LADRILLO REFRACTARIO 4-1/2”x4-7/16”x1-1/4”
LADRILLO REFRACTARIO 9”x4-7/16”x1-1/4”
15
S16040
1
S16046
QTÉE
CANT.
ART NO.
PART NO.
8
LADRILLO REFRACTARIO 7-3/4”x4-7/16”x1-1/4”
4
S16222
BRIQUE 7-3/4pox4-7/16pox1-1/4po
FIREBRICK LT 7-3/4”x4-7/16”x1-1/4”
16
FIREBRICK LT 9”x2-1/2”x1-1/4”
FIREBRICK FOR ASH DRAWER
BRIQUE 9pox2-1/2pox1-1/4po
BRIQUE POUR LE CENDRIER
LADRILLO REFRACTARIO 9”x2-1/2”x1-1/4”
LADRILLO PARA DEPÓSITO DE CENIZAS
1
S16216
1
S16214
COTTER PIN
GOUPILLE FENDUE
ALFILER DE COTTER
S11421
DEFLECTOR DE CERÁMICA
1
Page is loading ...
-
1
-
2
Century FW300011
The Century FW300011 is a non-catalytic wood heater that meets the US Environmental Protection Agency’s emission limits for wood heaters. Under specific conditions, this heater has been shown to deliver heat at rates ranging from 11,800 to 32,300 BTU per hour.
- Adjustable Heat Output: The Century FW300011 has four different heat settings, allowing you to customize the heat output to your desired level of comfort.
- Large Viewing Window: The large viewing window provides a clear view of the fire, making it easy to monitor the flames and adjust the airflow as needed.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- français: Century FW300011 Manuel utilisateur
- español: Century FW300011 Manual de usuario
Related papers
-
Century FW300006 WOOD STOVE User manual
-
-
-
-
-
Century Hearth S244E WOOD STOVE User manual
-
-
Century Hearth FW270029 User manual
-
-
Century Hearth S241E WOOD STOVE User manual
Other documents
-
DutchWest CDW1000L02 Quick start guide
-
CFM S274E Installation And Operational Manual
-
Pleasant Hearth LWS-127201 Series User manual
-
-
-
-
-
-
-