en Before using for the first time
12
K Before using for the
first time
Before using for the first time
In this section, you will learn how to
commission your appliance. Before you
can use your new appliance, you must
make some settings.
Note: Only use the appliance in
frost-free areas. If the appliance was
transported or stored at temperatures
below 0 °C, you must wait for at least 3
hours before using it.
Installing and connecting the
appliance
1. Remove any protective plastic film.
2. Place the appliance on a level,
water-resistant surface which can
bear the weight.
3. Using the mains plug, connect the
appliance to an earthed socket that
has been correctly installed.
Commissioning the appliance
Setting the language
Notes
■ The language selection appears
automatically when the appliance is
switched on for the first time.
■ You can change the language at any
time. ~ "Menu settings"
on page 22
1. Switch on the appliance with the
on/off button.
The preset language appears in the
display.
2. Use the rotary selector to select the
desired display language.
3. Confirm with the right navigation
button.
The setting has been saved.
Setting the water hardness
It is important to set the water hardness
correctly, so that the appliance indicates
accurately when the descaling
programme should be run. The preset
water hardness is level 4.
You can check the water hardness
using the enclosed test strip or by
asking your local water supplier.
If a water softening system is installed in
the house, please select the "Water
softening system" setting.
1. Briefly immerse the enclosed test
strip in fresh tap water, leave it to
drip off and read off the result after 1
minute.
2. Use the rotary selector to set the
water hardness determined.
3. Confirm with the right navigation
button.
The "Fill bean container" reminder lights
up briefly.
4. Either confirm with the right
navigation button or wait a few
seconds.
Notes
■ When the appliance is used for the
first time after running a service
program, or if it has not been
operated for a long period, the first
beverage will not have the full aroma
and should not be consumed.
■ After commissioning the appliance,
you will achieve a suitably thick and
stable "crema" only after the first few
cups have been dispensed.
■ If the appliance is in use for a long
period of time, water droplets will
form on the ventilation slots. This is
normal.