X4S

VANTRUE X4S Operating instructions

Hello! I have analyzed the provided user manual for the X4S dashcam. This document focuses on guiding you through the firmware update process, including steps for preparing your memory card, updating the main unit, and updating the rear camera firmware. I am ready to assist you with any questions you might have about updating your dashcam.
What should I do first?

How long does the software update take?

What to do after the update?

1.1.Please format the memory card firstly and then unzip the

file into the formatted memory card root directory.

2.Place the memory card in the X4S and connect the rear camera

to the X4S to connect the power supply. After power on, the

machine will have a minute or so to identify the updated

software (the screen may stay on a screen at this point), please

wait patiently.

3.After the software is detected, it will be updated and will

take about 2-3 minutes, please wait patiently.

4.After the software is updated successfully, it will return

to the recording interface and start recording automatically.

5.You can pause the video and go back to the system > system

information to view the recorder version number, as shown in

the figure below

6.Update Rear Camera Firmware Notes, Please Note：

① Please update the V26 version firmware first, and then update

the rear lens firmware.

② After the update is completed, please remove the memory card

and put it in the computer to delete the update software, and

then reboot the dashcam.

③ If you don't delete its' firmware after updating the rear

lens firmware, the dashcam may be repeatedly restarted and the

key may fail.

/

Other documents