2. ARIZE
  3. LED FIXTURE

ARIZE LED FIXTURE User guide

  • Hello! I'm an AI assistant that has reviewed the Arize LED Lighting Systems Cleaning/Maintenance Guide. The document you've provided outlines the proper procedures for inspecting and cleaning your Arize Element, Factor, Integral, Lynk and Life fixtures, including safety precautions and recommended cleaning materials. This guide also highlights that fixtures should not be disassembled. Please ask me any questions you might have about the document or maintaining your fixtures.
  • How often should I inspect the Arize fixtures?
    What should I do if I find physical damage on the fixture?
    What type of cleaner should I use?
    Can I use a high-pressure hose to clean the fixtures?
    Is it necessary to clean the internal parts of the fixture?
LED Lighting Systems
Cleaning/Maintenance Guide
Every six (6) months or more frequently as required by the facilities equipment cleaning schedules, inspect Arize
fixtures for physical damage (including cracks, dents, etc.), failed LEDs, solid connections, lens clouding and dirt and/or
dust accumulation on the fixture. If dirt, dust or debris is present, please follow the below cleaning instructions.
If the fixture is damaged, please contact your reseller to purchase a new one.
Maintenance and Inspection Schedule
Cleaning Instructions and Cautions
For Arize Element, Factor, Integral, Lynk and Life
DO NOT CLEAN INTERNAL SYSTEM
Arize fixtures are not designed to be disassembled and do not require cleaning of internal parts.
For safe operation, and to maximize the longevity of the luminaire; ensure that the light module and driver are clean
and free of dirt, dust, oil, or any other debris by cleaning on a regular basis. Do not apply any kind of film on the lens
or otherwise cover the driver or light engine in any way.
PERIODIC CLEANING
Should the Arize Element, Factor, Integral, Lynk or Life fixture require cleaning, use only non-abrasive, neutral (pH 6-8)
cleaner containing no chlorinated or aromatic hydrocarbons.
1. Make certain power is off attempting any maintenance.
2. Use mild soap/detergent (pH 6-8), or ethyl alcohol (80%).
3. Rinse with cool low pressure water (5-10 psi / 35 – 69 kPa). Do not use a high pressure hose directly on the
fixture or submerge the fixture.
4. Wipe dry with clean soft cloth.
Cleaning/Maintenance Guide
HORT118
CAUTION
RISK OF BURN. Allow fixture to cool before handling.
WARNING
RISK OF ELECTRICAL SHOCK. Turn power OFF before
inspection, installation or removal.
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the
General Electric Company and are used under license. Information and specifications subject to change without
notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 1
(Rev 06/19/23)
HORT118
/