2. Home
  3. Home security & automation
  4. Security camera accessories
  5. InCarTec
  6. 27-241
27-241

InCarTec 27-241 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the InCarTec 27-241 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
27-241 – RETAIN ORIGINAL CAMERA ON FIAT U-CONNECT
27-241 – RETAIN ORIGINAL CAMERA ON FIAT U-CONNECT
Installation Instructions
1. Check the wiring from the vehicle is correct for this adapter. The
original camera should be pinned to pins 31, 32 and 33 on the male
connection from the car, wiring colours may vary. (See image A)
2. Push the terminals of the 27-241 camera retention to the ISO lead or
steering wheel control interface. Connect the yellow lead to pin 21 and
the black to pin 22. (See image B), pin numbers on inside of connector.
3. Connect the ISO lead or steering wheel control interface to the
connection in the vehicle.
4. Connect the yellow RCA plug to the reverse camera input of the after
market radio and connect the reverse wire of the radio to the reverse
output of the ISO lead or steering wheel control interface.
DESIGNED FOR USE WITH OUR STEERING
WHEEL CONTROL INTERFACE 39-FIA-03
Image A Image B
THE TERMINALS CAN ONLY BE INSERTED
ONE WAY. DO NOT FORCE THEM IN
UPSIDE DOWN
CHECK THEY ARE FULLY INSERTED. THEY
SHOULD CLICK INTO PLACE.
Installation Instructions
1. Check the wiring from the vehicle is correct for this adapter. The
original camera should be pinned to pins 31, 32 and 33 on the male
connection from the car, wiring colours may vary. (See image A)
2. Push the terminals of the 27-241 camera retention to the ISO lead or
steering wheel control interface. Connect the yellow lead to pin 21 and
the black to pin 22. (See image B), pin numbers on inside of connector.
3. Connect the ISO lead or steering wheel control interface to the
connection in the vehicle.
4. Connect the yellow RCA plug to the reverse camera input of the after
market radio and connect the reverse wire of the radio to the reverse
output of the ISO lead or steering wheel control interface.
DESIGNED FOR USE WITH OUR STEERING
WHEEL CONTROL INTERFACE 39-FIA-03
Image A Image B
THE TERMINALS CAN ONLY BE INSERTED
ONE WAY. DO NOT FORCE THEM IN
UPSIDE DOWN
CHECK THEY ARE FULLY INSERTED. THEY
SHOULD CLICK INTO PLACE.
/