Step 3
Install Wheels to Wheel Base. Check to
be sure they are Secure.
Step 4
Connect Base and Adjusting Rail to
Wheel Base. Tighten Bolt on Base.
Step 5
Connect 1 Upright to Wheel Base,
Tighten Bolt for 1
st
Upright.
Step 6
With the Help of Another person, Install
Log Splitter on Stand, allowing front Leg
Support frame to sit on base while
attaching last Upright to Wheel Stand.
Tighten Bolt on Second Upright. Install
Bolts & Nuts on Front Support. Confirm
Levelness of Splitter and Tighten Bolt on
Adjustable Rail.
Verify All Bolts & Nuts are Tightened and you
will be ready to operate your Log Splitter on
Stand.
Step 2
Remove Wheels from your Log Splitter.
Save these parts you will need them to
reinstall on Stand Wheel Base.