Antennas Direct EU385CF-1S Installation guide
- Type
- Installation guide
Cable from
UHF antenna
Combiner
To UHF
IN
Cable from
the Combiner
VHF
to the VHF
antenna
IN
Cable from
Combiner to
TV/converter box
From UHF Antenna
To
TV/converter
box
From
VHF Antenna
2) Run a short coaxial cable
labeled UHF IN.
3) Repeat step 2, running a
short coaxial cable from the
VHF Antenna to the
combiner connector
labeled VHF IN.
4) Connect the coaxial cable
from the combiner connector
labeled TO
BOX to the
TV/CONVERTER
“Antenna Input” on the
TV/converter box.
5) Follow the instructions in
your TV owner’s manual to
change the input from “CABLE”
to “ANTENNA”, “AIR”, or
‘BROADCAST”.
6) Point the antennas in the
direction of the TV stations’
broadcast towers and check for
reception by scanning for channels.
Note: To locate your broadcast
towers, go to antennapoint.com or
call your local TV station. You may
need to reposition the antenna to
receive broadcast signals.
Remember to perform a channel
scan at every position you try.
UHF/VHF DIPLEXER
UHF IN VHF INTO TV/CONVERTER BOX
POWER PASS
EU385CF-1Z
UHF/VHF DIPLEXER
UHF IN VHF INTO TV/CONVERTER BOX
POWER PASS
EU385CF-1Z
from the UHF Antenna
to the combiner connector
UHF / VHF ANTENNA COMBINER
Quick Start Assembly/Installation Instructions
Combiner with Mounting Hardware
Coaxial Cable Not Included
Included
-
1
Antennas Direct EU385CF-1S Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
TERK Technologies TERK TV32 User manual
-
RCA ANT2050X User manual
-
-
Zenith TELEVISION RECEIVER Operating instructions
-
Fracarro 283938 Datasheet
-
Dish Network Satellite TV System VIP612 User manual
-
Sony SAT-A55 RM-Y802 User manual
-
Procom 21VU User manual
-
Emerson DTE314 Owner's manual
-