Smeg ksec 61 Owner's manual

Page is loading ...

English

Dear customer,

We congratulate you on your choice. We are

sure that this modern, functional and

practical article, constructed from highest

quality materials, will fully meet your

requirements.

Please read all the sections of this

INSTRUCTION MANUAL before using the

extractor for the first time to be able to obtain

its full performance and to avoid any

breakdowns that could arise from its misuse,

also allowing small problems to be

overcome.

Keep and store this manual. It will always

provide useful information on the extractor

and will help other people to use it.

Safety Instructions

Before using the extractor for the first time,

you must read the following safety

instructions.

* Never pull the cable to unplug the extractor.

* Do not switch on the extractor if the

electricity cable is worn out or has cuts or if

there are signs of deterioration around the

control panel.

* If the extractor stops working or functions

abnormally, unplug it from the mains and

advise the technical service.

* Do not leave gas burning without a pan

above it under the hood.

* Do not allow grease to accumulate in any

part of the extractor, especially in the filter as

this COULD PRODUCE A FIRE RISK

* Do not flambé food under the hood.

* Before installing the extractor consult local

rules and regulations in force with respect to

current standards on air and fumes.

* Before connecting the extractor to the

mains, check that both the voltage and the

frequency conform to what shown on the

characteristics label of the extractor located

inside it.

* The cooker hoods provided with plug must

preserve it accessible. In the opposite way, it

is necessary to install an omnipolar switch

with at least a distance of 3 mm. between

Line (L) and Neutral (N).

* The room must be provided with

appropriate ventilation if the extractor is

going to be used at the same time as other

food processing equipment not using

electrical power.

* We recommend the use of gloves and

caution when cleaning the inside of the

extractor.

* Your extractor is designed for domestic use

and only for expelling and purifying gases

arising from food preparation. Its use for any

other purpose must be at your own

responsibility and may be dangerous.

* You should contact the nearest Qualified

Technical Assistance Service for any repairs

always using original spare parts. Repairs

and modifications carried out by others could

damage the apparatus or cause it to

malfunction, and risking your safety. The

manufacturer cannot be held liable for

inappropriate use of the apparatus.

Description of the appliance (Fig.1)

A Motor controls, three speeds.

B Light switch independent from motor

commands.

C Two lamps for hood lighting.

D Filters located over cooking area,

easily removable for cleaning (2 or 3

according to model).

E Extractable group that allows a greater

gas capture area.

F Possibility of incorporating active

charcoal filters (Fig. 5)

G Motor functionning indicator light.

H-I Anti return tabs to be located in the

outlet mouth, locating their ends in the

holes provided.

4

5

F

I

E

1

2

INOX COLOR

Speed

Vitesse Velocidad

Velocità

Snelheid Absaugleistung

Ñêîðîñòü

Velocidade

Hastighet

First Première

Primera Prima Laag Erste Ïåðâàÿ Primeira Första

Second

Deuxième

Segunda

Seconda

Hoog Zweite Âòîðàÿ Segunda Andra

Third Troisième

Tercera Terza Intensief Dritte Òðåòüÿ Terceira Tredje

Light

Lumière

Luz Luce Licht Beleuchtung Ñâåò Luz Lampa

On Allumé Encendido

Accesa

Schakelaar

aan

Ein Âêëþ÷åí Acesa

På

Off Eteint Apagado

Spenta

Schakelaar

uit

Aus Âûêëþ÷åí

Desligada Av

3

Instructions for use

By pushing buttons shown in the figure 2, you

will be able to control the functions of the

extractor

Two achieve better extraction, we recommend

switching on the extractor a few minutes

before starting to cook (3 - 5 minutes) so that

the air flow is continuous and stable when

extracting the fumes.

Likewise, keep the extractor switched on for a

few minutes when cooking is complete to

allow all fumes and odours to be expelled.

Cleaning and maintenance

Before carrying out any cleaning or

maintenance activities, ensure that the

extractor is disconnected from the mains.

To carry out cleaning and maintenance, follow

the Safety Instructions.

Filter cleaning

To remove the filters from their locations

release the anchoring points. Clean the filter,

either by putting it in the dishwasher (see

notes) or leaving it standing in hot water to

simplify the removal of grease or, if wished, by

means of special sprays (protecting the non

metallic parts). Once clean, leave it to dry.

Notes: cleaning in the dishwasher with

aggressive detergents may darken the surface

of metallic parts, without this affecting its gas

retaining properties.

N.B. The filter must be cleaned at least once a

month depending on how often the extractor is

used. It must be remembered that grease

accumulates in the extractor when cooking,

whether it is switched on or not.

Cleaning of the extractor body

The use of warm (40ºC approx.) soapy water

is recommended. A cloth moistened in this

water is used for cleaning the extractor, paying

special attention to the grids. Afterwards, dry it

using a lint-free cloth.

Note:

* Never use metallic scouring pads or abrasive

products that could damage the surface.

* Do not use scrapers with metallic surfaces

such as knives, scissors etc.

Active charcoal filter

* To install the charcoal filter, disassemble the

lid, introduce the filter in the position provided

and reassemble the lid.

* The carbon filter lasts from three to six

months depending on the particular conditions

of use.

* The activated carbon filter can neither be

washed nor regenerated. Once it is exhausted,

it must be changed.

* To replace the exhausted filter with a new

one, we will make in the same way that in its

assembly, previously extracting the spent filter.

Changing Bulbs

* It is important that the mains are

disconnected, and ensure the bulbs that are to

be replaced are not hot.

* Remove the light lens to expose the

extractable lamps.

* The maximum bulbs power is 40W.

Technical Information (Fig.3)

Dimensions Width = 600//900 mm

Depth = 500 mm

Height = 150 mm

Electrical characteristics:

REFER TO RATING PLATE

I

H

D

A

B

G

C

E

English

Installation

To fix the extractor to the kitchen use

measures shown on fig. 4.

The lower part of the extractor must be

located at a minimum height of 60cm above

the hob for electric cookers and 65cm for gas

cookers. If the instructions of a gas cooker

indicate a greater distance these must be

observed.

When the extractor is working at the same

time as other non-electrical cooking

equipment, the outlet air pressure must not

exceed 4 Pa (4 x 10

-5

bar).

To achieve optimum performance the length

of the outlet hose should not exceed 4

meters, or include more than two 90º angles

(elbows)

Although venting to the outside is

recommended, activated carbon filter may be

used, which allow the gas to be returned to

the kitchen through the outlet pipe.

To evacuate air via the upper part, it is

needed an external evacuation conduit, and

the evacuation lever must be located in the

“E” position (Fig. 5).

The small (anti-return) outlet hose is located,

ensuring that the remaining outlets are duly

plugged.

To allow re-circulation through the active

carbon filter the evacuation lever is located in

the “I” position. Then the activated carbon

filter is introduced in the corresponding

groove.

If something does not work

Before seeking technical assistance carry out

the following checks first:

Om någonting inte fungerar

Innan du kontaktar verkstad gå efter följande

instruktioner:

FEL MÖJLIG ORSAK LÖSNING

Kontakten är inte isatt Sätta i kontakten

Fläkten fungerar inte

Det kommer inte ström i

kontakten

Försäkra dig om att det finns el

Filtret är fullt med fett Rengör filtret eller byt ut det

Tilltäppning i utgångsröret Ta bort tilltäppningen

Fläkten suger inte

upp tillräckligt eller

vibrerar

Fel utgångsrör Kontakta installatören och följ

instruktionerna i denna bruksanvisning

Lamporna är utbrända Byt ut lamporna

Lamporna tänds inte

Lösa lampor Skruva åt lamporna

Den här apparaten är CE märkt i enlighet med direktivet 2002/96/EC i Europa Parlamentet och

RAEE av Europarådet angående avfall från elektriska och elektroniska apparater. Rätt

avfallshantering av denna produkt undviker fara för miljön.

Symbolen på produkten eller dokumenten som medföljer produkten, visar att man inte kan

hantera det som hushållsopor. Det skall föras till återvinningstation för elektriska och

elektroniska apparater. Hantera i enlighet med miljölagarna.

För mer information kontakta din kommuns återvinningstation.

SMEG. förbehåller sig rätten att göra ändringar för att förbättra sina produkter om de anser det

nödvändigt utan att detta försämrar produkten.

Svenska

Byta ut lampor

* Ta bort filterna så att man ser lamporna.

* Vidta försiktighetsåtgärder för att ta av

fläkten och se till att lamporna inte är varma.

* Den maximala strömstyrkan på lamporna

Är 40W.

Teknisk information (Fig.3)

Dimensioner:

Breddstorlek = 600//900mm

Djup = 500 mm

Hög = 150 mm

Elkännetecken:

SE KÄNNETECKENSETIKETTEN

Installation

För att fixera fläkten i möbeln, använd modell

på figur 4.

Nedre delen på fläkten ska placeras minsk

65 cm ovanför spisen om det är gas och 60

cm om det är elspis. Om gasspisens

instruktioner säger att det ska vara högre

måste man ha det i åtanke.

När man sätter på köksfläkten samtidigt som

av annan än elenergi försedda apparater så

bör inte luftströmmen vara starkare än 4Pa

(4 x 10

–5

bar).

För att uppnå bästa prestation, ska

uttömnings-röret inte vara längre än 4 meter

och Inte ha mer än två vinklar på 90º.

Även om vi rekommenderar att oset ska

föras utomhus går det även att installera

aktiva kolfilter som tillåter oset föras tillbaka

till köket via utgångsröret.

För att oset ska föras ut via den övre delen

måste man ha ett utlopp utomhus och

placera tömningsspaken i läget “E” (Fig. 5).

Placera utgångsrörmuffen (ej återgång) och

se till att resterande utgångar är täppta.

För återströmmen genom det aktiva kolfiltret

placera tömningsspaken i läge “I”. Därefter

introducera det aktiva kolfiltret i motsvarande

ränna.

Special U.K. Requirements

Height above gas hob: 75 mm minimum.

NEVER PLACE THE COOKER HOOD

OVER AN EYE-LEVEL GRILL.

This appliance must be connected by a

competent person, using fixed wiring via a

DOUBLE POLE SWITCHED FUSED SPUR

OUTLET.

Electrical connection

We recommend that the appliance is

connected by a qualified electrician, who is a

member of the N.I.C.E.I.C. and who will

comply with the I.E.E. and local regulations.

Should the colour of the wires in the mains

lead for the appliance not correspond with

the coloured markings identifying the

terminal in your spur box proced as follow:

* The wire which is coloured blur must be

connected to the marked N (Neutral) or

coloured Black.

* The wire which is coloured brown must be

connected to the marked L (Live) or

couloured Red

* Where avialable (see installation), the wire

which is coloured yellow/green must be

connected to the market  or coloured

Yellow/Green.

If the cooker hood is installed for use above

a gas appliance then the provision of

ventilation must be in accordance with the

Gas Safety (Installation & Use) Regulations

1984 and the relevant Building Regulations.

Detailed recommendations are contained in

the following British Standard Codes of

Practice BS6172, BS5440 and BS6891

Current Edition.

This apparatus has the marked CEE in

conformity with Standard 2002/92/EC of the

European Parliament and the Council about

remainers of electrical en electronic

apparatuses. The correct elimination of this

product avoids negative consequences for

the market and the health.

Symbol (In the product or in the

documents that are included with it),

indicates that it’s not possible to be treated

like domestic remainder. It’s necessary to

give it in a collection point to recycle

electrical and electronic apparatuses. Get rid

of it in accordance with the environmental

norms for remainders elimination.

In order to obtain detailed information about

the treatment, recovery or recycling of this

product, put yourself in contact with the city

council, with the elimination service of urban

remainder or with the store where you

acquired the product.

SMEG reserves the right to make corrections in its appliances wherever it considers these

necessary or useful, without harming their essential features.

Page is loading ...

Smeg ksec 61 Owner's manual

This manual is also suitable for

Smeg ksec 61 Owner's manual

in other languages

Related papers

Other documents