AMG AMG2006-DR Instruction Sheet

Type
Instruction Sheet
AMG Systems Ltd. reserves the right to make changes to this document without
notice. The information herein is believed to be accurate. No responsibility
however is assumed by AMG for its use.
Page 1 of 3 D03023-02
AMG2006-DR
Instruction Sheet
AMG2006-DR 19” Rack Mount Subrack
Front View
Rear View
The AMG2006-DR Subrack is a dual power feed standard 19" rack-mount subrack. It is designed to
house AMG 2000, 2700, 2900 series video transmission equipment.
It takes two 15 volt, 7Amp, DC power feeds both connected to the rear power distribution panel to
power the plug-in units via isolation diodes. Front panel LEDs indicates the presence of power on
each input power feed. There are also two contact changes over relays controlled by the presence of
each power feed in order to provide alarm information regarding failure of one or both of the power
feeds.
Operation of the equipment plugged into the subrack is maintained following failure or loss of either of
the power feeds.
AMG 2006-DR
POWER INPUT A
POWER INPUT B
AMG Systems Ltd. reserves the right to make changes to this document without
notice. The information herein is believed to be accurate. No responsibility
however is assumed by AMG for its use.
Page 2 of 3 D03023-02
Connections
Rear Panel Schematic
Power Connection
Power supply input ..............................2 off @ +14.5 to +16.0 Volt 8 amps.
Connector............................................2off 2 way removable screw terminal 5.08mm pitch screw
flange connector (Phoenix Pt. No. MSTBV 2, 5/2-GF-5.08)
Connections.........................................see schematic
Alarm Connection
Connector............................................2 off way removable screw terminal connector (Weidmuller 3
way Plug Pt. No. BL 3.5/3, 10A, 3.5mm)
Connections.........................................see schematic
(Note: normally closed and normally open refer to the state when not powered)
15V Input
power feed ‘A’ 15V Input
power feed ‘B’
‘B’ power
feed fuse
‘A’ power
feed fuse
‘A’ power feed
alarm
output
‘B’ power feed
alarm output
+ 15 V 0 V
NC
normally closed C
common
NO
normally open
AMG Systems Ltd. reserves the right to make changes to this document without
notice. The information herein is believed to be accurate. No responsibility
however is assumed by AMG for its use.
Page 3 of 3 D03023-02
Fuses
Type.....................................................8Amp Antisurge (T) 20 x 5mm.
Indicators
Power...................................................2off
Green power present in input power feed
Off no power present on input power feed
Physical Information
Dimensions
Height ..................................................3U Plug-in
Width....................................................19” with rack mount ears
Depth ...................................................290mm
Weight..................................................1600grams
Mounting Details
The unit is designed to be mounted within a standard 19” rack. Care should be taken with regard to air
circulation when populated, taking into account the total heat dissipation of the equipment installed. An
air circulation gap above and below the subrack is recommended when populated to full power
capacity.
Safety
The 2006-DR should only be fed from low voltage supplies. Only AMG equipment should be plugged
into the subrack.
Maintenance and Repair
There are no user serviceable parts within the AMG2006-DR products.
In case of problem or failure contact your local support centre or AMG Systems Ltd, Technical Support
Department on tel. +44 (0) 1767 600777.
  • Page 1 1
  • Page 2 2
  • Page 3 3

AMG AMG2006-DR Instruction Sheet

Type
Instruction Sheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI